volume calculation 中文意思是什麼

volume calculation 解釋
容積計算
  • volume : n. 1. 卷，冊；書籍；【歷史】書卷，卷軸。2. 〈常 pl. 〉大塊，大量，許多。3. 體積；容積；分量，額；【物、樂】音量；強度，響度。
  • calculation : n. 1. 計算，計演算法。2. 推定，預測。3. 深思熟慮，精打細算；慎重的計劃；算計。
  1. Three steps were involved : ? ) estimation of the ileum volume of the animal using single compartment model. ? ) measurement of the flex of each compartment. ? ) determination of the amino acid content of chymus of abomasums and ileum, and calculation of the amino acid digestibility

    試驗分為3步：一是測定回腸體積，二是測定各分域的流率，三是測定真胃和回腸食糜中氨基酸含量和計算小腸氨基酸消化率。
  2. However, the volume of some room in the modern high building and large public construction are much larger than others, such as assembly room, so the calculation consequence of the software would be incorrect with the supposition

    然而現代高層建築及大型公用建築，有的受限空間體積相差很大，如會議室等與客房體積相差幾倍甚至上百倍，採用網路模型的思想簡單視其為單一節點不可能獲得正確的預測結果。
  3. The maximum of the piezoelectric constant d33 is 68pc / n when the volume fraction of pzt, pvdf, pan is 0. 55, 0. 45, and 0. 05 respectively. finally, when the n, a, p are 6, 0. 6, 0. 3 respectively, the calculation value can agree well with the experimental data

    而且經過理論計算與比較，當以下三個參量取下列值時，即陶瓷顆粒形狀因子n = 5 、極化率= 0 . 6 、結構因子q = 0 . 3時，實驗數據與理論計算吻合較好。
  4. In the design, the construction measures such as application of shrinkage - compensating concrete, arrangement of spacing layer between the foundation rock and the bottom slab, adding outside waterproof layer, flexible connection between outlet pipe with side - wall, integerated concrete placement of pump seat with bottom slab and design of reinforcement with application of advanced calculation theory are used according to the characteristics of lager span, larger volume and complex loading conditions of the understructure

    針對下部結構跨度大、體積大、受力復雜的特點，在設計中採取多種措施，包括採用補償收縮混凝土、基巖與底板間設隔離層、增設外防水層、出水管與邊墻採用柔性連接、機座與底板整體澆注、採用先進計算理論指導配筋。
  5. It adopts reynolds time - average n - s equation and k - ? turbulence model to calculate the inner 3 - d viscid turbulence flow of centrifugal pump. in the unstructured grid, the governing equations are discretized with finite volume method based on finite element method. then the pressure correction method is used to carry out numerical calculation

    而後採用基於雷諾時均n - s方程與標準-湍流模型來求解離心泵葉輪內三維粘性紊流，在非結構化網格中，採用基於有限元的有限體積法對方程進行離散，用壓力校正法進行數值求解。
  6. This paper establishes a model simulating dam actual placing process and considering the non - continuity of initial temperature on the boundary of new and old concrete, daily air temperature change, concrete - placing temperature, hydration heat, heat insulation on boundary, water - storing process, placing intermission and curing with water. the calculation of stress field considers the concrete weight, static water pressure, thermal stress, different autogenous volume change between rcc and normal concrete, change of elastic modulus of concrete with age and creep action

    考慮了乞今最為全面的初始條件和邊界條件，包括模擬壩體的實際升程過程，考慮了新老混凝土接觸面上的初始溫度不連續，逐日的氣溫變化，混凝土的入倉溫度，水化熱溫升，邊界保溫，水庫蓄水過程，澆築間歇以及灑水養生等因素；應力場的計算考慮了混凝土的自重，靜水壓力，溫度應力，常態混凝土與碾壓混凝土不同的自生體積變形，混凝土的彈性模量隨齡期的變化以及徐變的作用。
  7. Calculation of coal hill volume by using contour line method

    等高線法煤山體積計算
  8. A calculation of the approximate sales volume required to just cover costs, below which production would be unprofitable and above which it would be profitable

    一種銷售收入大致與成本持平的計算方法，在其之下將無利潤，之上則可獲利。指用來描述固定成本、變動成本以及利潤等三者間關系的分析技術。
  9. Oxygen diffusion transport and electrochemical reaction in the oxygen cathode of direct methanol fuel cell ( dmfc ) have been expressed with the tffa model. model calculation has been carried out to investigate the effects of structural parameters of the dmfc cathode on the electrode performance, which is respectively represented by the curve of cathode overpotential versus current density. much attention has been paid to parameters including the porosity of the reaction layer, the thickness of the thin - film on the flooded - agglomerate, the radius of the flooded - agglomerate, the volume fraction of the flooded - agglomerates in the reaction layer

    本文首先運用tffa模型描述直接甲醇燃料電池（ dmfc ）陰極氧氣的傳遞和電化學反應過程，研究了過電位-電流密度曲線受陰極結構參數變化的影響程度，其中著重考慮了以下幾個參數：催化層的孔隙率，浸漬聚集體薄膜的厚度，浸漬聚集體的半徑，浸漬聚集體在催化層中的體積分數。
  10. On this base, a more precise volume model of concrete is established and one conception of dry mortar volume is brought forward. at the same time the author absorbed the concept of the best ratio between paste and aggregates and used mathematical method to induce the formulas of water content and ratio between fine aggregate and coarse aggregate in concrete : ratio between fine aggregate and coarse aggregate : if the two formulas are connected with the classical rule of water cementitious materials ratio ( bolmy formula ), the contents of all materials in concrete can be determined completely by calculation and overall calculation proportioning is realized

    在此基礎上建立了普遍適用的更精確的混凝土體積模型，提出了「干砂漿體積」概念，同時吸收國外關于最佳漿集比概念，用數學方法推導建立了混凝土用水量和砂率的計算公式：用水量公式：砂率公式：這兩個公式結合傳統的水膠比定則（保羅米公式） ，即可全面定量地確定混凝土的所有組成材料的用量，實現混凝土的全計算配合比設計。
  11. To solve the inaccuracy problem caused by the two existing methods ( average end - area method and prismoidal method ) used for the calculation of roadway earthwork volume, this paper puts forward a new concept of the 3 - dimensional algorithm that takes all the roadway geometric design procedures as a kind of geometrical operation between the ground model ( original terrain model ) and the roadway model ( designed model ) under certain constraints, and then presents a complete 3 - dimensional algorithm of roadway earthwork volume as well as its executable computer program. the algorithm benefits from the re - triangulation technique of constrained delaunay triangulation ( cdt ), which can yield a true volume value theoretically. through a number of practical tests covering varied intervals between adjacent cross sections, it is proven to possess a higher accuracy compared with that of traditional methods. all the work involved in this paper indicates that the 3 - dimensional calculation of roadway earthwork volume is feasible, more accurate and should have further application in practice

    針對目前廣泛使用的道路土方量計算方法平均斷面法和稜柱體法計算不準確的缺點，提出了三維土方量計算演算法的概念.該演算法以帶約束的狄羅尼三角化（ cdt ）為技術核心，認為所有道路幾何設計過程都是地面模型和道路（設計）模型進行幾何運算的結果.基於此，本文設計出相應的演算法步驟，同時完成了相應的軟體開發，使得該三維演算法能和傳統的方法進行對比.此外，結合工程實例，採用了不同的道路橫斷面間距對三維計算方法和傳統方法的誤差進行比較、分析.結果證明三維演算法具有更好的精度，該演算法可用於道路、場地平整等工程土方量計算
  12. Moreover, as an application of this module, the fuel volume calculation and error analysis of two types of training plane are made

    完成了兩個型號教練機的油量計算與姿態誤差分析。
  13. Volume marked calculation for horizontal vessel and spherical vessel

    臥式容器及球罐體積標定計算
  14. The limitation of mini - volume and mini - power application condition is adequately considered, and design of whole refrigeration system is accomplished farther, including choose and structure design of compressor, choose and calculation of heat exchanger, calculation of capillary, etc. structure design of the rotary compressor is the most primary part of the design of whole refrigeration system

    根據計算結果，並充分考慮到小體積、小功率的應用環境限制，進一步完成了整個製冷系統的設計實現，包括壓縮機的選型和設計、換熱器的選擇和計算以及節流管的計算等等。其中，滾動轉子壓縮機的結構微型化設計是整個製冷系統設計的核心部分。
  15. A simplified set of equations for analysis of the filling. finite difference methods are used for the pressure calculation. advancement of flow f ront uses a control volume approachand dynamic simulation of the moldfilling process is achieved. other is wetting out process which is the most critical stage in rtm. this stage is a typical porous media flow problem

    從粘性流體力學的質量和動量方程出發，建立了描述充模流動過程的數學模型，利用有限差分法求解壓力方程，並利用控制體積法跟蹤流體前沿；第二部分是充模流動的主體部分，屬于典型的多孔介質的流動問題。
  16. Firstly, we made investigations for reconstructed effects by measurements and surveys at sites, and made evaluations of social function using blurry synthetic evaluation methods. secondly, we analysed and valued the ecological functions, taking the fixed volume calculation of gardening vegetables the various types of ecological functions of garden and the fixed analysis of the ecological adjustment as the basic methods. lastly, in the thesis, many methods are used to calculate the value of economic values, such as shadow project method, market - value method, substitute method, and so on

    首先，通過實地測量和問卷調查等方法對其改造效果進行調查，並且運用模糊綜合評價法對其社會功能進行評價;其次，以城市園林綠化綠量計算為基礎，以園林植物不同種類生態功能定量計算為基本方法，對其生態功能進行了分析和估算;最後，運用碳稅法、造林成本法、影子工程法、市場價值法、條件價值法、替代法等方法，估算了其經濟功能。
  17. The technique of water control for offshore oil field is made up of profile control technique and water shutoff technique which include necessity judgment of water control, type selection, volume calculation and injection technology of shutoff agent

    海上油田控水技術由注水井調剖技術和油井堵水技術組成，這兩項技術都由措施必要性判斷、堵劑選擇、堵劑用量計算和堵劑放置工藝等技術組成。
  18. The application of method of alter average section in earthwork volume calculation

    用變更平均斷面法計算鐵路土石方工程量
  19. Round and sawn timber - method of measurement of dimensions - part 2 : round timber - requirements for measurement and volume calculation rules ; german version en 1309 - 2 : 2006

    圓木和鋸木.尺寸測量方法.第2部分:圓木.測量和體積計
  20. Analyses the physical characteristics of diesel oil, the volume calculation of daily - use oil tank and the related items in the revised edition of the code for fire protection design of tall buildings

    摘要對柴油的物理特性、日用油箱的容積計算及修訂版《高層民用建築設計防火規范》相關條款進行了分析。
分享友人
分享到 Line

分享到臉書