working section length 中文意思是什麼
working section length
解釋
試驗段長度-
Finally, the two dimensional flow in the diffuser is calculated, the results show that the change of ma makes an effect to the performance of the diffuser. owing to the accretion of ma, the action of oblique shock waves and the boundary layer pricks up, the flow separates from the wall where the shock waves impinge on the boundary layer more quickly, the cluster of diamond shock waves becomes larger. moreover, by comparing the change of flow field under different structure parameter, it is found that the augment of length of constant area section alter the structure of fluid field little, a smaller area ratio and larger angle of compression section make the diffuser working better
最後，針對擴壓器中的二維流場進行了數值模擬，結果表明馬赫數對擴壓器性能影響較大，隨著馬赫數的增大，擴壓器管道內激波-附面層干擾加劇，流動從附面層分離相應加劇，激波串數目增多;通過比較不同結構參數下的擴壓器內流場，發現等直段長度的變化幾乎沒有改變流場結構，只是對局部流場稍有影響，並且在其它參數不變的情況下，一定范圍內減小面積比a2 / a1和增大收縮角有利於擴壓器性能的提高。 -
The distance from figure center of the parabola to the potential slide surface is less than half of the section length. mechanical conditions of this method include not only force equilibrium but also moment equilibrium. as for the beam - on - foundation, its pressure can be calculated by homogeneous hypothesis or winkler foundation hypothesis or infinite half elastic foundation hypothesis on the pulling anchor - cable step and by coulomb active earth pressure theory approximatively on the long term working step
對于樁在滑面以上段所受的坡體荷載，提出可按形心偏下的拋物線型分佈模式計算，並在滿足力的平衡條件的同時還滿足力矩平衡條件；對于地樑上作用的坡體荷載，提出在錨索張拉階段可按均布或溫克爾（ winkler ）地基假定或彈性半無限體地基假定來計算，在工作階段則一般可以近似按庫侖主動土壓力理論計算。 -
Under the same working pressure and flow rate, the flow passage length and cross - section area of the seven different emitters were compared. according to those results, the anti - clogging ability of emitters was analyzed and several good structural form of flow passage were obtained. in addition, regression model describing the relationship among flow rate, the length of flow passage and work pressure was set up
比較了不同結構形式滴頭的流態指數和相同工作壓力和流量下的流道長度與流道截面積，分析了其抗堵塞性能，得出了較佳的幾種流道結構，並建立了描述滴頭流量與工作壓力及流道長度之間關系的函數模型。
分享友人