合線 的英文怎麼說

中文拼音 [gěxiàn]
合線 英文
amphitene
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  1. An oes with a large capacious head, good pigmentation, wall eye or brown eyes, nice length of neck, correct angulation of the front and rear legs, good lay of shoulders, good quality and texture to the coat, nice topline, strong truncated muzzle with correct bite, compact body with enough leg under them, sound movement with good side extension and so on and so on is what makes an oes an oes !

    翻譯：一個有大容量腦子，良好色素，藍色或者棕色眼睛，美好長度的脖子，角度正確的前後腳，好的層次的肩，高質地的毛，美好的背線，強壯，短小，有適當咬合線的嘴，結構緊湊的身體，迴旋的聲音等等才是古牧的標準和特色。
  2. The meshing line of a pair of klingelnberg bevel gears

    克林貝格錐齒輪的嚙合線
  3. Furthermore, the degradation rate of the surgical suture line of chitosan must match up to the cicatrization speed of wound

    認為在制備手術縫合線之前有必要對殼聚糖進行預處理，此外縫合線降解的速度應與傷口愈合的速度相互匹配。
  4. On the basis of remote sensing technique ' s good characteristic with large - area, multi - time, multi - photograph variety, manifold abundant spectral information and high ground resolution, the fault tectonics frame, river geomorphy ( such as terrace, floodplain, shoal, etc ) and suspended load, etc. were explained after analyzed the fault tectonics, river geomorphy, characteristic in the tm image by gray bar statistics, primary component analyses, tm741 image integration, line convolve enhancement and model recognition etc. especially 9 piece of fault tectonics were explained in this thesis, in succession, the impacts of the factors severally were analyzed

    遙感技術具有大范圍、多時相、多片種、多層次、含有豐富的光譜信息及具有較高的地面解析度的特點。本文利用該技術，運用灰階統計特徵分析和主成分分析、 tm741多波段融合、線性卷積增強、模型提取等一系列遙感解譯分析方法，分析了斷裂構造、河流地貌（階地、漫灘、沙洲）及懸浮物等在tm遙感圖象上的影像特徵，解譯出了安徽南部斷裂構造格架、河流地貌和懸浮物的分佈，並新解譯出了9條近東西向的斷裂。
  5. However geological information is fully recorded in the remote sensing image, which made it possible for the choosing of this area as a dissection point to extract complex structural information of orogenic belt in west china. taking fully advantage of multi - band image richly bearing concealed geological information in combination with remote sensing analysis and structure analysis, to anatomy the supracrustal composition and structure of orogenic belt with the regional linear structures and their partitioned block and schistous geological masses as the macro - frame ( in corresponding to structure units and structure segments ) and with the rock masses, structure - rock assemblages, line - featured and belt - featured structures as well as penetrative and non - penetrative foliation ( primary stratum and trans position layering ) and folds as the texture and structure elements. the methods of how to distinguish granulite > ductile - shear zone, imposed fold, different deformed belts -

    因而，本文選擇這一地區作為我國西部地區從遙感圖像上提取造山帶復雜結構構造信息的解剖區，充分利用遙感圖像多波段反映物質屬性的特點和圖像處理提取隱含信息的優勢，採用遙感解析?構造解析相結合的研究方法，以區域線狀構造及由它劃分的塊狀、片狀地質體為宏觀骨架（對應于構造解析劃分的構造單元、構造均勻區段） ，以地質體中的巖石巖體、構造巖石組合，線狀、帶狀構造，透入性、非透入性面狀（原始層理、新生面理）和褶皺等構造作為用於解析的結構構造要素，進行造山帶表殼組成和結構構造解析研究。
  6. Line tapes for stranded aluminium conductors and acsr

    第1部分:鋁絞合線和鋼芯鋁線用線路膠帶
  7. The methods - three dimension fabric - enforced laminates, and sparse fabric - enforced laminates, layer - enforced laminates ? to enhance the interlaminar toughness of fabric - reinforced laminates were discussed in this paper. the stitching method to enhance interlaminar toughness of stitched - laminates was mainly discussed in this paper based on our research and experiment. the middle - alkali glass fabric used as enforced - material with thickness of 0. 2mm, 3 section 600 deniner kevlar yarn is used as stitching thread in this research, which improved lock stitching way and different kinds of stitching mode were adopted

    以提高層合板復合材料的層間斷裂韌性（能量釋放率）為目標，採用中堿玻璃布為增強材料，對疊層后的玻璃布，採用凱芙拉縫合線、改進的鎖型縫合方法、不同的縫合工藝進行了縫合；基體採用的是不飽和樹脂，固化劑為過氧化甲乙酮，促進劑為環烷酸鈷液；在室溫下採用真空輔助rtm （ resigntransfermolding ）成型固化方法，製作了不同縫合工藝的玻璃布增強復合材料層合板。
  8. However, in the area with strong magma mingling, there are widespread abnormal fabrics, distinguished differences in the idiomophic - textures and the peritectic reaction, poililitic texture, metasomatism among the minerals, metasomatic border, embayment, rimmed structure, abnormal plagioclase zoning, relict fabric as well as the acicular apatite are very common

    巖石的異常結構構造十分發育，礦物之間自形程度差異顯著，常見包晶反應、包含結構、交代邊、熔蝕邊、交代蠶食的港灣狀結構構造及交代縫合線、礦物鑲邊、斜長石異常環帶和礦物殘留等，多見指示巖漿混合的標志性礦物針狀磷灰石。
  9. Commercial building telecommunications cabling standard - part 2 : balanced twisted - pair cabling - addendum 3 - additional considerations for insertion loss and return loss pass fail determination

    商用建築電信電纜敷設標準.第2部分:對稱雙絞合線電纜敷設.補充件3 .插入損耗和回波損耗通過失效確定的附加考慮要素
  10. The proximity effect of synmmetrical cable employing copper clad steel as conductor

    採用銅包鋼復合線的對稱電纜鄰近效應
  11. The welding technology of francis turbine runners is optimized from the view of subsection welding and local heating by numerical simulation. the result shows that welding residual tensile stress appears in the weld and its area nearby, and peak stress appears in the dangerous area of blades after practising quondam welding technology ; welding residual tensile peak stress in the dangerous area of blades can be decreased by welding both ends earlier and then welding middle section later during subsection welding, and decreasing effect on welding residual stress of the subsection welding is related to the weld length of blade outlets and welding direction of each subsection ; decreasing effect on residual stress of the local heating is direct proportional to heating time, heating temperature, heating area, and inversely proportional to cooling area, and welding residual tensile peak stress in the dangerous area is decreasing trend earlier, and then increasing trend later with heated location increased

    本文利用數值模擬手段對轉輪的焊接工藝從分段焊和局部加熱兩個方面進行了優化，結果表明:採用普通工藝焊接時，葉片焊后殘余拉應力出現在焊縫及其附近區域，並且在葉片出水邊的熔合線附近（危險區域）出現了峰值;在採用優化的分段焊時，先焊兩端后焊中間的方法可以降低葉片危險區域的焊接殘余拉應力峰值，降低效果與葉片出水邊焊段長度、焊縫各段的焊接方向有關;局部加熱法降低轉輪危險區域殘余應力的效果主要與加熱時間、加熱溫度以及加熱面積成正比，與冷卻面積成反比，並且危險區域的殘余應力隨加熱區域的增大呈先降低后升高的趨勢。
  12. Bed - parallel stylolite

    順層縫合線
  13. Bed - normal stylolite

    立層縫合線
  14. Results the procedures of general linear model and mixed linear model to test treatment factor and time factor are provided

    結果給出了一般線性模型和混合線性模型對處理因素和時間因素進行比較的具體做法。
  15. Neither the vox or the hybrid require any adjustments

    無論是vox或是混合線路都不需要任何調試。
  16. In chapter 4, the spectral characteristics and its application in optical add - drop multiplexer ( oadm ) and in multi - channel dispersion compensator of linearly chirped moir fiber grating are studied. according to the coupled - mode theory and considering the construction features, we derive the couple - mode equations that describe the mode interaction in this kind of grating

    首先從耦合模理論出發，結合線性啁啾moir光纖光柵的結構特性，建立了分析線性啁啾moir光纖光柵的耦合模方程，通過數值求解耦合模方程，研究了線性啁啾moir光纖光柵的光譜特性和時延特性。
  17. Jacket centre back seam require re - pressing, to remove traces of seam pucker. on future production an adjustment to the sewing machine thread tension should be made

    夾克後背中心的縫合線需要重復擠壓，沿著褶子的紋線的的痕跡來擠壓。這是為以後的成品調解拉緊裁縫機穿線而做的
  18. The third section of the essay, analyzes the distributing law of passenger flow of public traffic, brings forward a new prediction method which could keep accordance to the practical distributing law of passenger flow by and large, furthermore, could meet the demand of optimizing bus dispatch system. this method based on intelligent technology breaks through the traditional way

    第三部分研究了城市公共交通線路日客流量分佈規律，提出了一種可操作性的、能在總體均值上符合線路客流客觀變化規律、可滿足以城市公共交通線路調度為目的和以此為精度要求的城市公共交通線路每日客流量預測方法。
  19. Servomotors are closed - loop devices

    伺服電動機是閉合線圈設備。
  20. Since the images of a human face lie in a complex subset of the image space that is unlikely to be modeled by a single linear subspace, we use a mixture of linear subspaces to model the distribution efface and non - face patterns. in the other words, we used fisher linear discriminator to project samples from a height dimensional image space to a lower dimensional feature space

    對于背景復雜的人臉圖象的檢測，使用單個線性線性子空間很難準確地區分出人臉和非人臉模式，因此，本文使用混合線性子空間對人臉和非人臉樣本的分佈進行建模，在利用自組織映射神經網路標識人臉和非人臉樣本的基礎上構建一個fisher人臉檢測器。
分享友人
分享到 Line

分享到臉書