toughness 中文意思是什麼

toughness 解釋
百慕達奶油花強韌
  1. Tumble abrasion of a fabric is highly dependent on the inherent fiber toughness.

    織物耐滾磨的能力與纖維固有韌度相關密切。
  2. At 100 to 150, both the toughness and the molecular weight decreased during the process of amination, but the transformation ratio of the amination reaction increased rapidly ; above 150, both the toughness and the molecular weight increased and transformation ratio of the amination slightly increased, and reached completely amination

    亞胺化過程中，當溫度從100升至150時，不同熱處理階段薄膜的韌性和分子量均下降，亞胺化反應轉化率上升較快； 150后，其韌性和分子量均升高，亞胺化反應轉化率上升趨于緩慢，最終達到完全亞胺化。
  3. Standard test method for toughness and tenacity of bitumen

    瀝青粘韌性試驗法
  4. A study on the low temperature toughness of high cellulosic electrodes

    高纖維素型焊條低溫韌性研究
  5. Relation between the microscopic fracture pro cess of carbon epoxy composite laminates and their fracture toughness

    環氧樹脂復合層板脫層破斷的微觀過程與斷裂韌性的關系
  6. Based on the analyses on mechanical properties, microstructure and fracture of - the microalloyed steels socrv with various heat treatment technique, it can be affirmed that various fractures arttribute to various mechanism, we can draw conclusion that the strength and toughness of microalloyed steels 50crv will be increase simultaneously by optimal heat treatment technique. to illustrate the mechanism of the strength and toughness of microalloyed steels socrv, we designed the comparative experiment and observed the microstructure of the sample which occurred at different quench and tempering temperature and different tempering time. the last experiment results were determined by the four factors : fined microalloyed elements grains, the decompound of martensite, martensite transformation of remnant austenite and the second phase precipitation

    為解釋微合金化50crv鋼強韌化機理，本文通過對不同淬火溫度，回火溫度，回火時間下的力學性能指標的對比及顯微分析，認為微合金元素的細化晶粒，馬氏體的回火分解，殘余奧氏體的轉變，第二相的沉澱析出共同決定了微合金鋼的強韌化情況，特別是由於微合金元素的存在，其細化晶粒及其碳氮化物的沉澱析出，導致鋼的良好的強韌性，並且如果工藝滿足第二相的沉澱析出強化大於回火馬氏體分解引起的軟化效應，會在硬度曲線中產生明顯的二次硬化現象。
  7. Effect of skipping over deepfreezing on fracture toughness of a100 steel

    100鋼斷裂韌性的影響
  8. The accepted designation for the plane-strain fracture toughness under these environments is this.

    在這些環境下平面應變斷裂韌性所採用的符號是這個。
  9. Trial - manufacture of grade x80 with high toughness acicular ferrite

    80級管線鋼的試制
  10. From shoulder to shoulder he measured several ells and his rocklike mountainous knees were covered, as was likewise the rest of his body wherever visible, with a strong growth of tawny prickly hair in hue and toughness similar to the mountain gorse ulex europeus

    兩肩之間寬達數埃爾46 。他那如磐石若山嶽的雙膝，就像身上其他裸露著的部分一樣，全結結實實地長滿了黃褐色扎扎乎乎的毛。
  11. It showed that 73 % increasing of toughness in modified composites was achieved without the reduction of other mechanical properties. sem has showed the periodically interleaved system where the co - continuously connected granular structure occurs layer by layer between each ply and the interlayer was relatively very thin

    電鏡分析表明離位改性的碳纖維單向布周期性增強體系，在每兩層增強體之間都有很薄一層規整的球性兩相結構，正是這個獨特的多層結構使其抗沖擊性能大幅提高，而且不會對其他重要的力學性能產生不利影響。
  12. He had developed his unusual toughness by working out daily at a gymnasium.

    他每天在體操房裡頑強地苦練，終于練得非常強健堅韌。
  13. Nephrite toughness is very great ; this characteristic is that other malachite is inexistent

    軟玉韌性很大，這一特點是其它玉石所沒有的。
  14. Test method for jic, a measure of fracture toughness

    Jic -破裂韌性的試驗方法
  15. Metallic materials - standard test method for jic, a measure of ductile fracture toughness

    金屬材料延性斷裂韌度jic試驗方法
  16. Method of elastic - plastic fracture toughness jic testing for metallic materials in liquid helium

    液氦中金屬材料的彈塑性斷裂韌度的jic測試方法
  17. The methods - three dimension fabric - enforced laminates, and sparse fabric - enforced laminates, layer - enforced laminates ? to enhance the interlaminar toughness of fabric - reinforced laminates were discussed in this paper. the stitching method to enhance interlaminar toughness of stitched - laminates was mainly discussed in this paper based on our research and experiment. the middle - alkali glass fabric used as enforced - material with thickness of 0. 2mm, 3 section 600 deniner kevlar yarn is used as stitching thread in this research, which improved lock stitching way and different kinds of stitching mode were adopted

    以提高層合板復合材料的層間斷裂韌性（能量釋放率）為目標，採用中堿玻璃布為增強材料，對疊層后的玻璃布，採用凱芙拉縫合線、改進的鎖型縫合方法、不同的縫合工藝進行了縫合；基體採用的是不飽和樹脂，固化劑為過氧化甲乙酮，促進劑為環烷酸鈷液；在室溫下採用真空輔助rtm （ resigntransfermolding ）成型固化方法，製作了不同縫合工藝的玻璃布增強復合材料層合板。
  18. He liked their toughness and their loyalty.

    他喜歡他們的堅韌不拔和忠貞不二。
  19. Metals are elements that can be defined by their properties, such as ductility, toughness, malleability, electral and heat conductivity, and thermal expansion

    金屬是根據可鍛性，剛性，可塑性，電熱導通性以及熱膨脹度等特徵來定義的多種元素的復合物。
  20. In the same time, according to the fracture test results, the influence mechanism of aggregate size on fracture toughness of adherence of new and old concrete is discussed and analyzed, which is verified by manse of the fractal theory

    同時根據新老混凝土粘結斷裂試驗結果，分析了粗骨料最大粒徑對新老混凝土粘結斷裂韌度的影響機理，並用分形理論對影響機理進行了驗證。
分享友人
分享到 Line

分享到臉書