xerogel 中文意思是什麼

xerogel 解釋
干凝膠
  1. Two kinds of n - substituted pyrrole ( trimethyl - ( 2 - pyrrol - l - yl - ethyl ) - ammonium iodide and 2 - ( 2 - pyrrol - 1 - yl - ethoxy ) - ethane - sulfonate sodium ) were synt hesized ; poly ( trimethyl - ( 2 - pyrrol - l - yl - ethyl ) - ammonium iodide ) / v2os nanocomposites were synthesized by two methods ( monomer in - situ intercalate polymerization and polymer intercalation in solvent ). to fabricate vaos sol by melt quenching, oxygen top - blend technique was applied to improve oxygenic part - pressure, decrease the oxygenic anoxic and restrain the increase of v4 + ion when vos was melted. the xos xerogel prepared by the new technique had more complete structure than the vos xerogel which v20s powder was melted in the air

    針對以v _ 2o _ 5為原料、熔融淬冷法合成v _ 2o _ 5溶膠、制備v _ 2o _ 5干凝膠薄膜這一方法，提出了在v _ 2o _ 5熔融時運用氧氣頂吹工藝這一思路，目的是增加熔體表面的氧分壓，減少熔體的氧缺損，使v _ 2o _ 5干凝膠的v ~ （ 5 + ）離子含量更高、其結構更完整、性能更穩定。
  2. The stretching vibration of v = o shifts to lower wavenumbers, which is contributed to the oet v : = o bonding interaction. the intercalation of peo effectively shields the electrostatic interaction between li + ions and v2o5 layers, resulting in the improvement of the cycling reversibility and stability of li + ions insertion / extraction in the interlayer of v2o5 xerogel and the improvement of electrochromic behavior of the films

    通過電學、電化學和光學性能測試結果表明: peo的嵌入，有效屏蔽了vzos層對li十離子的靜電作用及peo與li十離子之間產生的絡合作用，大大提高了li +離子在氧化物層間的嵌入容量、嵌入/脫出可逆性和穩定性，有效提高了薄膜的電致變色性能尤其是在近紫外區的陰極電致變色性能。
  3. The major results were listed below : the forming processing of xos xerogel was studied. the results showed that it is useful to apply the oxygen top - blend technique to the fabrication of vaos xerogel by melt quenching

    研究了氧氣頂吹對v _ 2o _ 5干凝膠形成過程的影響，結果表明：氧氣頂吹工藝運用於熔融淬冷法制備v _ 2o _ 5干凝膠是可行的。
  4. The sem micrographs of xerogel thin films show that the surface of the films is homogeneous, no cracks and holes are observed and it has a fiber - like microstructure

    Sem觀察表明v _ 2o _ 5 - moo _ 3干凝膠薄膜是一種纖維狀顯微結構，且納米復合薄膜表面均勻，無裂紋和孔洞。
  5. The synthesis of water - soluble pyrrole and poly ( trimethyl - ( 2 - pyrrol - l - yl - ethyl ) - ammonium iodide ) / vios nanocomposite was studied systemically. the vos xerogel was prepared by melt quenching method and the fabrication method was improved

    本論文詳細評述了聚合物層狀無機化合物納米復合材料的研究進展，介紹了有機-無機納米復合材料的特點和應用前景。
  6. The dsc curve and xrd of vo xerogel revealed that three - change process during the drying process of xos sol

    其xrd和tga圖譜顯示，在相同溫度下熱處理，樣品a在001面有序化程度比樣品b低。
  7. The peo - v2o5 - moo3 xerogel thin films show the excellent cycling reversibility and stability of li + ions insertion / extraction in the interlayer of v2o5 - moo3 xerogel

    另一方面， peo的嵌入也導致薄膜結構上的重組，提高了復合薄膜的嵌理量。
  8. The surface structure of sample a would be more regulate and complete than sample b after annealing. tga was applied to analyze the weight loss process of vio xerogel

    Sem譜顯示樣品a比樣摘要品b表面光滑，經熱處理后，樣品a比樣品b的層狀結構更整齊、完整。
  9. Peo can be completely intercalated into the interlayer of v2o5 xerogel in form of amorphous state at x = 0. 5, whereas partial peo can not be intercalated into v2os xerogel interlayer and exists outside of v2o5 xerogel interlayer in form of crystalline state at x = l, 2

    當x為0 . 5時， peo的嵌入較完全，在層間以非晶態形式存在；當x = 1 、 2時，部分peo未能嵌入氧化物干凝膠層間而存在於其主體之外，以晶態形式存在。
  10. Peo can be completely intercalated into the interlayer of v2o5 - moo3 xerogel in form of amorphous state at x 1, whereas partial peo can not be intercalated into v2o5 - moo3 xerogel interlayer and exists outside of v2o5 - moo3 xerogel interlayer in form of crystalline state at x = 2

    當x約為1時， peo的嵌入較完全，在層間以非晶態形式存在；當x = 2時，部分peo未能嵌入氧化物干凝膠層間而存在於其主體之外，以晶態形式存在。
  11. The xps analyses show that there were two different chemical conditions of li + ions when li + ions were inserted into v2o5 - moo3 xerogel, corresponding to the li + ions in the interlayer and interstitial positions ( localized by the layers ) of v2o5 - moo3 lattice, respectively

    當peo嵌入后，層間li ~ +離子含量大大增多， li ~ +離子以層間li ~ +離子（非水化）為主要存在形式，並且peo的嵌入削弱了li ~ +離子與周圍環境的相互作用。
  12. During the temperature of 360410, the weight lose was aboutl. 8 % of both sample a and sample b. the calculating result of n ( water molecular number ) was n = 1. 59 ( sample a ), n = 1. 79 ( sample b ) respectively. li + ion storage properties in xos xerogel films were related to the content of v5 + ion and the situation number that li + ion were capable to hold

    干凝膠的離子儲存能力受到薄膜中vk離子的含量和理離子可占據的總位置數限制，熱處理溫度對理離子的儲存性有一定的影響：低溫時，由於凝膠薄膜中層間水的脫出，有利於注理量的提高；高溫時，有v坍離子產生，不利於注理量的提高。
  13. ( 1 ) carbon aerogel and xerogel were made from resorcinol - formaldehyde organic gels and used as the anode materials for lithium ion batteries. by discussing the influences of pyrolysis temperature, the level of the catalyst and the concentration of reactant in the preparation of carbon materials on their behavior of lithium ion storage, their performance of storing lithium ions and process of charge and discharge were studied in details. moreover, the relationship between the structure of carbon aerogel and xerogel and the performance of storing lithium ions was analysed, and the mechanism of the storage of lithium ions in this type of porous carbon materials based on organic gels was also dicussed simply

    （ 1 ）從合成間苯二酚-甲醛有機凝膠出發，制備了碳干凝膠和氣凝膠，研究了其作為鋰離子電池碳陽極材料的儲鋰性能，探討了碳材料制備過程中的熱分解溫度、催化劑用量、反應物含量等條件對碳干凝膠和氣凝膠儲鋰行為的影響，並分析了碳材料結構與儲鋰性能的關系以及充放電過程，也簡單探討了鋰離子在這類基於有機凝膠的多孔碳材料中的存儲機制。
分享友人
分享到 Line

分享到臉書