voltage phasor 中文意思是什麼

voltage phasor 解釋
電壓相量
  • voltage : n. 【電學】電壓,電壓量,伏特數。 the working voltage (電氣的)耐壓限度。
  • phasor : 彩色信息矢量
  1. Models with different measurements precision based on phasor measurements are built. as for measurements with low precision, the voltage phasor of nodes with pmus are iterated as state variables. as for the measurements with enough precision, the measurements of pmu are regarded as state results directly

    在此基礎上,建立了基於相角量測的狀態估計模型,對不同精度的pmu量測值採用不同的狀態估計模型, pmu精度較低時,在增加量測量冗餘度的同時, pmu所在節點的電壓相量仍然作為狀態變量參加迭代; pmu精度足夠高時,直接將pmu的量測值作為狀態估計的狀態解, pmu所在節點的電壓相量不參加狀態估計。
  2. After investigating the relationship between generator measuring speed pulse and its on - load voltage at phase a, it is proposed in the thesis that we can obtained phasor of generators through messuring dividing frequency signal of generator measuring speed pulse

    我們研究了發電機測速脈沖和其a相空載電勢相位的關系,提出了只需測量與發電機同軸的測速發電機發出的測速脈沖的分頻信號,經過計算就可以得出發電機相角的測量方法。
  3. The equivalent parameter estimation and on - line voltage stability index at weak buses of network side based on phasor measurement is presented

    提出了基於相量測量的薄弱節點電網側等值參數的估計和在線電壓穩定指標。
  4. Phaser including phasor of generators and phasor of bus voltage are most important state variables that reflect stability of power systerm. if it can be measured at real time, dispatcher adopts in effect controlling step based on phasor such that all generators can still be synchronously operated to do this, it is necessary to messure the phasor of generators and to send. them to the power system control center

    相角(包括發電機的功角和母線電壓相角)是反映系統穩定性的最主要的狀態量,如果它能夠被實時測量,可以根據相角信息採取有效的控制措施,從而使得發電機群仍然能夠保持同步。為此,必須測量各發電機的功角,並把此信息送到調度中心。
  5. The time harmonic voltage and current wave propagation along a transmission line can readily be transferred from frequency domain voltage and current phasor distribution along the line

    由傳輸線上電壓及電流沿線分佈之頻域相量,可轉換為傳輸線上各頻率成份弦波電壓及電流沿線之時域傳播。
  6. The non uniform variation along the line of the input impedance calculated from phasor voltage to current ratio is conformed with that calculated from the phasor ratio of one plus the reflection and one minus reflection along the line

    數值驗證,由駐波電壓與駐波電流之相量比及由沿傳輸線一加反射與一減反射相量比計算所得之輸入阻抗,沿傳輸線之不均勻變化是一致的。
  7. The sinusoidal voltage and current distribution on the line of each frequency component is obtained by the phasor equation for the transmission line and the source and load impedances

    將傳輸線上不同位置電壓及電流之頻譜以快速富氏反轉換即得傳輸線上不同位置之近似電壓及電流脈波。
分享友人