upper die 中文意思是什麼

upper die 解釋
上模
  • upper : adj 1 （更）上面的，上方的，上部的；較高的；上級的；（議會）上院的；（衣服）穿在外面的。2 上流的...
  • die : vi （died; dying）1 死。2 滅亡，消滅；熄滅；枯死，凋落。3 漠然不受影響，感覺不到 （to） 。4 泄氣...
  1. According to the structure of the final forging die, the flash groove is studied and coded into a separate sub - function. in order to split the upper and under dies, a sheet body of the separating surface is coded into a sub - function

    根據鍛模設計要求，研究了分模面、毛邊槽的設計並編制了相應模塊；研究了鍛模參數的計算和鍛模實體的生成。
  2. This paper, based on normalizing well logging data while drilling and correcting depth into true vertical depth and calculating reservoir parameters and etc, combining the practical ease of mobei oilfield, extracted logging and geological pattern characteristic of target oil - gas formation and geosteering mark formation, and used bp neural network and regressive analysis to create predicting mode of geosteering parameter to build relevant contrast curve ; adopted geometry geosteering method to fix on die drilling direction of bit upper and declination, the position in reservoir, to judge the real drilling case. all finely solved the problem to follow the geological target while drilling for three horizontal well these methods improve the drilling horizontal well ability by using the techniques to follow the geological target while drilling, and then it is convenient and practicable

    本文在開展隨鉆測井資料的標準化和斜井校正及儲層參數解釋與含流體性質判釋等工作的基礎上，結合研究工區莫北油田的實際情況，提取了目標油（氣）層和導向標志層的測井地質模式特徵，並採用bp神經網路法和回歸分析法建立了地質導向參數的預測模型、構造了相應的對比曲線；採用幾何導向法確定鉆頭上下傾鉆進方向及其在目標層的位置，以判斷實際鉆進地層情況，很好地解決了研究工區三口水平井的隨鉆跟蹤地質目標的問題。
  3. Mount upper die lip after mounting restrictor bar

    節流棒安裝完成後再安裝上模唇。
  4. Mount restrictor bar into the restrictor bar groove of upper die, mount adjusting bolt for restrictor bar into the bolt hole in the restrictor bar, then mount lower press block, upper press block

    在上模節流棒槽內裝入節流棒，將節流棒調節螺栓裝配進節流棒的螺絲孔中，再裝配上壓塊。
  5. Clean the dismantled restrictor and die body ( including upper and lower die bodies ). be sure to clear plastic residue in the die with soft tools like aluminum and brass products, cloth and compressed air

    清理拆卸下的節流棒和模具體（包括上、下模體） ，注意清理時一定要使用軟質的器具如鋁、黃銅製品，及抹布、壓縮空氣等將模具上的殘留塑料清理干凈。
  6. Fix upper and lower blocks on the die with m16 screws

    用m16的螺絲將上下壓塊固定在模頭上。
分享友人
分享到 Line

分享到臉書