wind pressure coefficient 中文意思是什麼
wind pressure coefficient
解釋
風力系數- wind : n 1 風；大風，暴風；氣流；【機械工程】壓縮空氣。2 【航海】上風；風向；〈古語〉〈pl 〉方向。3 氣息...
- pressure : n 1 壓；按；擠；榨。2 【物理學】壓力，壓強；大氣壓力；電壓。3 精神壓力，政治[經濟、輿論等]壓力。4...
- coefficient : adj. 共同作用的。n. 1. 共同作用；協同因素。2. 【數，物】系數，率；程度。
-
Finally, with caparisons of that three parapets properties cantilevered parapets has been adopt to the steel structure of light - weight buildings with gabled frames, numerical simulations have been carried out with that buildings, results of simulations show that device can also significantly reduce the area - averaged coefficient of wind pressure and high negative suction peaks on zones susceptible to wind pressure. formula has been proposed about the height of that parapet
最後通過三種女兒墻的性能比較確定對門式剛架設置懸挑女兒墻進行數值模擬，結果同樣表明懸挑女兒墻能明顯地降低門式剛架屋面風荷載敏感區的負壓峰值及屋面風荷載體型系數，並給出了女兒墻高度限值公式。 -
Using the system designed in this thesis work, flow field calibration of the wind tunnel is accomplished, which covers dynamic pressure drop coefficient, dynamic pressure time stability, axial static pressure gradient, boundary layer, and degree of turbulence, etc. boundary layer measuring principle and method are especially described in detail, the relationship between boundary layer thickness, wind speed setting, and the depth of the experimental section is summarized, and finally the calibration data for th e model center zone under specific wind speed are given
然後利用本文設計的系統完成了落差系數、動壓時間穩定姓、軸向靜壓梯度、邊界層及湍流度等內容的流場校測。特別對邊界層測量的原理及方法做了較詳盡的敘述，總結出邊界層厚度與設定風速、實驗段深度的關系，然後給出模型中心區一定風速下校正數值。 -
This paper takes jin ’ ao mansion and adjacent buildings as the study object. first we put the stated reduced scale model in the atmospheric boundary layer which the tunnel simulates, applied the dynamic pressure measure technology on the building ’ s surface to get the mean and fluctuating wind pressure coefficient, drew out the contour of pressure coefficient and analyzed its distributing law and characteristic
本文以金奧大廈及其鄰近建築作為研究對象，首先把一定縮尺比的模型置於風洞模擬的大氣邊界層環境中，運用建築表面動態測壓技術獲得金奧大廈表面的時均風壓系數和均方根風壓系數，繪制時均風壓系數和均方根等值雲圖並分析其分佈的規律和特點。 -
In this paper i was in virtue of the fluent software, set up the geometrical model of jin ’ ao mansion and adjacent buildings, used non - equilibrium wall functions to deal with the problem which come from the near wall, used realizable k - turbulent model to simulate the steady flow around 3d high - rise buildings, we can get the distribution of mean wind pressure coefficient of the surface of jin ’ ao mansion and five aerodynamics components. they were compared with the data from the wind tunnel test, we found out the distance between the result of the wind tunnel test and numerical simulation in the acceptable range
本文以fluent軟體為平臺，建立金奧大廈及其周邊建築的計算幾何模型，近壁區採用非平衡壁面函數法處理，運用基於雷諾時均的realizablek -湍流模型進行高層建築三維定常風場數值模擬，獲得金奧大廈表面時均風壓系數分佈及基底五分量氣動力，並和風洞測壓試驗的結果及風壓系數積分計算的基底五分量氣動力相比較，發現兩者之間的差異在可接受的范圍之內。 -
Designed a program which can use the mean pressure coefficient of jin ’ ao mansion to calculate mean wind load of the whole buildings and local floor. the integral result can apply into the practical design of construction, also can compare with the results of wind tunnel balance test to validate the veracity of this test
通過自編的程序對金奧大廈表面時均風壓系數進行積分計算獲得其整體和局部樓層的平均風荷載，積分計算的結果一方面可以方便地運用於實際的建築結構設計中，另一方面可以與風洞天平測力結果進行比較驗證動態測壓試驗的正確性。 -
An experimental study on the aerodynamic characteristics of new concept car is conducted by model wind tunnel test, covering the pressure coefficient and wake vortices on longitudinal symmetry plane, as well as aerodynamic forces and moments under different yaw angles
摘要用模型風洞對新概念車在不同橫擺角下縱對稱面上壓力系數、整車氣動力和氣動力矩的變化以及縱對稱面尾部流態分佈進行了試驗研究。
分享友人