內阻力 的英文怎麼說

中文拼音 [nèi]
內阻力 英文
internal resistance
  • : 名詞1. (內部; 里頭; 里邊) inner; inside; within 2. (妻子或妻子的親屬) one's wife or her relatives 3. (姓氏) a surname
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  • 阻力 : 1 (阻礙事物發展的外力) obstruction; resistance 2 [物理學] resistance; drag; drag force; nowel; ...
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法,在不考慮燃燒的冷態情況下,研究了熱風爐燃燒室的氣流分佈規律.在此基礎上,比較了2種不同設計方案的氣流流動特徵,尤其是研究了燃燒器空氣通道流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明,流板的設計對加強空氣和煤氣的混合有著極為重要的作用,同時也增加了空氣管道的損失,在同樣的工況條件下需要提高管道系統的總壓
  2. The article also analyzing the resistance comes from enterprise and indicate that building effective salary system and payment of house loan interest is feasible, give priority to interior training, assisting with exterior training, while providing promote chunnel for technical personnel should be deferred

    文章還分析了企業現狀對激勵機制實施的,指出建立有效的薪酬制度和住房貸款利息給付計劃是可行的,可以實施以部培訓為主、外部培訓為輔的培訓手段,員工職業發展的多跑道政策須暫緩實施。
  3. The influence of inflow velocity, the baffle body height and the clapboard position on the flow velocity, flow equilibrium between the two sides of the clapboard, particle distribution, rich / lean concentration ratio and flow resistance characteristic are studied numerically

    文章研究了來流速度,撞擊塊高度、隔板位置等因素對氣相速度場、隔板兩側配風均勻性、顆粒濃度、濃淡分離比和燃燒器內阻力特性的影響。
  4. This article offers a method for solving the frictional drag, that is, according to the various buckled shapes of coiled tubing in different hole sections, working out the mean contact counterforce in a screw pitch in solving the radial contact counterforce

    求解摩時,可針對連續油管在井身中不同結構段的不同變形形狀,採用求解徑向接觸反時求一個螺距平均接觸反的方法加以解決。
  5. The pressure drop of the compound tray can be regarded as consisting of dry plate pressure drop, clear liquid resistance, liquid surface tension resistance, and packing pressure drop. the model that has established can fairly predict the pressure drop of the compound tray, the value calculated by the model compared with that detected by experiment is less than 20 %

    復合塔板的壓降可認為由干板壓降、清液層、填料層壓降和克服液體表面張的壓降四部分組成,所建立的壓降計算模型,能較好地預測復合塔板的壓降,計算值與實驗值誤差在20以,可用於工程設計。
  6. Some researchers have made study on this subject, such as the generation and evolution of frazil ice, shore ice, bottom ice, ice cover and ice jam, the resistance of freeze - up river, flow capacity and variation of water stage

    外一些學者通過原型觀測,試驗和數值模擬的方法對水冰,岸冰,底冰,冰蓋和冰塞的生成和演變,封凍河道的、過流能和水位變化等有關問題進行了研究。
  7. Study on distribution and diffusion regularity of frictional resistance in the inter face of grouted body of anchor cable

    錨索錨固段摩分佈及擴散規律研究
  8. As there is lost motion in every kind of machinery, so there is lost motion in the grain market due to momentum, which drives an option slightly above or below a resistance level

    每種機器都有空轉的情況,因此穀物市場當然也由於其運行在一個水平上下很小的范圍的動而變成空轉。
  9. The aerodynamic characteristics of a projectile with wrap around fins are studied systematically in this paper, as follows : 1. the lift coefficients 、 drag force coefficients 、 pitch moment coefficients 、 pitch damping moment derivatives and roll damping moment derivatives are obtained from engineering calculation through looking wrap around fins as flat fins of the same projection aera

    本文對某卷弧尾翼彈氣動特性進行了系統研究,主要容與結論為: 1 .將卷弧翼按照相同投影面積的平板翼進行工程估算,得到升系數、系數、俯仰矩系數、俯仰尼導數、滾轉尼導數曲線。
  10. Results show when velocity of flow remains unchanged in the onflow area and openness of the tube is changed, then resistance coefficient changes obviously

    實驗結果表明:在湍流區域流速(量)不變時,改變管件開度,系數變化較顯著;改變流量,管件開度不變時,變化不大。
  11. Study of internal force of ring tunnel in stratum skin friction

    土層摩對圓形隧道的結構分析研究
  12. Study on packing body supporting resistance of enter - in packing for in - situ gob - side entry retaining in fully - mechanized top - coal caving mining face

    綜放巷充填原位沿空留巷充填體支護研究
  13. The results show that the internal friction angle of rock has importance affect on the displacement of surrounding rock for deep roadway when in - situ stress and support resistance all are certain

    分析結果表明,在地應和支護一定時,巖石的摩擦角對深埋巷道圍巖位移的影響最為明顯。
  14. Bead unseating resistance test for tubeless passenger car tyres

    轎車無胎輪胎脫圈試驗方法
  15. As ammonia built up in the water gas purification system reacts with a part of condensate on the inner wall of the heat exchanger tube passes, and the salt solution formed cools down and crystallizes in the tube passes, the resistance in the shift conversion section increases exceedingly

    摘要由於水煤氣凈化系統積累的氨與部分冷凝水在換熱器管程壁反應形成的鹽溶液在管程冷卻結晶,造成變換工序異常增大。
  16. As a newly developed high - performance ship, wave piercing catamaran ( wpc ) has been applied and investigated more and more extensively. in this paper, the theoretic calculation method of wave resistance of a kind of wave piercing passenger catamaran with 500 passengers has been researched, including the ship lines optimization ; the fast speed experiment research work and the research of the relation between the principal dimensions and the resistance. the relation between the wave piercing catamaran and the ship form parameters has been further researched, and also some useful theoretic basis and practical means have been provided for its practical engineering appliance

    本文以「 500客位穿浪雙體船」為研究對象,對穿浪雙體船興波理論計算和船型優化方法進行了研究,其主要研究容如下:一、穿浪雙體船的線型優化二、穿浪雙體船快速性理論與試驗研究三、穿浪雙體船主尺度與快速性的關系通過以上容,較深入的研究了穿浪雙體船船型參數與快速性的關系,為其在實際工程中的應用提供了理論依據和解決方法。
  17. The analysis of the repeated test data shows the maximum deviation of air drag coefficient is less than 0. 88 % and the deviation of the most surface pressure data is within 1 %, it illustrates the test data is reliable

    重復試驗的數據分析表明,空氣系數數據的最大偏差小於0 . 88 ,絕大部分測壓試驗數據的偏差均在1以,這說明客車模型風洞試驗數據的精度較高。
  18. In contrast, china is benefited significantly when japan gets to be involved into ftas, which allows china to increase exports of rice, pork, poultry meat, vegetables and fruits to japan

    日本開放農業部門對中國最為有利,稻米、豬禽肉和蔬菜水果有望獲得較大的貿易贏余,但是日本勢必面臨較大的國內阻力
  19. The internal damping forces and the nonlinear elastic forces in the analytical form are deduced from the kelvin. voigt viscoelastic model. a smart method basing on the concept of period number is proposed for evaluating periodic solutions of the nonlinear system and determining the periodic. doubling bifurcation points

    ( 2 )建立了一個4dof單跨彈性轉子在非線性油膜、非線性內阻力和非線性彈性作用下的非線性動學模型,提出了求周期解的數值計算方法,以及計算周期解周期數及分岔點的演算法。
  20. It is showed by the results that, the rotor has different dynamics with respect to present results obtained by other researchers while the rotor is subjected to internal damping, nonlinear oil film forces and nonlinear elastic forces simultaneously. with increase of the rotary speed the rotor, quasi. periodic movement caused by internal damping will occur

    發現當轉子通過油膜失穩進入倍周期運動時,由於非線性內阻力作用,還會發生概周期分岔形式的二次分岔,產生約1 / 6倍工頻的低頻運動。
分享友人