upper temperature limit 中文意思是什麼

upper temperature limit 解釋
上溫限
  • upper : adj 1 （更）上面的，上方的，上部的；較高的；上級的；（議會）上院的；（衣服）穿在外面的。2 上流的...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  • limit : n. 1. 界限，界線；邊界。2. 極限，限度；限制。3. 〈pl. 〉范圍，范域。4. 限價；限額；賭注限額；獵物限額。vt. 1. 限制，限定。2. 減少。adj. -able
  1. Therrnogravimetric analysis at heating rates 5, 10, 15 and 20 c / min was used to study the decomposition kinetics of the pdms / pma ipn in ni and in air by using tg and dtg, and the upper limit of the temperature was 700 c. it was found that ipn began to decomposite at 350 c. the process of the thermal degradation was multiple steps, the curve of the rate of thermal decomposition had two peaks, one of which lied between 400 c ~ 420 c and the other lied between 500 c ~ 540 c, the result corresponded to the components of ipn

    在熱分解動力學研究中，通過在兩種氣氛中，分別以5 、 10 、 15和20 min四種升溫速率條件下，採用tg - dtg聯動測試， ipn材料在350開始熱分解。熱分解速率存在兩個峰值，一個分解峰值在400 420之間，另一個在500 540之間，這與ipn結構中包含兩組分相對應，同時發現當緩慢升溫時，特別是在空氣氣氛中，兩個分解峰減弱，熱分解趨向於一個連續過程。
  2. How to set the upper limit and lower limit temperature

    怎樣設置溫度上限下限和化霜周期？
  3. The upper temperature limit in this country is about 27 centigrade

    這個國家的最高溫度大約為攝氏27 。
  4. From experimental result, i preliminarily know that eps is good thermal insulation material because the absorption of water is low and heat insulation is good, it is practicable at preserving temperature field of frozen earth roadbed and bringing frozen disaster under control ; second, according to the analysis of the eps that is applied into practical project, i have studied the practical effect which eps preserve roadbed temperature field, and the influence that was made after building field. i have get that eps can influence moisture content and frozen upper limit, through practical measuring data, i have studied freezing and expanding quantity and melting and submerging quantity during a complete frozen and melting cycle as well as have expanded and proved the practical application effect of eps with some reference significance to deep research of some connected problems. finally, through computer data analysis, setting up the analytical model of finite unit, i have simulated the temperature field of roadbed heat preservation, then expounded and proved that the height of embankment influenced the effect of thermal insulation material

    其一是對聚苯乙烯泡沫塑料（ eps ）保溫板以及天然路基土層、路堤填料進行了室內試驗分析，結合國內外現在的有關科研成果，綜合確定其各項特徵參數；從試驗結果初步認識到聚苯乙烯泡沫塑料是一種吸水率低，隔熱性好的保溫材料，在凍土路基溫度場的保護和凍害治理方面是可行的；其二通過eps保溫板在現場工程實踐中的應用分析，研究了保溫板在保護路基土層溫度場的實際效果以及修築路堤后造成的影響，保溫板對土體含水量、凍結上限的影響，通過實測資料，研究了在一個完整的凍融周期內整個路基的凍脹量和融沉變形量，論證了保溫板的實際應用效果，對有關問題的進一步研究和相關工程設計具有參考意義；其三，通過計算機數值分析，建立有限元分析模型，對保溫路基的溫度場進行了模擬計算，論證了路堤高度對保溫材料效果的影響。
  5. Sige simox : oxygen ions with high dose were implanted into sige grown directly on silicon substrate for the first time, and sige - oi novel structure was formed successfully with additional high temperature annealing ; it has been confirmed that oxygen implantation with 45kev, 3 1017cm - 2 and annealing at 12500c in ar + 5 % o2 for 5 hours, are fit for the formation of sige - oi structure ; ge loss during the high temperature annealing has been observed, which is originated from ge volatility and ge diffusion ; it has been proposed to use nanoporous layer induced by h + / he + implantation to surppress ge diffusion and to use surface oxidation to overcome the upper limit of sige simox. sige smart - cut : hydrogen ions were implanted into sige material and followed by high temperature process ( 4000c to 7000c ) ; blistering study was done and suggested the possibility of sige layer transfer by smart - cut technology ; it is concluded that the bubble formation is easier in sige than in si, and the strain in sige / si and the difference of binding energy in sige and in si could possibly contribute to this effect. behavior of sige / si implanted with hydrogen : gave a detailed study on sige implanted by beamline or phi hydrogen implantation ; it has been found that great strain is introduced into sige by hydrogen implantation and this strain could be alleviated by high temperature annealing ; both for conditional beamline implantation and piii hydrogen implantation, 600 is appropriate for the post - implantation treatment

    Sige - simox工藝方面：首次採用硅（ 100 ）襯底上直接外延的100nm厚sige的樣品中注入高劑量的o離子，通過退火處理成功制備了sige - oi新結構，即sige - simox工藝，證實了以45kev注入3 10 ~ （ 17 ） 7cm ~ （ - 2 ）劑量的氧離子，隨后在氧化層的保護下經1250 ， ar + 5 o _ 2氣氛的高溫退火（ 5小時）過程，可以制備出sige - oi新型材料；實驗中觀察到退火過程中的ge損失現象，分析了其原因是ge揮發（ ge通過表面氧化層以geo揮發性物質的形式進入退火氣氛）和ge擴散（ ge穿過離子注入形成的氧化埋層而進入si襯底中） ，其中ge擴散是主要原因；根據實驗結果及實驗中出現的問題，對下一步工作提出兩個改進的方案：一是通過在si襯底中注入適量h ~ + / he ~ +形成納米孔層來阻斷ge擴散通路，二是可以通過控製表面氧化來調節安止額士淤丈撈要表面sige層中的ge組分，從而部分解決sige
  6. It begins to refrigerate when the temperature in the milk jar is higher than the temperature upper limit, and stops refrigerating when the temperature is below temperature lower limit

    ：當奶罐內溫度高於「溫度上限」時，開始製冷，一直到溫度降到低於「溫度下限」時停止製冷。
  7. The results demonstrate that the upper limit of permafrost in this area had declined from 1970s to the middle phase of 1990, and permafrost has appeared degenerate tendecy, but since middle 1990s, permafrost have a stable state ; ground temperature of roadbed near the earth surface is higher than that of the natural ground, thawing time of roadbed near the earth surface is longer than that of the natural ground, the heat income within the permafrost is greater than the heat release from the permafrost during anannual period, the heat accumulation within the permafrost is temporarily appeared as temperature rising, but with the heat accumulation within permafrost growing up year by year, permafrost temperature will become higher gradually, and strong thawing of permafrost could be happened in the region

    結果表明：風火山地區從20世紀70年代到90年代中期凍土上限下降，凍土出現退化現象，從90年代至今凍土趨于穩定；路基近地表地溫明顯高於對應天然地表下的地溫，路基近地表經歷的融化期長于對應天然地表，進入多年凍土區的熱收支也呈現出吸熱明顯大於放熱的周期性變化，進入多年凍土的熱積累暫時以增高地溫耗熱為主，但隨著凍土吸熱量的逐年積累、凍土溫度的不斷升高，本區凍土可能發生強烈融化。
  8. After absorbing heat, the temperature rises to rated value and is let out at hot - blast mouth. when the hot - blast temperature reaches to the rated upper limit, the burner will stop to work automatically or turn to small fire. when the hot wind temperature reaches to the rated lower limit, the burner will kindle again or turn to big fire

    需加熱的空氣通過選配的鼓風機強行送入熱風爐、吸熱后溫度升至額定值從熱風出口送出、當熱風溫度達到額定的上限溫度時，燃燒器會自動停止燃燒或自動轉為小火陷燃燒，當熱風溫度降低到額定的下限溫度時，燃燒器又會重新點燃運行或轉為大火燃燒，升溫的速度可調進風閥來實現。
  9. Set temperature upper limit

    溫度上限設置上限溫度
  10. Set at least 2 seconds, the nixietube shows the upper limit temperature, and upper limit led lights, then using

    秒，進入設置狀態，這時「溫度上限」燈亮，數碼顯示器上顯示上限溫度，用「
  11. Set and hold it for at least 2 seconds, the controller displays the upper limit temperature, and upper limit led lights, then using the key

    秒，進入設置狀態，這時「溫度上限」燈亮，數碼顯示器上顯示上限溫度，用「
  12. Set at least 2 seconds, the micro - controller displays temperature that is upper limit also the upper limit lights, then using

    秒，進入溫度設置狀態，這時「溫度上限」燈亮，數碼顯示器上顯示上限溫度，用上或下鍵改變設定值「
  13. Set and hold it for at least 2 seconds, the micro - controller displays temperature that is upper limit, also upper limit led lights, then using the key

    秒，進入設置狀態，這時「溫度上限」燈亮，數碼顯示器上顯示上限溫度，用「
  14. Set and hold it for at least 2 seconds, the controller displays the temperature upper limit, and the led of temperature upper limit lights, then using the key

    秒，進入溫度設置狀態，這時「溫度上限」燈亮，數碼顯示器上顯示上限溫度，用上或下鍵改變設定值「
  15. At the same time for at least 2 seconds, the micro - controller displays temperature that is upper limit, also upper limit led lights, then using the key

    同時按上下兩個鍵，進入溫度上限設置狀態，這時數碼顯示器上顯示的溫度即為上限溫度，然後用上或下鍵改變設定值「
  16. The temperature of creek segments down from dam no. 2 has exceeded the upper survival limit of juvenile salmons. the spawning season temperature of these segments also tends to surpass normal reproduction temperature range

    二號壩以下溪段七、八月的夏季高溫已到達幼鮭耐受極限，生殖季節水溫亦偏高，為不適于棲息之環境。
  17. Set upper limit temperature has been revised

    設置上限溫度已修改
  18. Setting upper limit temperature

    設置上限溫度
  19. Set upper limit temperature

    設置上限溫度
分享友人
分享到 Line

分享到臉書