喇叭形 的英文怎麼說

中文拼音 [xíng]
喇叭形 英文
tubaeform喇叭形反射器天線 horn reflector antenna; 喇叭形花朵 trumpet;喇叭形進水口 tapered inlet;喇叭形天線box horn; horn type antenna;horn feed antenna; 喇叭形揚聲器 horn loudspeaker; horn
  • : 喇同「啦」
  • 喇叭 : 1 (嗩吶) suona (a woodwind instrument)2 (管樂器) trumpet; horn 3 (揚聲器) loudspeaker; 喇...
  1. Rectangle binding post terminal rbpt10 - 2 rectangle binding post terminal

    Rbpt10 - 2長方接線端盒
  2. A valved brass wind instrument that produces a mellow tone from a long, narrow tube that is coiled in a circle before ending in a flaring bell

    一種有活瓣的銅管樂器,從漩渦且端部有口的又長又細的管子里發出圓潤的樂音。
  3. Some are flared ? that is, thicker at the rim than in the center, like a concave lens

    有些呈喇叭形即邊緣較中心厚,類似凹透鏡。
  4. ( 4 ) the tubiform petal of p. suffruticosa andr. and paeonia lactiflora pall, is a special petal which only has been occurred in the highflower of pralification flower of the above two species. the petal is similar to corolla of some family of sympetalous dicotyledon in shape, however it has a more thin base and many different lobes in form and size

    ( 4 )在對臺閣花型的研究中新發現了一種特殊的花瓣一筒狀花瓣,它具有筒狀結構,外類似於一些合瓣花類植物的花冠,但筒的基部更細,向上變粗,口部邊緣變化較大,具狀和大小各異的裂片,有的呈喇叭形,有的呈鐘,筒內壁上有時具一頂部游離的芒狀物。
  5. On the assumption that a cabin and a horn antenna were under the bottom of an airplane, fdtd method was applied to analyze the antenna patterns which are generally affected by the body of the airplane

    摘要假定飛機腹部加裝了某一狀的炮艙和矩天線,用時域有限差分法( fdtd )分析了這樣的外對天線輻射特性的影響。
  6. Secondly, in this paper, the four typical uwb antennas of tem horn antenna, log - periodic antenna, biconical antenna and helical antenna are theoretically analyzed and the uwb antenna design methods are generalized and discussed

    其次,本文對tem天線、對數周期天線、雙錐天線和螺旋天線四種典型的超寬帶天線進行了理論分析,總結並討論超寬帶天線的設計方法和手段。
  7. Analytical solution of the residual stress when the inflexion of the retaining ring is on the top

    兩炮口爆炸成強化護環拐點在上端面時殘余應力的解析解
  8. At a three-way junction the usual layout adopted is the trumpet.

    三路交叉口的布置通常採用喇叭形
  9. The research result shows that the basic conditions for tidal bore formation are the funnel - shaped hangzhou bay and sand bar rising

    研究結果表明,成涌潮的基本條件是杭州灣平面態使潮差增大和沿程沙坎的抬升。
  10. The pipe splays ( out ) at one end

    管子一端呈喇叭形
  11. A brass instrument consisting of a long cylindrical tube bent upon itself twice, ending in a bell - shaped mouth, and having a movable u - shaped slide for producing different pitches

    一種銅管樂器,由彎曲兩次的長圓筒金屬管構成,尾部有喇叭形口,有一個可滑動的u拉管,可發出不同音高的音。
  12. The horn is merely a round tube through which the air moves on its way into the engine cylinder.

    這種喇叭形管僅僅是一個圓的管子,空氣通過它進入發動機汽缸。
  13. Displays is functioned under the electromagnetic theory and can be easily effect by the magnetic field. however, please notice that most of the speaker has built - in a big magnet which can effect the functioning and level down the quality of the displays. please do not use your monitor when magnets or electronic products such as speakers operating nearby

    電腦顯示器是利用電磁原理來運作的,因此磁場干擾的隔離相當地重要,很多消費者都將放在顯示器兩側,而市面上防磁的防磁效果不一,因為後方有個相當大的磁鐵,如果過于靠近顯示器的話,就會造成干擾的情,甚至於產生著磁現象而影響畫面品質。
  14. It is found that the mesoscale mountain has significant influence on the location and intensity of the heavy rain area, and the bell - mouthed area and the riverway area of xichang are favorable to the occurrence and development of mesoscale disturbance and heavy rain

    梯度分析表明,西昌地區所處的河谷地和場區所處口小地,有利於中小尺度氣壓擾動的發生、發展和暴雨的產生,當地梯度減弱時,降水量相應減弱。
  15. Experimental study on phenomenon of high - speed railway train passing through tunnel with trumpet - shaped entrance

    高速列車通過喇叭形入口隧道的試驗研究
  16. Horn type loudspeakers

    喇叭形揚聲器
  17. Flare groove welding

    喇叭形坡口焊
  18. It has a wooden body in the middle and a metal bell at one end and a double reed at the other. the modified suona is now fitted with padded keys

    它是以一個用蘆葦制的嗩吶嘴而發音,是一種雙簧樂器,其底部用一個喇叭形的金屬制的擴音器,把聲音擴大。
  19. Metallic tube connections for fluid power and general use. part 1 : 24 degrees compression fittings

    流體動力和一般用途的金屬管連接件.第1部分: 24度喇叭形壓合接頭
  20. Metallic tube connections for fluid power and general use - part 1 : 24 compression fittings iso 8434 - 1 : 1994 ; german version en iso 8434 - 1 : 1997

    液壓傳動和通用連接件.第1部分: 24度喇叭形壓合接頭
分享友人