wave deformation 中文意思是什麼

wave deformation 解釋
波的變形
  • wave : n 〈美海軍〉女志願軍人〈見 WAVES 條〉。n 1 波浪;碎浪; 〈the wave(s)〉 〈詩〉海。2 波動;波狀...
  • deformation : 變形,走樣
  1. So the deformation modular of soil between piles, that is the rayleigh wave velocity of soil between piles is the capitally influence the sampling of n

    因此,樁間土的變形模量,即樁間土的瑞雷波速成為影響n取值的主要因素。
  2. The pre - seismic and post - seismic stress direction can be statistically determined by a large collection of foreshock and aftershock focal mechanism data while the stress drop can be determined through the source fracture inversion from seismic wave data or crust deformation data

    地震前後的應力方向可根據大量前震和餘震震源機制統計給出;地震應力降可通過地震波或地殼形變資料的震源破裂反演研究得到。
  3. In order to detect the bottom thickness, cavity, leak and deformation of steel meshes in secondary lining of concrete in tunnel construction, the authors evaluate the wave character and the detected result in the second lining of the tunnel using surveying radar technology and conclude the wave character in the tunnel lining which has mass defect and tested the accuracy and reliability of this technique

    摘要為檢明隧道混凝土二次襯砌中的底界厚度、空洞、漏水、鋼筋網變形等質量問題,利用探地雷達技術,通過對檢測方法及工程檢測實驗的研究,進行隧道二次襯砌中雷達波形特徵參數及檢測結果評價,總結了隧道襯砌質量問題的雷達波形特徵,驗證檢測方法的精度和可靠性。
  4. The frontal structure of longmenshan in the west of sichuan is very complex, showing intense structure deformation in overthrust belt, high structure amplitude, steep stratigraphic dip, developed fault blocks, complex seismic wave field, frequent change of lateral velocity, and poor image of post - stack time migration processing

    摘要川西龍門山前緣構造非常復雜,逆掩推覆構造帶構造形變強烈,構造幅度大,地層傾角陡,斷塊發育,地震波場復雜,速度橫向變化大,常規疊后時間偏移處理成像效果較差。
  5. If a refraction or a reflecting body is irregular, the wave front undergoes a deformation.

    如果折射體或反射體是不規則的,波前即產生變形。
  6. After that the dynamics behaviors and wave properties of finite deformation elastic thin rods are paid more attentions to in lagrangian coordinate

    然後,利用lagrange描述法對一維彈性桿中考慮有限變形時的幾何非線性波的波動特性及動力學行為展開討論。
  7. Finally, two - dimensional wave - motion equations of the finite deformation elastic rod are derived by variation principle taking simultaneously geometrical and physical nonlinearity into consideration

    最後,利用變分原理又導出同時考慮幾何和物理非線性的有限變形彈性桿的二維波動方程。
  8. The main results show that : ( 1 ) the mechanism of laser bending is very different from that in bending with hard tools. ( 2 ) the bending angle is varied along scanning direction, and there is a deformation wave in the process. ( 3 ) the effects of sheet length on bending can be neglected while the length is more than 10 times of thickness. ( 4 ) the sheet width has much higher influence on the bending process

    分析發現:激光彎曲成形時板料的應力狀態與機械折彎時有根本不同;當激光束沿直線單向掃描時,板料兩端的彎曲角度不同;板料的長度大於10倍板厚或5倍光斑尺寸時,板長對彎曲角度的影響不再顯著;沿掃描方向,距離光斑中心3倍光斑尺寸以外的區域,仍然對彎曲變形量產生影響。
  9. The result shows that under the effect of repeated impact load, the stress wave produces reflection in the metallurgical junction plane between coating and basal body, and forms stretch wave causing longitudinal split and angle split of coat ; the microcosmic spot pitting and deep layered peeling off occur in coating surface due to stress concentration ; the energy accumulation of impact loading causes rigidity variation and plastic deformation

    結果表明:在多沖載荷作用下,應力波在塗層和基體的冶金接合面發生反射,形成拉伸波造成塗層的縱裂和角裂;在塗層表面由於應力集中,塗層表面發生微觀點蝕和深層剝落;沖擊載荷能量的積累,造成塗層試樣硬度變化和塑性變形。
  10. Firstly, the hertz contact theory is used to design the export moment of the prototype ; deformation status of the flexspine under the elliptical cam wave generator action is analyzed using the column shell theory, whose boundary condition is four force action. design proposal of the wave producer put forward considering the precision theory of rolling friction transmission

    首先用赫茲接觸理論對樣機的輸出力矩進行了設計;應用四力作用下的光滑圓柱殼體理論分析了在橢圓凸輪波發生器作用下柔輪的變形狀況,結合滾動摩擦副傳動精度理論提出了波發生器總體設計方案。
  11. Deformation and breakup of droplets behind shock wave

    激波誘導的液滴變形和破碎
  12. Effects of single joint with nonlinear normal deformation on p - wave propagation

    非線性法向變形節理對彈性縱波傳播的影響
  13. The shake wave appear in the datum of strain and ground deformation, the step change appear in the datum of water temperature and water level, and the ability difference of recording earthquakes is large

    應變及地傾斜出現幅度不同的震蕩波,水溫和水位大部分出現明顯階變,且不同的儀器記震能力相差很大。
  14. Experiments are conducted in a 5 m long, 60x60 mm cross - section shock tube, liquid drops acted by shock wave undergo deformation, breakup and atomization. based on experiments, the effects of shock velocity and drop diameter on drop breakup time have been discussed

    採用ya ? 16高速照相機,詳細研究了液滴在激波作用下變形、剝離、破碎、霧化的全過程,並討論了液滴的破碎模式、激波強度和液滴直徑對液滴破碎時間的影響。
  15. A nonlinear numerical model for wave transformation is established in time domain based on integral equation transformed from two dimensional laplace equation. then the model is applied to compute the linear wave and nonlinear wave deformation in offshore flow field. a new 0 - 1 combined bem ( boundary element method ) is adopted in this thesis to avoid computational errors accumulated with time steps

    本文以波動勢函數的laplace方程的green積分轉換得到的邊界積分方程為基本控制方程,建立了一種新的時域內波浪變形計算的數值模型,籍此對非線性波浪在結構物周圍的波浪形態進行了數值模擬,並通過數值造波水槽內的波浪試驗對數值模擬結果進行檢驗。
  16. C. r. chou, r. s. shih and h. m. fang, 1996, deformation of solitary wave in coastal zones, boundary element methods, pp. 171 - 181

    周宗仁、石瑞祥、李中和, 1995 ,斜坡上考量復數消能系數對波浪變形影響之研究,第十七屆海洋工程研討會論文集。
  17. This software is composed of three modules : the pre - processing, analysis and calculation and post - processing. in the pre - processing, it includes automatic generation of structural meshes, adding contraints and loads and so on ; in the analysis and calculation, the wave - front is used to calculate and establish data files related ; in the post - processing, strong and visual function of vc + + is utilized to display structural deformation graph, contours as well as color cloud pictures. in this last processing, deformation graphs are divided into two types - boundary deformation graph and entire deformation graph in order to show deformation condition entirely ; contour graph comprises isodisplacement graph and isostress graph ; color cloud picture comprises cloud picture of displacement and that of stress, whose drawing principle is isoparametric mapping method

    該軟體由三個模塊組成,即前處理、分析計算和后處理。在前處理模塊中,主要包括結構網格的自動剖分、施加約束以及載荷等;在分析計算模塊中,採用波前法計算並形成有關數據文件;在後處理模塊中,利用vc + +強大的可視化功能自動整理計算成果並顯示結構變形圖、等值線圖和彩色雲圖。其中,變形圖分為兩種?外框變形圖和整體網格變形圖,以便能綜合顯示變形情況。
  18. Large deformation response of multirow steel tubes subjected to blast wave

    爆炸荷載作用下多排鋼管結構的大變形響應
  19. Associating example, the influence factors of the stress ratio of pile and soil are discussed, especially the replacement rate, the modular ratio of pile and soil, deformation modular of gravel pile, reyleigh wave velocity of soil between piles are given more effort

    文章結合實例對樁土應力比的影響因素進行了討論,並重點分析了置換率、樁土模量比、碎石樁變形模量、樁間土瑞雷波速對樁土應力比的影響。
  20. In the thesis domestic and foreign relation model of standard penetration blow count and shearing velocity, standard penetration blow count and deformation modular, shearing velocity and foundation bearing capacity are analyzed. on base of these analysis a new calculation model that applying rayleigh wave velocity to calculate the stress ratio of pile and soil between piles is established. because of the difference of region and soil character, the new model own three branch model, ie, japan model, wuhan model, xia liaohe mo del, in three different conditions

    文章通過分析國內外標準貫入擊數與剪切波速、標準貫入擊數與變形模量、剪切波速與地基土承載力之間的關系模型,並考慮到地區性和土質類別的差異,分別選用日本公路橋梁抗震設計新規程模型(日本模型) 、武漢地區模型、下遼河平原模型三種模型建立了新的樁土應力比計算模型? ?應用瑞雷波速求解樁土應力比之間的計算模型。
分享友人