water cut oil 中文意思是什麼
water cut oil
解釋
含水石油-
From the error resource, this paper emphatically analyzes the cause that the metering error produces in the process of crude oil metering with this flowmeter, and discusses the necessity of insulating the prover, installing the automatic sampler and automatic water cut analyzer
著重從誤差的來源分析了用容積式流量計進行原油計量產生誤差的原因，指出了體積管保溫、安裝自動取樣器和自動含水分析儀的必要性。 -
The crude oil water - cut analyzer with a low energy source
低能源原油含水分析儀 -
The problem which identificate oil - water two phase flow pattern with information entropy is discussed profoundly. the information entropy distribute in the range from 0. 1209 to 0. 1659 for 61 % kw 91 %. changes of the information entropy with variations of total flowrate and water - cut correspond to oil in water in existing flow pattern map
）為61 91時，信息熵值分佈在0 . 1209 0 . 1659之間，與流型圖對比可知，信息熵值與總流量q _ 1及含水率之間有良好的對應關系，表明此范圍為水包油流型（油為分散相） 。 -
This theoretic model employs the basic idea of correlation measurement, achieve the density wave speed by the correlation of the signals of upper and lower sensors, and get the total flow rate and water cut through the theoretic relationship of density wave speed and total flow rate as well as holdup with the help of drift flux model so as to accomplish the oil / water two - phase flow measurement at last, using the limited available experiment data, the theoretic model has been simplified into an applicable linear alternative which is suitable to homogeneous oil / water two - phase flow measurement to accomplish the oil / water two - phase flow measurement using the density wave phenomena is of highly theoretically valuable for density wave theory research as well as oilavater two - phase flow measurement research. to develop new type oil / water two - phase flow instrumentation based on this theoretic measurement method will be very applicable and promising
在此基礎上，針對穩態密度波理論提出了基於密度波理論的油水兩相流測量理論模型，該模型以密度波傳播理論作為基礎，通過上下游傳感器信號相關獲得密度波傳播速度，利用密度波傳播速度與總流量以及持相率的理論關系結合漂移模型來求解總流量和含相率，實現油水兩相流的測量，在理論分析的基礎上，在實驗資料有限的條件下，對基於密度波理論的油水兩相流測量理論模型作了極限的簡化，提出了本文油水兩相流測量理論方法應用在測量均勻油水兩相流中的實用線性模型。 -
Be aimed at the characters of fluvial layered pool, such as serious intrastratal and interlayer heterogeneity, small water flooding volume and low oil displacement efficiency in its high water - cut stage, the fine research work on reservoir heterogeneity model are carried out, and the research is done on the base of geological, logging, production testing materials and production date and with a center of the research of remaining oil. the west 7th block, gudong oilfield is in case. the forming mechanisms of remaining oil and its distributing feature in this area are revealed
本文針對我國陸相沉積層狀油藏層內及層間儲層非均質性嚴重、高含水期水驅波及體積小、驅油效率低等特點，以剩餘油研究為中心，藉助于數學地質統計及聚類分析等方法，綜合利用孤東七區西的地質、測井、生產測試資料和生產動態信息等，深入開展了儲層非均質模型的精細研究，揭示了在不同規模非均質模型上剩餘油的形成機理和分佈特徵。 -
The theoretical study of the recovery percent vs. water cut of thin and bottom water reservoir in luliang oilfield is based on developing its geologic and flow models, obtaining oil - thickness ratio, oil - water viscosity ratio, relative permeability curve parameter and chart of effect of bottom water toning, etc., on water - yielding pattern of the reservoir
摘要在建立了陸梁薄層底水藏地質及滲流模型基礎上，採用理論研究的方法，研究了薄層底水油藏采出程度與含水率關系式，並獲得了油厚比、油水粘度比、相滲曲線特徵參數以及底水錐進等對油藏產水規律的影響關系圖版。 -
Using normal probability model is more simple and efficient to determine performance and characteristic parameter of waterflood oilfield, so it is feasible and practicable to forecast water cut and oil recovery of waterfood oilfield and evaluate its development measures
摘要應用正態概率模型可以方便地確定水驅動態變化、描述水驅特徵參數，這就使得預測油田含水率、採收率、評價並發措施變得比較簡便而實用。 -
Aiming at the abnormal phenomenon that water content of some production wells with decline along with the time in the yanqi basin, this paper puts forward an argument that low water - cut oil layers exist in the low permeability formation
摘要針對焉耆盆地部分生產井，在投產過程中存在隨時間的延長含水率下降的反常現象，提出了低滲地層存在低含水油層的觀點。 -
With the development of oil fields, many old reservoirs in the east of china enter the high water - bearing development period. sustaining a high and stable production rate faces severe challenge. the key to preserve oil output in high water cut period is dependent upon the understanding degree to the properties of residual oil distribution. from 1980 ' s, while the study of the reservoir flow unit was proceeded alongside, it has been more widely utilized to characterize reservoir feature and remnant oil distribution. study of reservoir flow unit plays. both theoretically and practically. an important role in recognizing reservoir heterogeneity. performing a high - definition reservoir delineation and understanding the distribution of the remnant oil in the reservoir
隨著油田的不斷開發，我國東部許多老油田已進入高含水期開采階段，保持油氣產量的穩定面臨嚴竣的挑戰，而高含水油田穩產的關鍵取決于對剩餘油分佈的認識程度。八十年代以來，隨著對儲層流動單元研究的不斷深入，它越來越廣泛地被應到油藏描述和剩餘油研究中來，流動單元研究對于認識儲層的非均質性、提高油藏描述精度、搞清剩餘油分佈具有重要的理論意義和實際意義。 -
This paper analyzes the causes of high water cut in oil well and proposes corresponding well logging methods according to the features manifested by all kinds of high water cut oil wells
對造成油井高含水的原因進行了分析，並根據各種高含水油井表現出的特徵給出了相應的測井方法。 -
Practice for improving the recovery during the super - high water cut in dongxin oil field
東辛油田特高含水期提高採收率的實踐 -
Meanwhile coaxial line phase water cut meter has realized dynamic measuring of oil well water cut. and the detecting results objectively represent flowing state in pumping wells
同軸線相位法含水率計實現了油井含水率的動態測量，其測量結果客觀反應了抽油機井中油水兩相流動狀態。 -
Simulation results shows that water cut increases rapidly after coning control to the level before coning control and oil production increases a little but too little compared with the production loss during oil well shut - in
還通過數值模擬方法對壓錐效果進行了研究，模擬結果顯示，壓錐后油井的含水快速升高至壓錐前的水平，油井產量雖略有提高，但與壓錐期間油井關井損失的產量相比，仍然得不償失。 -
Logging method and pre - processing method of logging data have been ascertained for the logging tool formed by coaxial line phase water cut meter and other function units such as temperature meter and flow meter. data of 10 oil wells obtained by the logging tool has been interpreted using the soft - measuring model, and the result is accordant with data of ground measurement. it indicates that the soft measurement model of coaxial line phase water cut meter has high interpreting precision
確定由同軸線相位法含水率計組成的組合測井儀的現場測井方法以及測井數據資料的預處理方法，並利用軟測量解釋模型對現場所測10口井的資料進行解釋，結果與地面計量符合較好，說明同軸線相位法含水率計的軟測量模型在現場測井解釋中具有較高的解釋精度。 -
On the basis of integral study of core data, testing and geology in es3 of huzhuangji oilfield both before and afater water injection, the major factors inducing reservoir changes are analyzed in the area after water injection, a model is established for interpreting physical properties of the reservoir, by which the study of reservoir heterogeneity turns to dynamic development from static one, by which basis is laid down for precision study of remaining oil distribution at the high water - cut stage
在綜合研究胡狀集油田沙三段注水前後巖心、測試、地質等資料的基礎上，分析該區儲層注水后容易變化的主客觀因素，建立儲層物性解釋模型，使儲層的非均質研究由靜態向動態方向發展，為精細研究高含水期剩餘油分佈規律奠定基礎。 -
Based on analysis of geological and developing factors affecting water cut of oil wells, model for predicting water cut in small layers of oil wells under different sandbody connecting relations between oil and water wells is set up by using numerical simulation method
本文在對影響油井含水的地質及開發因素分析的基礎上，用數值模擬方法建立了油水井間不同砂體連通關系下，油井小層含水率預測模型。 -
Based on conclusion of practical experience from polymer flooding pilot test, and in combination with theoretical calculation and analysis of numerical simulation, the varying range of main production index by polymer flooding is determined, varying mode of liquid production, comprehensive water cut, oil production and incremental oil by polymer flooding is set up by adopting reservoir engineering method, forming simplified, fast and feasible method for calculating production index by polymer flooding, which provide practical and theoretical basis for making polymer flooding programe
本文在總結聚合物驅礦場試驗實踐經驗和結合數值模擬理論計算分析的基礎上，研究確定聚合物驅主要開采指標的變化范圍，採用油藏工程方法建立聚合物驅采液量、綜合含水、採油量和增油量的變化模式，形成簡便、快速、實用的聚合物驅開采指標測算方法，為編制聚合物驅規劃方案提供了實踐和理論依據。 -
Abstract : based on conclusion of practical experience from polymer flooding pilot test, and in combination with theoretical calculation and analysis of numerical simulation, the varying range of main production index by polymer flooding is determined, varying mode of liquid production, comprehensive water cut, oil production and incremental oil by polymer flooding is set up by adopting reservoir engineering method, forming simplified, fast and feasible method for calculating production index by polymer flooding, which provide practical and theoretical basis for making polymer flooding programe
文摘:本文在總結聚合物驅礦場試驗實踐經驗和結合數值模擬理論計算分析的基礎上，研究確定聚合物驅主要開采指標的變化范圍，採用油藏工程方法建立聚合物驅采液量、綜合含水、採油量和增油量的變化模式，形成簡便、快速、實用的聚合物驅開采指標測算方法，為編制聚合物驅規劃方案提供了實踐和理論依據。 -
Through the comparison between test and commission of low water - cut oil layers and the analysis of electric property and logging display characteristics, this paper brings forward the methods for identifying oil layer, low water - cut oil layers and oil and water layers, namely, through the comparison between natural potential and natural gamma as well as the varieties of oil saturation, electric resistivity, curve shape of hydrocarbon, volumetric coefficient and geochemical bright spot index to identify the layers
通過對低含水油層的試油與投產對比，對電性、錄井顯示特點的分析，提出了用測井自然電位與自然伽馬對比、含油飽和度、電阻度、氣測全烴曲線形態、灌滿系數、地化亮點指數的變化等識別油層、低含水油層、油水同層的方法。 -
Based on the analysis and research on test results, it discusses the existence of low water - cut oil layers due to porous media and pore water in micro pores of reservoir
在分析研究化驗資料的基礎上，探討了儲層存在多孔介質、微細孔隙水等產生低含水油層的原因。
分享友人