噴嘴位置 的英文怎麼說

中文拼音 [pēnzuǐwèizhì]
噴嘴位置 英文
nozzle location
  • 噴 : 噴動詞1. （液體等受壓力而射出） spurt; spout; gush; jet 2. （噴灑） spray; sprinkle
  • 嘴 : 名詞1. （口的通稱） mouth 2. （形狀或作用像嘴的東西） anything shaped or functioning like a mouth 3. （指說話） talk; speak
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  1. Nozzles of jacket on agitated vessels, of glass lined steel - position of nozzles

    鋼制搪玻璃攪拌容器用套管噴嘴.噴嘴位置
  2. A reasonable position of driving nozzle helps to achieve the maximum material flow that also depends on other parameters such as backpressure, properties of conveyed material and driving gas. it is observed that, an increase of convergent section angle is harmful to the pneumatic conveying system, and also influences on the mass flow rate of conveyed material, the distribution of static pressures in injector and the pressure drops of conveying pipe. in addition, within a reasonable scope of air mass rate, increasing the driving jet velocity is more advantageous than enlarging the dimension of driving nozzle

    試驗研究發現，氣體噴嘴位置對氣固噴射器的輸送能力影響最大，氣體噴嘴存在某一最佳位置，而這一最佳位置與背壓、輸送物料特性和輸送風特性相關聯；氣固噴射器的收縮角對其輸送能力、內部靜壓分佈和輸送管阻力特性均有適量影響，收縮角增大對整個輸送系統均不利；在適當的輸送風范圍內，提高氣體噴嘴出口速度比擴大氣體噴嘴尺寸更為有利，但氣體噴嘴出口速度過高會增加氣固噴射器和輸送管內的能量損耗，給輸送帶來不利的影響；系統背壓與氣固噴射器的氣體噴嘴出口速度的選取有關。
  3. Agitator vessels - part 3 : position and sizes of cover nozzles for glass lined steel agitator vessels

    攪拌容器.第3部分:搪玻璃鋼件攪拌容器頂蓋噴嘴的位置
  4. Study on properties of grinding fluid jet and nozzle position limit during quick - point grinding

    快速點磨削磨削液射流特性及噴嘴極限位置研究
  5. The law how the controlling parameters, such as the pressure before injecting, total pressure of the gas, the survey distance to exit, affect the discharge coefficient and the mean diameter of the spray is analyzed

    通過冷態試驗，分析了液體噴注壓降、氣體總壓等控制參數及測量位置對噴嘴流量系數、霧化平均直徑的影響。
分享友人
分享到 Line

分享到臉書