wet power 中文意思是什麼

wet power 解釋
注水功率
  • wet : adj (opp dry )1 濕,潮濕的,有濕氣的。2 雨的,下雨的,多雨的。3 〈美俚〉允許賣[制]酒的,不禁酒...
  • power : n 1 力,力量;能力;體力,精力;(生理)機能;〈常 pl 〉才能。2 勢力,權力,權限;威力;政權;權...
  1. And careworn hearts were there and toilers for their daily bread and many who had erred and wandered, their eyes wet with contrition but for all that bright with hope for the reverend father hughes had told them what the great saint bernard said in his famous prayer of mary, the most pious virgin s intercessory power that it was not recorded in any age that those who implored her powerful protection were ever abandoned by her

    那些飽經憂患的心靈,為每天的麵包操勞的,眾多誤入歧途,到處流浪的。他們的眼睛被悔恨之淚打濕,卻又放出希望的光輝,因為可敬的休神父曾經把偉大的聖伯爾納在他那篇歌頌瑪利亞的著名禱文39中所說的話告訴過他們:任何時代也不曾記載過,那些懇求最虔誠的童貞瑪利亞為之祈禱有力地保護他們的人,曾被她所遺棄。
  2. Experimental studies on s1a - 02 gas turbine with water injection into compressor interstage / inlet as well as that on turbocharger self - loop test rig with inlet water injection are introduced. test results are in good accordance with simulation results, wet compression can lower compression work and increase engine power output so engine performance is enhanced, if engine power output is not changed, efficiencies of compressor and this engine become higher and turbine inlet temperature and fuel consumption become lower and if keeping t4 the same as that before wet compression is used, efficiencies become furthermore higher and engine power output increases greatly

    實驗結果和計算結果同樣表明:濕壓縮減少了壓氣機所消耗的壓縮功,增加了燃氣輪機的輸出功率,提高了燃氣輪機性能,如果保持發動機輸出功率恆定,濕壓縮可以提高壓氣機和整個燃氣輪機機組的效率,與此同時,渦輪進口溫度t _ 3 ~ *和燃油消耗率下降;如果保持渦輪排氣溫度t _ 4 ~ *恆定,壓氣機和燃氣輪機機組效率進一步提高,燃氣輪機輸出功率增加。
  3. Power tamp method treatment of wet and sunk loess foundation

    濕陷性黃土地基的強夯法處理
  4. On the base of the analysis on the advanced technology of hard ferrite in foreign country, the main procedures of preparing hard ferrite pre - sintering material are determined as follows : first, the ferrite oxides coming from the main cold rolling line and strontium carbonate are conveyed to storage tank by gas power and weighed automatically according to the demands of constituent composition. and then they are mixed and grinded by using method of wet treatment. finally the mixtures is transported to the devices of storage by transporting pump

    在分析國外先進的永磁鐵氧體生產工藝的基礎上,確定了生產高檔永磁鐵氧體預燒料的主要過程:首先,利用攀鋼冷軋鐵紅為主要原料,將氧化鐵紅及碳酸鍶採用氣力輸送至貯料料倉,經自動稱量裝置,按工藝配方稱量後分別由氧化鐵紅及碳酸鍶發送罐氣力輸送進入預混攪拌筒加水攪拌,然後再送入混磨機濕法混磨;最後,混合物經輸送泵輸送至料漿存儲裝置,經定量進料泵定量輸送至回轉窯進行濕法預燒,預燒料經緩冷至室溫后,再球磨。
  5. Products includes clutch cover. clutch disk for light & heavy vehicles, piston , engine for gasoline & diesel engine, shock absorber for light & heavy vehicles, auto remote security systems, power window controllers, normal alarm, door locks, fuel caps, steering column locks, alternator & starter, alloy & die casting parts, other automotive parts, wet and dry cylinder liner of gasoline and diesel engine

    主營產品有適用於輕,重型車用的離合器蓋,離合器鋼片,適用於汽油發動機和柴油發動機用的活塞,發動機,適用於輕,重型車用的減震器,汽車遙控安全系統,電窗控制器,報警器,門鎖,交流發電機,起動器,汽缸等。
  6. This thesis chiefly analyzes the problem of exchanging heat quantity and the methods of the improvement of cooling tower in power station, compares and analyses the advantages and disadvantages of it. this thesis will discuss how to prevent natural - draft counter - flow wet cooling tower from freezing in winter, and compute the areas of draught deflectors

    本文針對自然通風逆流式冷卻塔冬季運行時的防凍處理,及預防結冰所應採取的措施進行研究和計算,提出以增加或減少擋風板的高度來控制出塔水溫的方法,並對其進行計算分析。
  7. The research work in this paper was carried out at the second power factory of xici subsidiary. the production technology of strontium ferrite was studied and wet process of strontium ferrite pre - sintering material with anisotropic characteristic was determined. products of y30h - 2 which meet the standard series of sj / t10410 - 1993 were selected to be experimental products

    本文以西磁分公司料粉二廠為基點,研究了鍶永磁鐵氧體生產的工藝技術路線,確定了濕法工藝生產各向異性鍶永磁鐵氧體預燒料,並將試驗產品定位在sj t10410 - 1993標準中的y30h - 2產品。
  8. The application of wet desulphurization in handan thermal power plant

    濕法脫硫在邯鄲熱電廠中的應用
  9. According to the working principle of thermo - electrode, we demonstrate the structure of enlarged reflection area and the structure of step broaden waveguide to improve the switch ' s performance and bring down the driving power. according to the fabricating condition of our lab, we proposed simple wet - etching method to fabricate the oversized waveguides and peeling - off method to fabricate the electrode

    針對全內反射和熱電極的作用特點,在全內反射型熱光開關的設計中提出了擴大反射區結構和漸變展寬結構,理論模擬和實驗結果表明該方法能有效地提高了開關性能,降低了驅動功率。
  10. Mr power said, wiping his wet eyes with his fingers. poor paddy

    鮑爾先生用手指揩著盈眶的淚水說, 「可憐的帕迪
  11. Wet limestone flue gas desulfurization technology has been widely applied in coal - fired power plants all over the world due to its high efficiency and reliability

    石灰石濕法煙氣脫硫作為一種相對成熟、脫硫效率較高的脫硫技術,在世界范圍內得到了廠泛的應用。
  12. Their titles are : 《 the investigation of aca in the optimization of controller parameters in the thermal automation system 》, 《 realization of simulative simulation in wan 》, 《 inspired simulator and application in steam system of power units 》, 《 study and realization of wet flue gas system simulator in power plant 》

    其中,張倩同學的論文題目是《蟻群演算法在熱工自控參數優化中的應用研究》 ,陳孝偉同學的論文題目是《激勵式模擬系統在廣域網中的實現》 ,何麗娜同學的論文題目是《激勵式模擬機及其在火電機組蒸汽系統中的應用》 ,白永鳳同學的論文題目《火電廠濕法煙氣脫硫系統模擬機的研究及實現》 。
  13. The lowest threshold current 1. 8ma is achieved with continuous - wave at room temperature, the maximum output power is 7. 96mw. for the resesrch work on the fabrication procedures, we discusses selective oxidation and selective wet etching

    利用濕法氧化和選擇性腐蝕相結合工藝研製出室溫連續工作的vcsel ,最低閾值電流為1 . 8ma ,輸出功率為7 . 96mw 。
  14. The problem of acid rain is still severity, in the fossil power plant, the flue gas desulfurization is the main approach on controlling the let of so2. the paper mostly introduce the dcs rebuilding project of the desulfurization system in. the equipment is first introduced into our country from mitsubishi corporation, which is the wet limestone - gypsum flue gas desulfurization equipment

    火電廠煙氣脫硫是控制so _ 2排放的主要途徑。本文主要介紹華能珞璜電廠脫硫系統的dcs改造工程。該裝置是國內首家引進的日本三菱重工公司濕式石灰石石膏法煙氣脫硫裝置。
  15. Suitable for dewatering, medium drainaging, spraying, dry and wet classifying in coal, metallurgical ore dressing, power, light sugar making and salt making industries

    本系列篩適用於煤炭、冶金選礦、電力、輕工、製糖、制鹽對物料的脫水,脫介、脫泥和干濕式分級,具有處理能力大和篩分效率高等優點。
  16. Suitable for dewatering, medium drainaging, spraying, dry and wet classfying in coal, mining, met allurgical ore dressing, highway, railway, power, chemical ldustries, light sugar makyng and salt making industries. with high capacity and efficieney

    系列振動篩適用於煤炭、礦山、冶金選礦、公路、鐵路、電力、化工、輕工、製糖、制鹽對物料的脫水、脫介、脫泥和干濕式分級,具有處理能力大和篩分效率高等優點。
  17. Laser particle size analyzers that ourspecial researches of wet power 、 dry power and on - line for the business of cement plant in china have many customers and get favorable comments from the cement research institutes, joint ventures and cement plants of large scale

    公司專門為水泥行業研製的濕法、干法、在線激光粒度分析儀,在全國各地的水泥行業研究院所、合資企業、大型水泥廠有廣大的用戶並受到一致好評。
  18. Save cost : same wet - blue yield, save power to 80 %, and 40 % steam, even 50 % labor, and save the sewage disposal charge

    節省費用:相對同樣的產量的蘭濕皮節約能源可達80 % 。並節省40 %蒸汽用量,節省50 %的人力費用同時用水的減少也節約了污水處理的費用。
  19. Through real example of desulfuration project in guohua dingzhou power plant, the problems, such as slurry - freezing and blocking in the pipe conduit and other equipments, occurred in trial operation of limestone - gypsum wet type flue gas desulfuration equipment have been presented

    摘要通過國華定洲電廠脫硫工程實例,介紹了石灰石石膏濕法脫硫裝置在冬季試運期間遇到的管道、設備內漿液凍結及堵塞的問題。
  20. Simulation results show that wet compression can be used to cool compressors and gas turbines, when this technology is used, compression work consumed is lowered and engine power output increases and even more, compression work can be less than isentropic dry compression work

    計算結果表明:濕壓縮可以被用來進行有效的冷卻,減少壓縮功,增加渦輪輸出功;而且濕壓縮的壓縮功有可能比等熵干壓縮的壓縮功還要少。
分享友人