介質電導 的英文怎麼說

中文拼音 [jièzhídiàndǎo]
介質電導 英文
diectric conductance
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  1. Based on the effective medium hb resistivity models in laminated or dispersed shaly sands proposed by berg, the general effective medium hb resistivity model in laminated and dispersed shaly sands is established. in the derivation of the model we assume that clay - bound water fraction is included in total pores, clay - bound water and formation water have the same resistivity, and yet the difference of electrical properties between the two waters is incorporated into clay grain conductivity

    本文首先基於berg提出的層狀泥質或分散泥質砂巖有效介質hb電阻率模型，並在總孔隙中考慮粘土結合水的體積，但不考慮粘土結合水與地層水導電性的差別，而將粘土結合水與地層水的導電性差別歸結到粘土顆粒導電中，建立了混合泥質砂巖有效介質通用hb電阻率模型。
  2. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  3. Microwave absorption of cb abs continuous conductivity medium

    連續導電介質吸波性能研究
  4. Introduction cl21s are non - inductively wound with meatllized polyester film stacked as the dielectric electrode with copper - clad steel leads and epoxy resin coating

    Cl21s為無感結構，用金屬化聚酯膜作電介質電極繞制而成，導線採用鍍錫銅包鋼線，使用環氧樹脂包封。
  5. Meb are non - inductively wound with metallized polyester dielectric / eletrode and copper - clad steel leads encapsulated in a plastic case sealed with epoxy resin. they are suitable for filtering, by - pass, coupling decoupling and timing circuits with applications in telecommunications, data processing, industrial instruments and automatic control system equipments

    Meb為非感應式，用鍍金屬聚酯電介質/電極繞制而成，導線採用鍍錫銅包線，用環氧樹脂密封在一塑料套內，本品適合於耦合、濾波、和計時電路中，廣泛御用於遠程通訊、數據處理、工業儀表和自動控制系統的設備中。
  6. Mef are non - indluctively wound with metallized polyester film as the dielectric / electrode with copper - clad steel leads and epoxy resin coating they are suitable for blocking, copling decoupling filtering, by - pass and timing circuits, they find application in telecommunication, date processing, industrial instruments. and automatic control system epuipments

    Mef為非感應式，用鍍金屬聚酯薄膜作為電介質/電極，導線採用鍍錫銅包線和環氧樹脂包封.本品適合於耦合、濾波、整流和計時電路中，在遠程通訊、數據處理、工業儀表和自動控制系統的設備中得到了運用。
  7. Are non - inductively wound with metallized polyester film as dielectric / electrode with copper - clad steel leads and encapsulated in a plastec case sealed with epoxy resin

    為無感結構，用金屬化聚酯薄膜作為電介質/電極繞制而成，導線採用鍍錫銅包銅線，使用環氧樹脂密封在塑料殼內。
  8. Are non - inductively wound with metallized polyester film as the dielectric / electrode with copper - clad steel leads and encapsulated in a plastic case sealed with expoxy resin

    為無感結構，用金屬化聚酯膜作電介質/電極繞制而成，導線採用鍍錫銅包銅線，使用環氧樹脂密封在塑料殼內。
  9. Based the basic principle of the accumulation of induced electric charges across the resistivity discontinuities and the induction current channeling inside the conductive bodies inspirited by the mt field, we set up the relation between the measured field on the earth surface and the distribution of the induced source underground by means of the defining the electric charge occurrence probability function and the electric dipole occurrence probability function and the spacial distributing of the " correlation probability ". the " image " of the field sources underground, or the distributing graphy of the induced electric charges and the induced current in the mesuring area can be drawed, from which we can get the outline of the geological anomaly on the meaning of the probability

    大地電磁場概率成像方法是一種新的地球物理成像反演方法，它是根據在大電磁波場的激勵下，地下介質電阻率間斷處產生感應電荷積累和導體內部產生感應電流，從而產生感應電磁場的原理，相應地定義了感應電荷發生概率函數和感應電偶極子發生概率函數，通過「相關概率」發生的大小的空間分佈，建立了地表觀測場與地下場源空間分佈的內在聯系。地下場源分佈概率的「像」 ，即測區的感應電荷和感應電流的概率的分布圖像，就是測區內地質體在概率意義下地質異常體的分佈輪廓。
  10. Introduction cl21x are non - inductively wound with metallized polyester film as the dielectric electrode with copper - clad steel leads and epoxy resin coating

    Cl21x為無感結構，用金屬化聚酯膜作電介質電極繞制而成，導線採用鍍錫銅包鋼線，使用環氧樹脂包封。
  11. X1 - mex are non - inductively wound with metallized polypropylene film as the dielectric electrode with copper - clad steel leads and encapsulated in a plastic case sealed with epoxy resin

    X1 - mex為無感結構，用金屬化聚丙烯膜作為電介質電極繞制而成，導線採用鍍錫銅包鋼線，使用環氧樹脂密封在塑料殼內。
  12. Cbb61 are non - inductively wound with metallized polypropylene film as the dielectrice electrode with ul leads and encapsulated in plastic case sealed with epoxy resin

    Cbb61為無感結構，用金屬化聚丙稀膜作為電介質電極繞制而成，用「 ul 」導線引出，使用環氧樹脂密封在塑料殼中。
  13. Are non - inductyvely wound with metallized polyester film as the dielectric / electrode with copper - clad steel leads and encapsulated in a plastec case sealed with epoxy resin

    為無感結構，用金屬化聚丙烯薄膜作電介質/電極繞制而成，導線採用鍍錫銅包銅線，使用環氧樹脂密封在塑料殼內。
  14. Cbb60 are non - inductively wound with metallized polypropylene film as the dielectric electrode with " ul " leades and encapsulated in a plastic case sealed with epoxy resin

    Cbb60為無感結構，用金屬化聚丙稀膜作為電介質電極繞制而成，用「 ul 」導線引出，使用環氧樹脂密封在塑料殼中。
  15. Are non - inductively wound with metallized polypropylene film as the dielectric / electrode with copper - clad steel leads and encapsulated in a plastic case sealed with expoxy resin

    為無感結構，用金屬化聚丙烯作電介質/電極繞制而成，導線採用鍍錫銅包銅線，使用環氧樹脂密封在塑料殼內。
  16. Cbb65 are non - inductively wound with metallized polypropylene film as the dielectric electrode with ul leades and encapsulated in a plastic case sealed with epoxy resin

    Cbb65為無感結構，用金屬化聚丙稀安全膜作為電介質電極繞制而成，用「 ul 」導線引出，使用環氧樹脂密封在塑料殼中。
  17. Introduction cl20 are non - inductively wound with metallized polyester film as the dielectric electrode and copper - clsd steel leads and outer wrapping of polyester end sealed with epoxy resin

    Cl20為無感結構，用金屬化聚酯膜作電介質電極繞制而成，導線採用鍍錫銅包鋼線，使用環氧樹脂密封。
  18. Are non - inductivel wound with me - tallized polyester film as dielectric / electrode and copper - clsd steel leads or flexible cord and outer wrappojing of polyester end sealed with epoxy resin

    為無感結構，用金屬化聚丙烯薄膜作為電介質/電極繞制而成，導結採用鍍錫銅包鋼線（或軟線） ，外層用聚酯膠帶包裹，兩端用環氧樹脂密封。
  19. 1. the differences of charging mechanism between fuel and conductive polar medium are analyzed on the basis of comparing conductivity, polarization and electrification

    1 、通過介質電導性、極化與帶電機理的對比，理論上分析了燃料與極性導電介質在荷電機理上的差別。
  20. Meanwhile, the soft - field characteristics of ert systems in different numbers of electrodes are studied, and the main soft - field characteristics of ert systems are found. the results show that the soft - field characteristics are greatly reflected in the influence of distribution of mediums and the difference in conductivity of two - phase mediums on the distributions of the sensitivity field

    最後研究了當電極數目不同時對ert軟場特性的影響，得出了ert傳感器軟場特性的規律： ert傳感器的「軟場」特性主要體現在其靈敏場的分佈受被測介質的分佈及兩相介質電導率差值的影響。
分享友人
分享到 Line

分享到臉書