working gas 中文意思是什麼
working gas
解釋
工作氣體-
Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing
文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力 -
The research status of the world diesel exhaust aftertreatment technology is summarized systemicallyo at the same time, the development status and problems about oxygenation catalysis converter and particulate filter are analyzed on the basis of mentioned informations, we bring up a diesel exhaust cleanse system, that adopts the technique course of catalysis conversion combining particulate collection and regeneration the system collects exhaust particulate by means of efficacious filtering material it can oxidize ho co and macromolecule solvable organic via catalyst and diesel oil additive enhanced temperature will partly oxidize collected particulate and ultimately achieve the aim of exhaust reduction, after processing system frame design and trial matching, it ' s detected that the system can surely cleanse gas exhaust and particulate in addition, gas - ejected combustion - supporting regeneration for diesel particulate filter is also researched, we have rudimentarily designed the software and hardware of the g as - ejected combustion - supporting system having processed a series of trials, we discover the rules of the system credibly working these rules demonstrate the right direction for researching gas - ejected combustion - supporting regeneration technology
本文系統地介紹了國內外柴油機排氣后處理技術的研究現狀，分析了氧化催化轉化器和微粒捕集器的發展現狀及存在的問題，以此為基礎，提出了一種柴油機排氣凈化系統，該系統採用催化轉化與微粒捕集及再生相結合的技術路線，通過過濾材料的有效過濾，將排氣中的微粒進行收集，藉助于催化劑和柴油添加劑使排氣中hc 、 co及高分子可溶性有機物氧化，產生的高溫使得收集到的微粒部分氧化，從而達到降低排放的效果。通過系統結構設計和試驗匹配，實現了對氣體排放物和微粒的凈化。同時，論文中還進行了柴油機微粒捕集器噴氣助燃再生的研究，初步設計了噴氣助燃系統，進行了控制系統軟、硬體的開發，通過正交試驗，摸索出了噴氣助燃系統可靠工作的一般規律，為噴氣助燃再生技術的開發提供了方向。 -
A bulb at the connector end provides a reservoir of filling gas which is necessary to give a reasonable working life.
在連接體的末端有一個小球，用以貯存所充的氣體，其目的是為了使計數器具有適當的工作壽命。 -
This paper described that the working theory and characteristics by high frequency argon discharge gas chromatograph, application of analysis cum in high purity argon product
摘要本文敘述了高頻氬放電離子氣相色譜的工作原理、特點；以及在高純氬氣產品分析中的應用。 -
Methane drainage experimental research for the stress - relief roof stratum of working face of high gas coal seam
高瓦斯綜采面頂板覆巖卸壓抽放瓦斯試驗研究 -
Probing into comprehensive gas control technique in high gassy working face
高瓦斯工作面瓦斯綜合治理技術探討 -
If we can find a way to artificially enhance the adsorption of activated carbon, its benefits on economy and environment will be considerable. it is the aim of this work to investigate electrosorption of chloroform in water on granular activated carbon. the potentials on working electrode are controlled by potentiostat and the concentration of chloroform is measured by headspace gas chromatography
實驗用恆電位儀作控制電源，調節工作電極電位（相對于參比電極電位）來控制加在活性炭上的電場，用頂空進樣法測定水中氯仿的剩餘濃度，參照方法與依據都是國家標準方法或國外先進方法。 -
The dongyuan salt well was listed september 1985 as cultural relic of zigong city and now is a producing and working place of the low pressure gas workshop of jiuda salt group
東源井於1985年9月被列為自貢市文物保護單位，現在久大鹽業集團低壓氣車間生產作業地。 -
During the process of measuring compression ratio, the viscous fluid instead of burning gas is applied to measure the maximal volume. residual volume and working volume of the engine combustion cylinder respectively
在壓縮比測量裝置中，採用粘性液體，代替發動機工作燃氣，分別測量出發動機燃燒工作室的最大容積、余隙容積和工作容積，方便地計算出發動機的壓縮比。 -
Target material was hexagonal boron nitride ( hbn ) and working gas was pure argon
用射頻濺射法在si襯底上制備立方氮化硼，靶材為hbn ， 。工作氣體為氬氣。 -
Boron nitride ( bn ) thin films were deposited on si substrates using the conventional radio - frequency ( rf ) sputtering system, with hexagonal boron nitride ( hbn ) target and working gas of argon ( or mixture of nitrogen and argon )
使用射頻濺射（ rf ）系統，靶材為燒結的六角氮化硼（ hbn ） ，工作氣體為氬氣（或氬氣和氮氣的混合氣） ，在硅襯底上沉積氮化硼薄膜。 -
1 successively depositing cbn thin films on si substrates which reaches international advanced level, the impact of negative substrate bias voltage and rf powers on the formation of cbn thin films were studied. boron nitride ( bn ) films were deposited on ( 100 ) - oriented p - type silicon substrate ( 8i sqcm ) with rf sputtering system. the target was hexagonal boron nitride ( hbn ) of 4n purity, and the working gas was the mixture of nitrogen and argon
研究了襯底負偏壓和射頻功率對制備立方氮化硼薄膜的影響立方氮化硼薄膜沉積在p型si （ 100 ） （ 8 15 cm ）襯底上，靶材為h - bn靶（純度達99 . 99 ） ，濺射氣體為氬氣和氮氣混合而成，制樣過程中，襯底加直流負偏壓。 -
Process parameters included rf power, substrate negative bias voltage, substrate temperature and working gas pressure
工藝參數有射頻功率、襯底負偏壓、襯底溫度和工作氣壓等。 -
The influence of various factors, such as substrate bias voltage and temperature, working gas pressure, types of si wafer, etc. on the preparation of cbn has been studied systematically
系統地研究了襯底偏壓、襯底溫度、工作氣壓、 si晶片的類型等多種因素對制備cbn薄膜的影響。 -
With the helium as the working gas, we attained 119. 7k the refrigeration temperature of the pulse tube. this is the first time that it enters the cryogenic field using the thermocaoustic engine in china. 2 ) the application of binary noble gas on tadptr after the discuss of the possibility of applying binary noble gas on tadptr, we give the way to calculate the prandtl number of the binary noble gas
混合工質應用於熱聲驅動的脈管製冷機對惰性氣體二元混合工質在熱聲機械中的可能應用進行了探討，給出了混合工質的普朗特數等參數的計算方法，並進行了採用氦-氬混合工質的熱聲驅動脈管製冷機的實驗研究。 -
It is concluded that for cvd method the cubic phase content and adhesion are highly effected by the crystal lattice mismatch between c - bn and substrate materials, however, for sputter method the crystal lattice mismatch between c - bn and substrate materials affects the quality of c - bn thin films very little. 5 n - type doping of bn thin films and preparing of bn ( n - type ) / si ( p - type ) heterojunctions adding s into the mixture of argon and nitrogen used as working gas, we sputtered 1ibn target to deposit bn thin films so as to study the n - type doping of bn thin films, and bn ( n - type ) / si ( p - type ) heterojunctions were prepared
5實現了氮化硼薄膜的n型摻雜，成功制備出bn型）乃…型）異質結並且首次系統研究了其卜v和cv特性我們用射頻濺射法濺射六角氨化硼靶，在工作氣體氮和氮中混入s ，沉積氮化硼薄膜，以研究氮化硼薄膜的n型摻雜，並得到bnh型）侶i …型）異質結。 -
We have a working gas station, movie theater
我們有加油站，電影院 -
While working gas was switched from ar in the first and second steps to ar + n2 in the third one
由第二步到第三步，工作氣體由氬氣變為氬氣和氮氣的混合氣體。 -
The nitrogen atoms involving in the chemical reaction originated from the working gas and nitrogen gas in the reactive chamber, and the latter is chief
噴塗過程中參與反應的n元素來自離子氣和反應室中的n _ 2氣，以後者為主。 -
The results of the experiments using the helium - argon as the working gas have showed that the performance of the tadptr can be improved if we add some argon in the pure helium
實驗結果表明在氦氣中加入適量的氬氣可以提高熱聲驅動器的性能，從而提高其驅動的脈管製冷性能。
分享友人