volume method 中文意思是什麼

volume method 解釋
容積法
  • volume : n. 1. 卷，冊；書籍；【歷史】書卷，卷軸。2. 〈常 pl. 〉大塊，大量，許多。3. 體積；容積；分量，額；【物、樂】音量；強度，響度。
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. Finite volume method in thermal analysis of avionics

    高可靠性航空電子設備熱分析中的有限體積法
  2. Surface active agents - determination of interfacial tension - drop volume method

    表面活性劑界面張力的測定滴體積法
  3. The results show that the drop volume method is a reliable and convenient approach to measure dynamic interfacial tension

    實驗數據證明，當破乳劑存在於油相中，水相離子價態對界面張力的影響是一個重要因素。
  4. In the paper, river and the downstream area of dike are regarded as a whole system, and hydraulic model of coupling 1 - d river and gradual dike - break is established, therein the preissmann implicit difference scheme is applied to main river, and the fvm ( finite volume method ) is applied to the breach and polder

    本文將河道與堤壩下游區域視為一個整體，對于單一河道採用preissmann四點隱式差分格式計算，對于潰口及圩區採用有限體積法，建立了一維河道與堤壩漸潰耦聯的水力模型，也是一維、二維耦合的水流模型。
  5. Finite volume method is appilied in numerical modeling of the flow in no - pressure tunnel of high water reservoir in this paper. i select standard k - turbulence modeling that put forward by launder and spalding in 1972 by weighted poly - turbulence modeling. the difficulty is that there is free surface in flow, but free surface problem ' s calculating region is indefinitely

    本文利用有限體積法對高水頭下水庫無壓泄水洞水流進行了紊流數值模擬，根據多種紊流模型的優缺點進行比較，選擇了launder和spalding於1972年提出的標準的k ?紊流模型。
  6. The chimera embedding technique is presented for the external store separation configuration. it divides the whole region into many subdomains. euler equations are used for every subregion with the finite volume method

    本文採用嵌套網格技術，將飛機投放外掛物的模型分成多個計運算元域，對飛機投放外掛物的復雜外形進行了分區迭代求解。
  7. It adopts reynolds time - average n - s equation and k - ? turbulence model to calculate the inner 3 - d viscid turbulence flow of centrifugal pump. in the unstructured grid, the governing equations are discretized with finite volume method based on finite element method. then the pressure correction method is used to carry out numerical calculation

    而後採用基於雷諾時均n - s方程與標準-湍流模型來求解離心泵葉輪內三維粘性紊流，在非結構化網格中，採用基於有限元的有限體積法對方程進行離散，用壓力校正法進行數值求解。
  8. 4. a 2 - d and 3 - d euler equations and n - s equations are solved using the cell - centered finite volume method and four - step runge - kutta scheme on the cartesian grids with standard convergence acceleration techniques such as local time stepping, enthalpy and implicit residual smoothing

    使用jameson中心有限體積法和runge - kutta時間推進方法，求解了關於二維、三維復雜流場的euler 、 navier - stokes方程，採用了當地時間步長、隱式殘值光順等多種加速收斂方法。
  9. Abstract : the dynamic interfacial tension at crude oil / water interface was studied by drop volume method at different temperatures and concentration of demulsifier

    文摘:採用液體體積法測定了原油/水體系在不同溫度和不同破乳劑濃度下的非平衡態界面張力，並對水相不同離子價態對界面張力的影響進行了研究。
  10. A high - resolution finite volume method 2d shallow water equations

    求解二維淺水方程的一種高解析度有限體積法
  11. A new finite volume method for two dimensional convection - diffusion problems

    二維擴散輸移問題的一種新的有限體積演算法
  12. Finite volume method, fvm

    網格的有限體積法
  13. Numerical simulation of square cavity flow by second - order up - wind finite volume method

    二階迎風有限體積法方腔流數值模擬
  14. Application of finite volume method in plane 2 - dnumerical model for nonuniform sediment

    平面二維全沙數值模擬方法及其應用
  15. Finite volume method

    有限體方法
  16. Analysis of the accuracy of the spatial discretization schemes for surface integrals in finite volume method

    有限體積法中面積分離散格式的精度分析
  17. In the second chapter, the fluid mechanics principle of vortex flowmeter at first was introduced. the classical theory about vortex flowmeter and the method of computational fluid dynamics about flow around body were expanded on, and the model of the single bluff body and the dual bluff body vortex flowmeter were constructed. and then, fvm - finite volume method - analysis software fluent was applied to analyze the flow phenomenon of flow over single bluff body or dual bluff body

    然後通過大量實驗和理論分析給出雙鈍體渦街流量計的設計準則：當管徑為d ，鈍體形狀為三角形，則鈍體設計參數為：銳邊寬度= 0 . 26d ，高度= 0 . 34d ，鈍體之間的距離= 1 . 2d （即當兩鈍體寬度相等且鈍體距離等於單鈍體兩列旋渦之間的距離） 。
  18. In this paper this problem is calculated by using finite volume method that prouduce though finite difference method and finite element method, and obtained the velocity and pressure distribution, through the compare between numerical result and model experiment result, there is very good inosculation

    本文利用有限差分法和有限元法所派生出的有限體積法對其進行數值計算，求解出計算區域的速度及壓力分佈，數值計算結果與模型試驗結果吻合較好。
  19. Based on the principles of designs of self - compacting and light aggregate concrete mix, sclc of lc30 - lc50 was developed by using absolute volume method. the main factors affecting the workability of sclc were studied by adopting the modified l - 800 fluidity instrument. the results indicate that the key techniques insuring good workability of sclc are about 30 % first - grade fly ash, about 50 % volume sand ratio, 2 % ~ 6 % dosages of silicon fume and compounded superplasticicizers with viscous ingredient

    採用改進l - 800流動儀，研究了影響lc40自密實輕骨料高性能混凝土工作性的主要因素，結果表明：粉煤灰摻量保持30左右，硅灰摻量為2 6 ，體積砂率為50左右和摻加具有粘塑組分的復合高效減水劑是保證sclc拌合物具有較好工作性的關鍵。
  20. In the paper, a numerical model of the interior flow of the submarine - based missile underwater launching is established. simulation of the interior flow of submarine - based powerless missile underwater launching is performed by applying the finite volume method

    本文建立了潛射導彈水下發射的內流場數學模型，採用有限體積法（ fvm ）對無動力導彈潛艇發射時的內流場進行了模擬計算。
分享友人
分享到 Line

分享到臉書