turbine analysis 中文意思是什麼

turbine analysis 解釋
汽輪機分析
  • turbine : n 【機械工程】（渦）輪機，葉輪機，汽輪機，透平機。 a hydraulic [water] turbine 水輪機。 a steam t...
  • analysis : n. （pl. -ses ）1. 分解，分析；【數學】解析。2. 梗概，要略。3. 〈美國〉用精神分析法治療（＝ psychoanalysis）。
  1. Fracture analysis for rotor turbine blade in aero - engine

    某發動機渦輪轉子葉片斷裂原因分析
  2. Vibration analysis of mistuned bladed disc of steam turbine

    輪盤系統耦合振動分析
  3. Analysis and treatment on cavitation damage in liner of turbine draft tube

    水輪機尾水管里襯汽蝕破壞分析處理
  4. The system optimization and heat economic analysis for feed pump steam turbine

    機組給水泵小汽輪機系統的改造及其熱經濟性比較
  5. The exergy analysis of the power turbine for gt

    航改型艦用燃氣輪機的火用分析
  6. Analysis on the magnetic pole fault of the feilaixia bulb type turbine generator

    飛來峽貫流式水輪發電機磁極故障的分析
  7. On magnetic pole faulty analysis of turbine - generator of feilaixia hydropower station

    飛來峽水電廠水輪發電機磁極故障分析
  8. Cold spin testing characteristic analysis of impeller used in minitype turbine

    小型增壓器葉輪超試特性分析
  9. Hydro - turbine governing system is a nonlinear and time mutative system that is usually conducted following analysis and calculations : calculation of regulation guarantee under transiting process of acute fluctuation ; dynamic analysis under small fluctuation

    水輪機調節系統是非線性和時變性的系統，其分析計算分為:大波動過渡過程下的調節保證計算;小波動情況下的動態分析。
  10. This paper carries on the 3d finite element structure analysis for power house monolith with a bulb turbine hydropower station located in the upstream of huang river as the carrier

    摘要以黃河上游擬建的某燈泡貫流式水電站為載體，對廠房壩段整體進行了三維有限元結構分析。
  11. 2. recuperative gas turbine cogeneration with water injection and its thermodynamic analysis recuperative gas turbine cogeneration can reduce exhaust temperature, make use of waste heat and increase efficiency

    二、功熱並供回熱注水燃氣輪機及其熱力分析採取回熱和功熱並供可以減小熱機循環的當量排氣溫度或有效利用余熱。
  12. Fracture failure analysis of the third class turbine vanes in some engine

    級渦輪葉片斷裂失效分析
  13. Analysis of the economy on the water feeding pump steam turbine under variable working conditions

    變工況下給水泵汽輪機經濟性分析研究
  14. According to the question of using natural cooling will prolong the period of opening cylinder for overhaul, we expound three modes for the steam turbine quickly cooled after being stopped, these are vacuum and aeration - cooling, pressure - air cooling and steam 1ing, then analysis and contrast them

    摘要針對汽輪機採用自然冷卻方式會延長機組檢修開缸時間的問題，提出了汽輪機停機后的三種快速冷卻方式：抽真空通汽冷卻法、壓縮空氣強迫冷卻法和蒸汽冷卻法，並對這三種方式進行了比較和分析。
  15. Presents the model proposed for analyzing the vibration characteristics of shrouded blades and their calculation method by employing a wave propagation theory and modal synthesis technology coupled with a finite element method from the view point it is possible not only to conduct frequency modulation of the shrouded blades of a gas turbine, but also to utilize the friction effects between them to dissipate energy, thereby attaining the aim of vibration alleviation, as shrouded blades have been widely used in the design of high - speed turbomachinery, such as modern gas turbines and steam turbines, and with the shrouded blades forming an integral whole in a centrifugal force field, the vibration characteristics of the whole ring of blades are different from those of a single isolated blade, and this makes it essential to take into account the integral effect of blade shrouds, concludes from the calculation examples and engineering application that the above approach is valid and correct along with the possibility of considerably reducing the scale of calculation and analysis, and points out it is necessary to take into consideration the coupled effect of the whole ring of blades while the dynamic characteristics of shrouded blades is being analysed

    帶冠葉片不但能調頻，還可以利用葉冠之間的摩擦效應來耗散能量，達到減振的目的.帶冠葉片在離心力場中形成一整體，其整圈葉片振動特性不同於單個孤立葉片，需考慮葉冠的整體效應.利用帶冠葉片系統的循環對稱性，提出了採用波傳播理論和模態綜合技術，結合有限元方法研究燃氣輪機帶冠葉片振動特性的分析模型和計算方法.算例和工程應用證明了該方法是效性的、正確的，並可以大大降低計算分析規模.研究表明帶冠葉片動力特性分析時必須考慮整圈葉片的耦合效應
  16. In this paper. the conclusion of this paper has utility meaning in analysis on turbine blades cooling after some proper correcting of the geometry structure and boundary conditions

    由於所採用的結構及計算域近似渦輪葉片的冷卻形式（主流加熱，內流通道冷卻） ，因此這種方法經過進一步的改進，可用於渦輪葉片冷卻的計算研究。
  17. Wear failure analysis of plasma spray coating on damping area of turbine blade

    渦輪葉片阻尼面等離子噴塗層磨損失效分析
  18. Analysis of electric power generation characteristics for hybrid power system combining wind farm with gas turbine

    風電與燃氣輪機互補發電系統發電特性分析
  19. Structural dynamic analysis on head cover of gezhouba water turbine set

    葛洲壩水輪機組頂蓋結構動力分析研究
  20. System optimization and performance analysis of a humid air turbine cycle

    循環的系統優化和性能分析
分享友人
分享到 Line

分享到臉書