transient wave test 中文意思是什麼
transient wave test
解釋
瞬態試驗-
It can cancel the harmonic phenomena along cross directions and deduce the cost of computation. in chapter four using the impulse characteristics of inciding wave, we test the energy peaks in the transient impulse response of radar targets
本文第四章用能量峰概念和微分參數估計的方法，在時域研究了目標脈沖響應的特性，該方法可以分解出目標上不同散射中心的散射波。 -
The hardware circuit design include : industrial control computer configuration, selection of industrial control board type, design of the power supply and monitoring interface circuit, design of signal processing interface circuit ( the constant current source circuit, the time base signal processing circuit, the processing circuit for the signal to be measured ), design of panel control circuit, design of the system self - checking circuit, and etc. the program flow hart include : main program flow chart, system boot - strap self - checking program flow chart, manual static testing program flow chart, semiautomatic static testing program flow chart, automatic static testing program flow chart, dynamic testing program flow chart, transient testing program flow chart, source voltage and current monitor program flow chart, investigate function testing program flow chart, and etc. the measure system offers six working power supplies, the signal of time base, the signal of constant current source, sine wave signal and step to leap signal, and measures the frequency of the output pulse signal of the wide range pulse convert circuit accurately under three kinds of different test state ( static form, dynamic form and transient form )
硬體電路設計包括：工控機配置、工控板卡選型、產品電源及監控介面電路設計、信號處理介面電路（恆流源電路、時基信號處理電路、被測信號處理電路）設計、面板控制電路設計、系統自檢電路設計等。程序流程圖包括：主程序流程圖、系統開機自檢程序流程圖、手動靜態測試程序流程圖、半自動靜態測試程序流程圖、自動靜態測試程序流程圖、動態測試程序流程圖、暫態測試程序流程圖、電源電壓和電流監控程序流程圖、研究功能測試程序流程圖等。測試系統提供六路工作電源、時基信號、恆流源信號、正弦波信號和階躍信號，並對三種不同測試狀態（靜態、動態、暫態）下大量程脈沖變換電路輸出脈沖信號的頻率進行精確測量。 -
Simulative analysis and experimental test of the transmission characteristics of transient traveling - wave in transformer
互感器暫態行波傳輸特性模擬分析與實驗測試 -
Contrast to such original place test method as static load method and drilling method, the method that applying transient rayleigh surface wave to inspect the compound foundation own many virtues as low cost, high efficiency, non - destruction, and it also can save much labour and effort. furthermore, it can implement the large - wide and comprehensive inspection and evaluation of compound foundation bearing capacity
與靜載試驗、鉆孔法等原位測試方法相比，瞬態瑞雷波檢測復合地基技術具有成本顯著降低、效率高、無破損等特點，可節省大量的人力物力，從而可以實現復合地基承載力大范圍、全面的檢測和評價，打破以往只能局部抽檢的局面。 -
Since that the choosing line hardware for the neutral ungrounded system has just passed part of the dynamic simulative test, matlab software was chosen to do a lot of simulative tests on single phase - to - grounding fault. and the simulative sampling ratio is almost the same as the hardware ' s. because there is a low wave filter in the hardware, i choose the db15 wave - let to carry out the multidimensional decomposition on the sample by the method of one dimension discrete wavelet in order to obtain low frequency signal including the high frequency transient information on single phase - to - grounding fault
鑒于實驗室已有的小電流接地系統選線硬體的研製只通過了實驗室里的動模試驗，故選用matlab軟體對小電流接地系統進行大量的單相接地故障模擬試驗，模擬的采樣率和硬體基本一致，由於硬體中帶有低通濾波器，故在進行采樣數據的morlet小波分析時先採用db15小波對采樣進行一維離散小波的多尺度分解，使得分解得到的低頻信號剛好包括了小電流接地系統單相接地故障時的暫態高頻信息，然後對這一信息再繼續進行小波演算法分析，分析結論表明利用變換后的實部、虛部和模值能夠較準確的實現單相接地故障時的故障選線和暫態高頻分量的提取。
分享友人