volume testing 中文意思是什麼
volume testing
解釋
批量測試-
Testing methods for the volume density, general porosity and water absorption of bonded abrasive products
磨具體積密度總氣孔率和吸水率.試驗方法 -
We research the causes of concrete cracking, develop the high performance anti - cracking additive, optimize the concrete mix and construction techniques, increase the stability of concrete volume by shrinkage compensation, enhance splitting tensile strength, and can meet demand of high workability of fresh concrete. in the study, a thorough investigation of this problem is made from all points of view, with the aid of various modern measurement & testing technology and different theories & methods in surface physical chemistry, structural chemistry, solid - state chemistry, composite materials, fracture mechanics, etc. our research results have shown that the various shrinkage of concrete cause concrete cracking in building engineering, such as autogenous shrinkage, dry shrinkage, temperature shrinkage, plastic shrinkage, carbonized shrinkage, etc
目前，解決混凝土開裂的方法是綜合的，我們調查研究了混凝土開裂的原因，開發研製了高性能抗裂外加劑，優化混凝土的設計和施工方法，並通過補償收縮達到混凝土體積穩定，提高抗裂強度，滿足混凝土拌和物高工作性能的要求。本研究採用多種測試技術，應用表面物理化學、結構化學、固體化學、復合材料學、斷裂力學等多學科的理論與方法，從不同的角度進行深入的研究和探討。通過調查研究建築工程中出現的混凝土開裂、滲漏問題，發現混凝土在非荷載作用下開裂主要是由混凝土的自收縮、乾燥收縮、溫度收縮、塑性收縮、碳化收縮等各種收縮變形引起的。 -
The the room volume is 1512 m3, bottom acoustic noise is lower than 18db, and the testing system is from b k company of danmark
消聲室容積1512立方米，本底噪聲低於18分貝，採用丹麥b k公司的檢測儀器。 -
Be aimed at the characters of fluvial layered pool, such as serious intrastratal and interlayer heterogeneity, small water flooding volume and low oil displacement efficiency in its high water - cut stage, the fine research work on reservoir heterogeneity model are carried out, and the research is done on the base of geological, logging, production testing materials and production date and with a center of the research of remaining oil. the west 7th block, gudong oilfield is in case. the forming mechanisms of remaining oil and its distributing feature in this area are revealed
本文針對我國陸相沉積層狀油藏層內及層間儲層非均質性嚴重、高含水期水驅波及體積小、驅油效率低等特點，以剩餘油研究為中心，藉助于數學地質統計及聚類分析等方法，綜合利用孤東七區西的地質、測井、生產測試資料和生產動態信息等，深入開展了儲層非均質模型的精細研究，揭示了在不同規模非均質模型上剩餘油的形成機理和分佈特徵。 -
Cryogenic vessels - transportable vacuum insulated vessels of not more than 1000 litres volume - part 2 : design, fabrication, inspection and testing
低溫容器.容量不超過1000升的可運輸真空絕熱容器.第2部分:設計生產檢驗和試驗 -
Based on rheologic and mutative mechanism of coal and gas outburst, this article discusses the forecast of outburst danger of in 7 ( superscript # ) coal heading face of jinjia mine by adopting coal and gas outburst volume dynamic index after blowing out. it determines the index critical value, and also presents the tentative testing result
摘要基於煤與瓦斯突出流變突變機理，探討了金佳礦7 （上標# ）煤層掘進工作面採用放炮后落煤瓦斯湧出量動態指標預測突出危險性，確定了指標臨界值，並介紹了初步試驗效果。 -
Cryogenic vessels - transportable vacuum insulated vessels of not more than 1000 litres volume - design, fabrication, inspection and testing
低溫容器.不超過1000升容積的可運輸的真空隔熱容器.設計，製造，檢驗和試驗 -
Standard specification for reference masses and devices for determining mass and volume for use in the physical testing of hydraulic cements
水硬水泥物理試驗中質量和體積測定用標準質量與設備的標準規范 -
Regarding the lcm filling process as the newton fluid through fibrous reinforcements, the permeability of preform determines the saturating of resin in fiber, and has effects on the curing process and the quality of products. based on the darcy ' s law, the theoretical model of permeability measurement was established. and the influence of different testing methods and major process parameters such as fabric structure, fiber volume fraction, injection pressure, flow rate and resin viscosity on preform permeability were investigated in details
文中首先根據達西定律建立了滲透率測量的理論模型，深入研究了不同的測試方法及主要工藝參數（纖維織物織構、纖維體積含量、充模壓力、流動速度、樹脂粘度）對滲透特性的影響規律，發現多孔介質增強材料的滲透率主要取決于纖維織物的結構形式，預成型體孔隙分佈及其體積分數、壓實性對滲透率有較大的影響，提高充模壓力和流動速度可以縮短充模時間，在一定程度上可以提高滲透率。 -
The paper based on the model volume of the money supply = basis money monetary multiplier, had each factor of the basis money and monetary multiplier in normative analysis and empirical testing, and considered various factors such as the speed of money circulation effect to money multiplier
本文按照模型貨幣供給量=基礎貨幣貨幣乘數，對基礎貨幣和貨幣乘數的影響因素逐一進行規范分析和實證檢驗，並考慮各種影響因素如貨幣流通速度對貨幣乘數的作用。 -
Some customers who ' ve been testing volume activation 2. 0 haven ' t seen anything they ' d quantify as “ substantial, measurable benefits, ” however
但是，一些測試過批量激活2 . 0的消費者並沒有看到微軟所說的「實質的、明顯的效益」 。 -
Testing of sealing materials for buildings ; determination of change in volume after temperature load ; pycnometer method
建築物用密封材料的檢驗.溫度加載后體積變化的測定 -
Aimed to the electric bicycle testing technology is n ' t adapt to the requirements of volume - produce in modern enterprise with the electric bicycle industry growing, a electric bicycle automatic testing system is researched and manufactured by using of the modern design methodology
本文針對路面行駛檢測技術的許多不足，利用現代設計方法學的有關理論對電動自行車自動檢測技術進行了研究，並開發研製了電動自行車自動檢測系統。該系統在多家企業投入使用後效果良好。 -
Testing methods for phthalic esters - part 4 : heating loss, acid value after heating, volume resistivity
鄰苯二甲酸脂的試驗方法.第4部分:加熱損失加熱后的酸值體電阻率 -
Testing method of cryo - insulation pressure vessels volume measurement
低溫絕熱壓力容器試驗方法容積測量 -
In large - volume testing environments, you might also want to create a gui to display all verification failures see figure 5
在大容量的測試環境中，您也許還想建立gui來顯示所有的驗證失敗（參見圖5 ） 。 -
On the other hand in volume testing, the test execution may go on and on
另外，在容量測試中，測試可能會不間斷的運行。 -
Volume testing is performed to find weaknesses of the system with respect to its handling large amounts of data over time
容量測試通過系統對大量數據的處理時間來找到系統的弱點。 -
The main works and contribution of this paper are as follows : 1. central type finite volume method proposed by jameson a. is investigated and the boundary condition of the method is improved. compared with the testing data it is proved that the program for 3d viscosity steady flow in thrust vectoring nozzle developed is correct and reasonable
研究了jamson提出了中心型有限體積法，並改進了其在邊界上的處理，通過驗證計算驗證了本文發展的矢量噴管三維有粘流動計算程序的正確性。 -
Method of testing volume resistivity of conducting and antistatic plastics
導電防靜電塑料體積電阻率測試方法
分享友人