wave angle 中文意思是什麼

wave angle 解釋
波程角
  • wave : n 〈美海軍〉女志願軍人〈見 WAVES 條〉。n 1 波浪；碎浪； 〈the wave（s）〉 〈詩〉海。2 波動；波狀...
  • angle : n 【英史】盎格魯人〈cf Angles〉。n 1 角，隅，角落；棱，嬗角。2 【數學】角，角位，角的度數。3 【機...
  1. The report takes account into the influence of foreshore and shallow foreshore, roughness, slope, berm, wave attack angle, vertical wall and so on

    報告給出了復雜斷面上波浪爬高和越浪量的計算公式，計算中考慮了前灘、邊坡糙率、邊坡坡度、平臺、波浪入射角以及豎墻等因素的影響。
  2. Discussion on standard of critical angle of seismic wave in seismic analysis of complicated structures

    復雜結構地震波輸入最不利方向標準問題
  3. Studying the rule of the reflect - coefficient at the interface, simulating the seismic wave travel in the field beyond the critical angle, analyzing the wave polarity diversification, all the work provides a theory for the wide - angle reflection

    通過研究反射系數在超臨界角部分的規律，模擬地震波在超臨界角的傳播，分析了地震波的極性變化，為廣角反射提供理論依據。
  4. With account for the effect of temperature and shock - boundary layer interaction, the forebody / inlet with plane lip and wedge lip are designed by using the design methods of constant shock wave intensity and constant shock wave angle. in the design, the incidence angle of the first ramp, height of isolator, length of forebody and total turning angle of the designed forebody / inlet models are given

    另外，根據優選結果，給定前體長度、前體預壓縮楔角、總壓縮轉角及隔離段高度，分別用等激波強度和等激波角度的方法設計了唇口平直和唇口帶楔角的前體進氣道。
  5. A two - dimensional plain strain finite element model of infinite plate is developed to investigate the ultrasonic wave propagation and scattering on three kinds of cracks : parallel to the surface, 450 oblique angle to the surface, and quarter - circle

    摘要建立了無限長板的具有吸收邊界的二維平面應變有限元模型，在研究了脈沖超聲波在無限長板中傳播的基礎上，對板中平行於表面的裂紋、與表面成45的斜裂紋和四分之一圓周弧形裂紋三種情況的脈沖超聲波散射進行了重點研究。
  6. Simulator tests indicates the speed ; wave ; angle between ship and wave are main factors of the sinkage. difference factors given difference sinkage with simulator tests. 3. the date of width ; depth are two important factors of channel design, the relationship between width to depth is speed

    （ 3 ）航道寬度和航道深度的關系，聯結這二者關系是航速，航道寬度和航道深度是決定航道參數的二個重要因素，並相互存在著一定的關系。
  7. Three dimensional interaction flowfield over high - speed spinning projectile with lateral jets is numerically simulated in this dissertation firstly. complicated shocks wave patterns is analyzed. several factors concerned such as high - speed spinning, attack angle, base bleed and so on, are studied

    本文首次完成了高速旋轉彈丸側噴三維干擾湍流流場的數值模擬，分析了彈丸側噴流場復雜的波系結構，研究了高速旋轉、攻角、底噴等因素對彈丸側噴流場的影響規律，深入分析了旋轉側噴彈丸的空氣動力學特性。
  8. At first in the condition of low - velocity impact it is discussed with the formation of ceramic smash cone angle on the base of quasi - statistic hertz and 3 a 6 y a c - theory. then using spherical stress wave reflection and transmission theory under the state of medium - high velocity the formation of spot in the ceramic back. finally the damage mechanism of ceramic suffered by the high impact is simply discussed

    首先，在低速撞擊的條件下，基於準靜態hertz的理論與薩布斯基理論，分析了陶瓷破碎錐角的形成；其次，在中高速撞擊條件下，利用球面應力波反射迭加理論，分析了陶瓷背面的層裂的形成；最後，簡單討論了高速撞擊下陶瓷的破碎機理。
  9. Because the relationship between the lift on the fin and the fin angle is gotten by the static hydrodynamic experiment, which has great error, especially dynamic hydrodynamic experiment, the control torque gotten by the experiment can not counteract the wave torque well and the stabilization result is not perfect

    而鰭的水動力試驗存在著很大的誤差，特別是在動態條件下，鰭的水動力特性測試更困難，所以這種通過計算求得控制力矩的方法產生的鰭升力無法很好地抵消波浪力矩，因而影響了減搖效果。
  10. Estimating the directional angle of coming wave with regression analysis

    利用回歸分析法估計來波方位
  11. The experimental results show that the wave shaper can control the moving direction of the rod fragments after the warheads exploded and ensure the integrity rate of the rod and that there is a close relationship between the flight attitude and the positioned angle, which is mainly reflected by the rotation velocity of the rod

    試驗結果表明：採用波形控制器可以較好地控制戰斗部爆炸后桿形破片的飛散方向，以及保證桿條的完整率；桿條的飛行姿態與放置角有密切關系，主要通過桿條旋轉速度表現出來。
  12. The experiment show that cr : sbn crystal has super characteristic of four - wave mixing to produce the phase - conjugate wave. we study the dependence of the phase - conjugate reflectivity of 1000ppm cr : sbn crystal on the parameters of incidence light such as light intensity ratio and the angle of incidence

    研究了摻雜量為500ppm的cr ： sbn晶體的四波混頻相位共軛特性，發現該晶體的四波混頻特性不如摻雜量為1000ppm的cr ： sbn晶體。
  13. The main results show that : ( 1 ) the mechanism of laser bending is very different from that in bending with hard tools. ( 2 ) the bending angle is varied along scanning direction, and there is a deformation wave in the process. ( 3 ) the effects of sheet length on bending can be neglected while the length is more than 10 times of thickness. ( 4 ) the sheet width has much higher influence on the bending process

    分析發現：激光彎曲成形時板料的應力狀態與機械折彎時有根本不同；當激光束沿直線單向掃描時，板料兩端的彎曲角度不同；板料的長度大於10倍板厚或5倍光斑尺寸時，板長對彎曲角度的影響不再顯著；沿掃描方向，距離光斑中心3倍光斑尺寸以外的區域，仍然對彎曲變形量產生影響。
  14. After solution of radiational and diffractional fluid field of asymmetrical sections by applying the multipole expansion method, wave loads on damaged ships are calculated by the linear strip theory under the non - upright floating condition, taking the effect on the heel angle and trimming angle caused by the damaged tank inundation below waterline into account

    然後採用線性切片理論，計及水線以下破損后船舶由於艙室進水產生的橫傾角與縱傾角的影響，利用多級展開法求解非對稱剖面的二維輻射和繞射流場，計算了破損船體非正浮狀態條件下的波浪載荷。
  15. It is concluded that the stress transmission rate varies with stress wave s incident angle

    通過對相似模型超動態應變的測試驗證了所得理論公式的正確性，並獲得了透射率隨入射角的變化規律。
  16. Wave - shape apron belt with large angle transferring system can working both horizon and perpendicular, which can also work at any angle within 0 - 90 with large load. the cost of designing, handling and repairing is low. the technology is reliable. it is good for environment protection. it has been widely used in steel, chemical and cement industries, which have benefited a lot

    大傾角波狀擋邊帶式輸送機系統可以和垂直狀態下運行，也可在0 90度范圍內任一角度運行，允許大運載能力、重載運輸，為設計、施工和維護節省投資和運行成本，技術可靠，利於環境保護，在全國各大鋼鐵、化工、水泥等行業運行，使廣大用戶受益匪淺。
  17. In the first part, the basic knowledge of particle scattering in meteorology and physics was introduced. the particles to be discussed include aerosol particles, fog droplets and raindrops and the em wave band in the discussion is near - infrared. in the second part, the mie theory was briefly reviewed and was applied to investigate the scattering characteristics of spherical atmospheric particles, the result shows that in the visibility measurement meter using forward - scattering method, when the working wavelegth is between 0. 8 m ~ 2 m, the scattering angle is between 25 ~ 40, the distinguishability and the relative scattering intensity would be better than those under other conditions. in the third part, the superellipsoid was used to describe a wide range of shapes such as spheres. ellipsoids and cylinders. an improved t - matrix method which can be used to calculate arbitry shaped particle ' s scattering field was introduced, and the scattering characteristics of non - spherical atmospheric particles was investigated with this method

    計算結果表明，從相對散射強度、同一方向上不同粒子散射的可區分程度來看，在散射式能見度探測儀器中，工作波長介於0 . 86 m 2 m ，探測角度選取前向25度40度時，探測的結果將會是比較理想的。第三部分中，使用超橢球方程來統一描述各種非球形粒子的形狀，然後使用t矩陣方法計算了一些形狀的非球形粒子的近紅外散射特性。另外，在本文中還針對球形粒子的散射場提供了一種三維可視化方法，使對散射場強度的空間分佈的理解更加簡單，直觀。
  18. The result shows that under the effect of repeated impact load, the stress wave produces reflection in the metallurgical junction plane between coating and basal body, and forms stretch wave causing longitudinal split and angle split of coat ; the microcosmic spot pitting and deep layered peeling off occur in coating surface due to stress concentration ; the energy accumulation of impact loading causes rigidity variation and plastic deformation

    結果表明：在多沖載荷作用下，應力波在塗層和基體的冶金接合面發生反射，形成拉伸波造成塗層的縱裂和角裂；在塗層表面由於應力集中，塗層表面發生微觀點蝕和深層剝落；沖擊載荷能量的積累，造成塗層試樣硬度變化和塑性變形。
  19. Given dynamic stress concentration factor around the interface circular lining. some examples and numerical results and illustrated, the influence of wave number, incident wave angle and combination of different medium parameters upon dynamic stress concentration factor are discussed

    針對具體算例給出數據結果討論了不同波數條件、不同入射角作用、不同的材料常數組合對界面襯砌散射波遠場位移模式和散射截面的影響。
  20. This paper applies ittc single - parameter ocean wave spectrum to simulate a random long - crested ocean wave according to statistics superposition theory and real - time simulate disturbance on the ship by random wave. it simulates roll and pitch of the ship in random wave in the time domain and gains roll angle ( t ) and pitch angle ( t ) signal of ship rolling movement

    本文根據統計疊加理論，採用ittc單參數標準海浪譜模擬模擬實際的長峰波隨機海浪，進而實時模擬長峰波隨機海浪對船舶的隨機擾動，對船舶在海浪中的橫搖和縱搖運動進行了時域模擬，得到船舶搖蕩運動的橫搖角信號（ t ）和縱搖角信號（ t ） 。
分享友人
分享到 Line

分享到臉書