water injection method 中文意思是什麼

water injection method 解釋
水噴射法
  • water : n 1 水；雨水；露；〈常作 pl 〉 礦泉，溫泉；藥水。2 〈常 pl 〉水體；水域；水道；海；湖；河；海域；...
  • injection : n. 1. 注射。2. 注射劑，注射液，針藥，灌腸（藥）。3. 充滿，注滿。4. 【醫學】充血。5. 【機械工程】噴射。6. 【宇宙空間技術】（衛星等的）入軌，射入軌道，射入軌道的時間[地點]。
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. Based on the development feature analysis, this paper studies thoroughly the reservoir flood feature and remaining oil distribution through the microstructure, sendimentary phase, reservoir heterogeneity and well control, and proposes the comprehensive adjustment based on the injection and development well net structure and improvement the result of the research is obvious with the production degression rate from 9. 14 % of 1997 to present - 1. 46 %, and water rate from original 0. 33 % to present 0. 16 %. in summary, the research idea, method and new achievement of the thesis provide a scientific geological basis for the oilfield development improvement

    在對本區開發歷程和開采特徵分析的基礎上，從微構造、沉積微相、儲層非均質性、井網控制等方面深入地分析了油藏水淹特徵及剩餘油分佈規律，提出了以完善注采井網、調整注采結構為目的的綜合調整措施，已見到了明顯的效果：油田遞減由1997年的9 . 14降至目前的- 1 . 46 ，綜合含水上升率由原來的0 . 33降至目前的0 . 16 。
  2. Recommended operational method for preventing of clay - swelling and fine - migration in acidizing of water injection well

    注水井酸化中粘土防膨與微粒防運移工藝規范
  3. The method for plotting chart on pressure - loss curve through choke of water injection well

    配水嘴嘴損曲線圖版製作方法
  4. At chengdao oil field, seawater injection is a main method in oil extraction, but it is difficult to improve the water quality

    在海洋石油平臺採油過程中，注水採油是一種行之有效的方法，然而注水系統及其水處理系統的自動化程度卻一直沒有得到必要的提高。
  5. Measurement of water flow rate in closed conduits. tracer methods. part iii : constant rate injection method using radioactive tracers

    密封管道中水流速的測定.示蹤法.第3部分：放射性示蹤器恆流速噴射法
  6. Measurement of water flow in closed conduits. tracer methods part ii : constant rate injection method using non - radioactive tracers

    密封管道中水流量的測定.示蹤法.第2部分：使用非放射性示蹤物的恆速率噴射法
  7. After synthetically analyses and researches of the existing methods for injection allocation rate, this article takes the group of water - injecting wells in waterflood oilfield as the research unit, the multiple regression method to decide the injection allocation rate is applied, by which and its regression coefficient and partial correlation coefficient, the multivariate regression models of model and model are developed

    在對目前存在的配注方法的綜合分析和研究之後，提出以水驅油田注水井井組為研究單元，採用多無回歸方法來確定注水井井組配注量，並基於多元回歸方法的回歸系數和偏相關系數，分別建立了多元回歸模型、 。
  8. Study of method using flow injection analysis to survey the cyanide in the water

    流動注射分析儀檢測水中氰化物的方法研究
  9. The new development in modern determination of anionic surfactants in environmental water samples is emphasized, including spectrophotometry, chromatography and flow injection analysis method. 1inail, the prospect of its determine methods are related

    重點論述了發展較快的分光光度法、色譜法和流動注射分析法等，並展望了在測定陰離子表面活性劑方法上的發展趨勢。
  10. In this paper, technology for water injection by long bore hole in fully mechanized mining face was studied, relevant experience and some parameter were acquired, which provide a reference for using this method in similar faces

    以鄭州礦區典型的「三軟」煤層綜放工作面為對象，試驗研究了長鉆孔注水防塵技術，取得了「三軟」煤層長鉆孔注水經驗和參數，為鄭州礦區類似條件的工作面推廣該方法提供了參考。
  11. Abstract : in this paper, technology for water injection by long bore hole in fully mechanized mining face was studied, relevant experience and some parameter were acquired, which provide a reference for using this method in similar faces

    文摘:以鄭州礦區典型的「三軟」煤層綜放工作面為對象，試驗研究了長鉆孔注水防塵技術，取得了「三軟」煤層長鉆孔注水經驗和參數，為鄭州礦區類似條件的工作面推廣該方法提供了參考。
  12. Intelligent method to predict trend of running status of equipment for water injection station

    注水站機組智能化機器狀態趨勢預測方法
  13. A method for determining the reasonable rate of water - injection stations in a large - scale system

    大型注水系統注水站合理排量的確定方法
  14. Standard test method for volatile alcohols in water by direct aqueous - injection gas chromatography

    用直接水噴注氣相色譜法測定水中揮發性醇類含量的標準試驗方法
  15. Method for efficiency testing and unit energy consumption calculation of oilfield water - injection surface system

    油田注水地面系統效率測試和單耗計算方法
  16. A resistivity method with vertical line source has been used to study the distribution of injection water and surplus oil

    摘要利用套管供電，通過地表觀測電位研究油田注水分佈和剩餘油分佈在油田開發中的應用。
  17. Method for formation fracture pressure prediction of water injection wells and its application

    注水井地層破裂壓力預測方法及應用
  18. Based on the fundamental theory of dynamics of soil moisture and the condition of water storage pit irrigation, numerical modeling of soil moisture movement of single water storage pit in heterogeneous soil is established. adi ( alternating direction implicit method ) and gauess - seidel iterative method are used to solve it. by using the simulated value of modeling, the relation of water injection volume and maximum horizental distance of moisture frontal are concluded. according to the relation, interval of pits are derived. then, after analyzing the infiltration characteristic of soil moisture under the condition of interference infiltration in multi storage pit, numerical modeling of soil moisture movement of multi water storage pit in heterogeneous soil is established, and its numerical solution is also acquired

    利用adi （交替方向隱式差分法）結合gauess ? seidel迭代法對模型進行數值求解。利用模型的計算結果得出了單坑注水量與濕潤鋒最大水平推進距離之間的關系，並據此確定了坑距。在此基礎上，通過對多坑干擾入滲條件下土壤水分入滲特性進行分析，太原理工大學碩士研究生學位論文建立了蓄水多坑非均質土壤水分運動數學模型，並對其進行數值求解。
  19. Optimization method for layered water injection project based on the distribution of remaining oil

    基於剩餘油分佈的分層注水方案優選
  20. Study on method of water quality optimization in water injection to develop oil field

    注水開發油田水質優化方法研究
分享友人
分享到 Line

分享到臉書