water injection 中文意思是什麼

water injection 解釋
內燃機注水減少污染
  • water : n 1 水；雨水；露；〈常作 pl 〉 礦泉，溫泉；藥水。2 〈常 pl 〉水體；水域；水道；海；湖；河；海域；...
  • injection : n. 1. 注射。2. 注射劑，注射液，針藥，灌腸（藥）。3. 充滿，注滿。4. 【醫學】充血。5. 【機械工程】噴射。6. 【宇宙空間技術】（衛星等的）入軌，射入軌道，射入軌道的時間[地點]。
  1. Quartz sand for sand control in oil, gas wells and water injection wells

    油氣水井防砂作業用石英砂
  2. Experimental studies on s1a - 02 gas turbine with water injection into compressor interstage / inlet as well as that on turbocharger self - loop test rig with inlet water injection are introduced. test results are in good accordance with simulation results, wet compression can lower compression work and increase engine power output so engine performance is enhanced, if engine power output is not changed, efficiencies of compressor and this engine become higher and turbine inlet temperature and fuel consumption become lower and if keeping t4 the same as that before wet compression is used, efficiencies become furthermore higher and engine power output increases greatly

    實驗結果和計算結果同樣表明：濕壓縮減少了壓氣機所消耗的壓縮功，增加了燃氣輪機的輸出功率，提高了燃氣輪機性能，如果保持發動機輸出功率恆定，濕壓縮可以提高壓氣機和整個燃氣輪機機組的效率，與此同時，渦輪進口溫度t _ 3 ~ *和燃油消耗率下降；如果保持渦輪排氣溫度t _ 4 ~ *恆定，壓氣機和燃氣輪機機組效率進一步提高，燃氣輪機輸出功率增加。
  3. 2. recuperative gas turbine cogeneration with water injection and its thermodynamic analysis recuperative gas turbine cogeneration can reduce exhaust temperature, make use of waste heat and increase efficiency

    二、功熱並供回熱注水燃氣輪機及其熱力分析採取回熱和功熱並供可以減小熱機循環的當量排氣溫度或有效利用余熱。
  4. In order to solve corrosion and heave scale deposit of water injection pipeline in zhongyuan pucheng oilfield 2. 5inch tbs2510ij glass fiber reinforced plastic pipe was used as water injection peip in two single well respectively in decemher of 1997 and january of 1998. its application results in good effect and is worth being populated

    總結在黃土高原儲罐基礎施工中處理瀝青砂墊層裂紋和凹凸度超標的實踐經驗，分析了缺陷成因，提出了處理和預防措施，實施效果良好。
  5. A low frequency hydraulic vibrator for water injection

    低頻水力振動注水器
  6. Meanwhile in the condition of high temperature, water vapors can participate in combustion. water gas reaction will happen, which will reduce carbon particle in flame, and reform combustion performance, so improve combustion efficiency. the article developed a kind of technology of water injection into intake ports for 4135g diesel engine, meanwhile designed a suit of water injection system

    同時在高溫條件下，水蒸汽參與燃燒，部分水分子與未完全燃燒的熾熱的炭粒發生水煤氣反應，形成可燃性氣體，從而減少了火焰中的炭粒，提高了油的燃燒程度，改善了燃燒狀況，提高了油的燃燒效率。
  7. Recommended operational method for preventing of clay - swelling and fine - migration in acidizing of water injection well

    注水井酸化中粘土防膨與微粒防運移工藝規范
  8. Annulus water injection

    環空注水
  9. To solve some questions about oil production declining quickly, production and injection patterns are imperfect, the low degree of reserves control, and the injection water not enough in injection well, we have taken measures such as strengthen the geologic integrated research, drill extension well and adjustment well, strengthen water injection system, and optimize fracturing techniques, which has improved reservoir development effect

    為了解決產量遞減快、注采井網不完善、儲量控製程度低、注水井欠注等問題，採取加強地質綜合研究、鉆擴邊井和調整井、強化注水系統和優化壓裂工藝等措施，有效地改善了油藏開發效果。
  10. Finically, the dynamic property of portal water injection sheet piles is analyzed in this paper, and the influence on dynamic property of pile length and distance between piles is discussed in detail

    此外，還探討了門架式水力插板樁的動力特性，以及樁長和樁間距對結構動力特性的影響。為進一步指導工程實踐提供了理論依據。
  11. The case study shows the reason that for low permeability reservoir, oil well and water injection well should be spaced where natural fractures are developed in order to reach helter production response

    計算實例從理論上說明了低滲透油藏中，油水井部署在天然裂縫發育處開發效果較好的原因。
  12. The method for plotting chart on pressure - loss curve through choke of water injection well

    配水嘴嘴損曲線圖版製作方法
  13. Application of water injection profile data in oilfield

    吸水剖面資料在油田開發中的應用
  14. Economical operation for water injection system of oil field

    油田注水系統經濟運行
  15. Application of genetic algorithm in water - injection system

    遺傳演算法在注水系統中的應用
  16. The peak production can be reached at the 4th to the 7th months after water injection, and the production would decrease after the 8th month

    先導性注水試驗表明，注水開發可以使青平川油田產量在較短時間內得到大幅度提高，在注水后的第4到第7個月達到產量高峰期，第8個月後進入穩產期。
  17. Study of calculation model of pressure field of water injection string

    注水管柱壓力場計算模型研究
  18. Cycle analysis of gas turbine with water injection into inter - stage of its compressor

    壓氣機級間噴水燃氣輪機循環分析
  19. The prediction of scale near bore in the water injection development

    油田注水開發中近井帶結垢定量預測
  20. The initial production decrease degree of water injection is 0. 0191 ( 1 / month )

    油田注水開發產量遞減規律分析表明初始遞減律為0 . 0191 （ 1 /月） 。
分享友人
分享到 Line

分享到臉書