unsteady heat transfer 中文意思是什麼

unsteady heat transfer 解釋
不穩定傳熱
  • unsteady : adj. 1. 不穩固的。2. 不堅定的；動搖的；易變的，反復無常的，不可靠的。3. 行為古怪的；品行不好的。vt. 使不穩定，使動蕩。adv. -ily ,-iness n.
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  • transfer : n 1 移轉，轉送；調職；調任[轉學]證書；變換。2 （財產；權利等的）轉讓，讓與（證書），移轉，授受；...
  1. For a soil or rock of water - lacked, a heat transfer theoretical model is developed, which is a steady or unsteady, the results show that reservoir temperature, thermal diffusion coefficient, inlet temperature, flow rate of and run time of ground source heat pumps have an effect directly on heat transfer process of dhe. it can deduce that intermit running is favorable for this type of soils and rocks

    對于貧含水地下巖土層建立了穩態與非穩態傳熱的理論模型，分析結果表明，巖土層的熱儲溫度、導溫系數、埋地換熱器進水溫度、流量以及地源熱泵系統的運行時間或開停機比，都對埋地換熱器的傳熱過程產生直接影響，可以推斷，對于該類型巖土層的地源熱泵系統，採用間歇運行將是有利的。
  2. Numerical study of an unsteady transfer heat underground pipeline

    埋地輸油管道非穩態傳熱數值研究
  3. Abstract : by using the 3 - d unsteady state heat transfer equation, the heat convection and radiation between the checker and the gas which flows through the checker holes, and the heat conduction among the checker in the chamber of the hot blast stove were studied. the time dependable gas temperature and the temperature distributions within the checker were obtained

    文摘:應用三維非穩態熱量傳輸方程，對高爐熱風爐在燃燒過程中蓄熱室內格子磚與氣體之間的對流和輻射傳熱，以及格子磚內部的導熱過程進行了耦合求解.得到了在燃燒期內格子磚及燃燒過程中燃燒廢氣的溫度分佈情況及其隨時間的變化規律
  4. Presents the study on the cross - effect of heat and mass transfer of capillary porous media a. b. luikov set up on the irreversible thermodynamics principle with the theoretical solution of unsteady drying process given and its validity verified though experiments, and analyses using the mathematical model the influence of all factors on temperature and moisture distribution and the cross - effect of heat and mass transfer during drying processes

    針對雷柯夫建立在不可逆過程熱力學原理上的傳熱與傳質方程組，著重研究毛細多孔介質內傳熱與傳質過程中的交叉效應.得出了非穩態乾燥過程的理論解，並通過實驗驗證了其正確性，利用該模型分析了乾燥過程中各因素對內部溫度場和濕度場的影響以及交叉效應在乾燥過程中的作用
  5. According to heat load source of die cavity, temperature distribution gradient equations and heat flux equations and the peak value equations of temperature load at die cavity surface have been obtained with research of temperature distribution and transfer laws of die surface by unsteady heat transfer theory

    摘要根據鍛模型腔熱負荷來源，通過非穩態傳熱理論，分析研究了模具工作表面層的溫度分佈與傳遞規律，給出了型腔表面溫度分佈梯度和熱流密度公式，並給出了鍛模型腔表面的溫度負荷峰值的計算公式。
  6. In this paper, a image processing method has been presented, with this method mean temperature of testing object can be arrived at from infrared picture and the interior temperature gradient of the test pieces in the situation of transient heat transfer can be got. unsteady - state heat transfer mechanism of wall has also been studied in this paper. on the basis of theoretical analysis and experimental study we can get such conclusions : infrared testing of energy conservation of buildings is rapider and more accurate than heat - flow meter method which is popular at present ; heat transfer mechanism in the situation of unsteady - state heat transfer has been analyzed through experiment ; the interior layers ’ temperature of the test pieces ascent in company with

    本文在理論分析和試驗研究的基礎上得出以下結論:本文研究的紅外檢測建築節能的方法比目前存在的熱流計法更快速、更準確;用試驗分析了墻體在非穩態傳熱情況下的傳熱機理;試件各層溫度隨著受熱面環境溫度的上升而上升，只是上升的程度不同，響應時間不同，這是由於試件內部有一個蓄熱過程;通過傳熱理論和建築熱工計算推導出了非穩態傳熱情況下的傳熱系數的計算公式;本文用matlab進行紅外圖片的處理，進而得到被測物的平均溫度;用數據處理軟體擬合溫度熱流。
  7. The cryogenic performance of scq and ssm superconducting magnets are investigated both at steady operation state and at unsteady state in detail, including flow and heat transfer characteristics of cooling medium, and electromagnetic, mechanical characteristics of magnets

    本文以bepc中關鍵部件scq 、 ssm超導磁體為主要研究對象，研究了超導磁體在低溫下的穩態與非穩態工作特性中的若干問題，包括冷卻介質的流動特性、傳熱機理，磁體的冷卻結構、電磁與機械性能等。
  8. Multi - grid - blocks, finite volume method, maccormack difference method was used to solve the unsteady two - dimensional navier - stokes equation, finite difference method was used to solve the two - dimensional heat transfer problem

    數值計算方面，以多塊網格為特徵的s2df程序採用有限體積法， maccormack離散格式求解二維、非定常n - s方程，利用有限差分方法求解二維熱傳導方程。
  9. Abstract : according to the site condition of the bisc, a mathematical model of two - dimensional unsteady solidification and heat transfer was established for the bloom caster in the mold. the mathematical model was solved with a finite difference method to characterize the temperature profiles and thickness of the solidified shell in the mold, the effects of casting speed on thickness of the solidified shell are also studied

    文摘:根據包鋼的現場條件，建立了大方坯連鑄機結晶器內二維非穩態凝固傳熱數學模型，採用有限差分法對數學模型求解，得出結晶器中鑄坯的溫度分佈規律和凝固坯殼生成規律，同時研究了拉坯速度對坯殼生成厚度的影響
  10. Lii continuous casting research it is an important method to establish the heat transfer mathematical model of slab continuous casting to simulate secondary cooling process by means of two - dimensional unsteady state heat transfer mathematical model

    應用二維非穩態傳熱數學模型建立板坯連鑄的凝固傳熱模型進行模擬研究是連鑄技術研究的重要手段。
  11. Analysis of unsteady heat transfer - method of reaction coefficient in new type energy saving wall

    新型節能墻體的動態傳熱反應系數法分析
  12. Analysis and determination of items amount of reaction coefficient for unsteady heat transfer calculation of wall

    墻體不穩定傳熱計算中反應系數項數的分析與確定
分享友人
分享到 Line

分享到臉書