transmitted wave 中文意思是什麼

transmitted wave 解釋
被射波
  • transmitted : 透射的
  • wave : n 〈美海軍〉女志願軍人〈見 WAVES 條〉。n 1 波浪；碎浪； 〈the wave（s）〉 〈詩〉海。2 波動；波狀...
  1. Refer to the impacting - echo technology, we impacted the apex of the steel bar and incepted the reflecting stress ave through the resonator that fixed on the apex of the steel bar, and the value of the consolidating wave speed was calculated based on the time of stress wave transmitted and the length of the steel bar, so, identifying the reflecting signal is the key of the consolidating wave speed method

    借鑒于沖擊回波技術，固結波速的測定方法是在鋼筋測桿的出露端施加瞬態沖擊載荷，由安設在測桿頂端的傳感器接收反射應力波信號，根據應力波的走時和測桿的長度折算固結波速的大小，因此反射信號的識別是固結波速法檢測混凝土強度的技術關鍵。
  2. A optimized design of the bend is made using the high frequency simulation software. 5. the coupler and the bend cause a phase change in the wave transmitted past the coupler in the sinuous feed and also a phase change in the coupled po ~ ver

    分析計算了耦合器、波導彎頭引入相位誤差對天線性能的影響，在此基礎上，採用對各個耦合器之間波導長度調節的方法，對陣面相位分佈進行補償。
  3. In the thermal separator, the energy is transmitted through the movement of the shock wave. so that, it is of great importance to study the formation, action and controlling of the shock wave for discovering of the mechanism and ameliorating of the running nature of the thermal separator

    熱分離機內氣體間能量的傳輸與轉換主要通過激波的運動來實現的，因此深入研究激波的形成、運動、行為及控制方法對于揭示熱分離機的製冷機理和提高其性能有重要意義。
  4. According to the test conditions, the double polarity inputting mode is adopted in the circuit of voltage - frequency converting part ; storage batteries are used in the optical emission part of optical fibre isolating and transmitting device, that can guarantee isolation between the main circuit and the testing system ; the 89c51 singlechip is used in the singlechip testing - controlling unit, the peripheral circuits are extended, data are transmitted through the serial port in this part ; the p opular software delphi5. 0 is used in the pc part, the communication between singlechip and pc by serial port, plotting of current wave, regulation of data ; the optical - electrical isolating and triggering are used in the controlling part, this can guarantee the veracity and reliability of breakers triggered, this triggering mode is also used in the triggering of the main closing breaker, the tested breaker and the assistant breaker, the triggering signals are sent out by a singlechip

    壓頻轉換部分電路中根據實際情況採用了雙極性輸入方式；光纖隔離傳輸裝置的光發射部分電源採用了蓄電池供電，確保了主迴路與測試迴路的完全隔離；單片機測控部分採用了89c51單片機，擴充了外圍電路，通過串口向pc機傳送數據； pc機與單片機之間的串口通訊、波形繪制、數據管理等都採用了軟體delphi5 . 0編寫。該測試系統中預留了輸出口，可以對合成迴路中的主合閘開關、被試開關、輔助開關進行觸發，信號由單片機發出，控制部分採用了光電耦合隔離觸發的方法。軟體設計主要集中在對電流信號的數據採集、數據處理、數據傳送、人機界面、波形繪制和數據管理，軟體部分又可分為單片機和pc機程序設計兩大部分。
  5. In the transmitted wave, along with the extinction coefficient increment, the width of photonic bandgap is a gradual extension, the edge of photonic bandgap is a gradual faintness, when the extinction coefficient increases to 0. 02, there is already no obvious photonic bandgap

    在透射波中，隨著消光系數的增加，禁帶寬度逐漸擴大，禁帶邊緣逐漸模糊，當消光系數增加到0 . 02時，已經不存在明顯的能帶。
  6. In those experiments wave shapers have been utilized to modify the incident wave so that the condition of constant strain rate is satisfied more sufficiently. the effect of outer factors on the stress equilibrium of early stage in the specimen was analyzed, and the methods to improve the uniformity of stress in specimen at early stage were given. the elastic wave velocity of specimens can be determined by the wave shape fitting of the predicted transmitted wave with the measured transmitted wave at the early stage, furthermore, the shifting - time in shpb data processing can be determined

    在shpb實驗中採用波形整形技術使入射波的上升沿變寬；分析了影響shpb實驗中試件早期應力平衡的外部因素，給出了改善早期應力均勻性的方法；採用透射波的早期預估波形與實測波形作對比的方法確定了shpb實驗數據處理中的延遲時間；因而在實驗中得到了比較準確的應力應變曲線。
  7. It is found that : ( 1 ) for linear slope, redistribution of incoming energy flux in modenumber space depends on both the modenumber of incident waves and the ratio of the slope of incident wave ray to slope of topography ; both the transmitted and reflected energy flux ( only for supercritical linear slope ) focus near one or two modenumbers ; for supercritical linear slope, the energy flux scattering to higher modenumbers becomes larger and the energy flux to lower modenumbers becomes smaller as the slope of incident wave ray comes near to slope of topography ; ( 2 ) for convex slope, energy flux is redistributed in wide - range modenumbers and also show peaks on lower - modenubers and higher - modenumbers ; ( 3 ) for concave slope, energy flux is also redistributed in wide - range modenumbers, but does not show peaks on higher - modenumbers as supercritical linear slope and convex slope do ; ( 4 ) the total energy flux scattering to higher modenumbers is approximately equal to the total energy flux to lower modenumbers for internal waves propagating over both convex slope and concave slope, which means the concave slope is the same efficient to convex slope in scattering energy flux to higher modenumbers ; ( 5 ) for convex slope, the wave ray reflected from near - critical topography can extend to deep ocean and shallow shelf, while for concave slope, the wave ray reflected from near - critical topography can only extend to limited distance, then meet the topography and be reflected again ; generally the shear of the internal waves reflected twice from concave slope is not enhanced while the enhanced shear does also appear before second reflection takes place, the enhanced shear can bring about intense mixing, so internal waves reflected from concave slope can also produce marked mixing near critical slope

    3 、內波在凹地形上傳播時，能通量在模態上的分佈范圍也比較寬，但與凸地形和超臨界線性斜坡地形相比，能通量在高模態上的分佈沒有明顯的峰值。 4 、從總的能通量來講，內波在凸地形和凹地形上傳播時，向高模態散射的能通量與向低模態散射的能通若十地形下內波傳播及內潮生成問題的理論解量近似相等，這意味著二者在向高模態散射能通量方面具有同等效率。 5 、凸地形上臨界點附近的反射，反射波的波射線能夠延伸到深海和陸架，凹地形上臨界點附近的反射，反射波的波射線很快遇到地形發生二次反射，一般來講二次反射后回到深海的波動其速度剪切並不很強，但是在進行二次反射之前的區域，速度剪切仍然很強，因而內波在凹地形上的反射依然能夠在地形附近區域，產生強的速度剪切區，誘發混合。
  8. In communications, a continuous frequency voltage or electromagnetic wave capable of being modulated or impressed with a second signal which carries the information to is transmitted

    通信技術中一種連續的電壓或電磁波，可用另一個攜帶有傳送信息的信號調制或疊加。
  9. The traditional wave control signal is been transmitted though cable which has many limitations, such as serious interference between cables, low reliability, short transmission distance, big volume and complicated routing

    傳統的波控信號採用電纜傳輸，存在電纜間相互干擾嚴重、可靠性低、傳輸距離短、體積大、布線復雜等諸多缺陷，不能滿足新的系統性能要求。
分享友人
分享到 Line

分享到臉書