均勻性試驗 的英文怎麼說

中文拼音 [jūnyúnxìngshìyàn]
均勻性試驗 英文
test of homogeneity
  • : Ⅰ形容詞(均勻) equal; even Ⅱ副詞(都; 全) without exception; all
  • : Ⅰ形容詞(均勻) even Ⅱ動詞1. (使均勻) even up; divide evenly 2. (分出一部分) spare
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. The structure of air - blast pipe was improved on. an orienting object was installed based on theoretical analysis, that increase the spraying span. it has been found that both spraying span and droplets uniformity improved, by installing the orienting object. according to the results of a great number of experiments, orderliness of droplets diameter along the spraying span was researched, and rational spraying span of air - assisted sprayer was suggested

    通過噴霧機樣機的噴霧能,並提出對各項參數的優化設計方案。通過正交和對比對霧滴取樣,證明導流器的安裝不僅增加了噴幅,而且還提高了霧滴系數。根據大量的結果分析,找出了霧滴直徑在噴幅方向上所呈現的變化規律,並提出了合理的噴幅范圍。
  2. Analysis on stress uniformity of viscoelastic materials in split hopkinson bar tests

    中粘彈材料的應力分析
  3. Experimental research of the hydroelastic response of box - typed vlfs in non - uniform sea environment

    箱式超大型浮體在非海洋環境下的水彈
  4. Field evaluation of yield response of winter wheat to uniformity of sprinkler applied fertilizer

    噴灌施肥對冬小麥產量影響的田間評估
  5. Based on the pseudo - static experimental results of nine abnormal joints, the damage process of abnormal joint is divided into four stages of original crack, entire crack, ultimate state and failure, the effect of axial force ratio, stirrup ratio and height of column section on seismic behavior of abnormal joint are discussed, the conclusion that anti - shear capacity of abnormal joint are studied in entire crack state by studying the minor core of abnormal joint is made, the calculating formula for anti - shear capacity of abnormal joint is proposed with a view to asymmetry in stirrup yield

    摘要根據9個鋼筋混凝土框架異型節點件的擬靜力結果,指出異型節點受力過程分為初裂、通裂、極限和破壞4個階段;討論了軸壓比、節點核芯配箍率、柱截面高度變化對異型節點抗剪能的影響;提出應考慮節點核芯區箍筋屈服的不並在通裂狀態下以「小核芯」為分析單元來研究此類節點抗剪承載力的建議;最終給出了異型節點抗剪承載力的計算公式。
  6. Standard test method for measuring the uniformity of an absorptive electrochromic coating on a glazing surface

    拋光表面上吸收電致變色塗層測量的標準方法
  7. Contact uniformity test for photographic contact printers

    攝影用接觸式印相器的接觸均勻性試驗
  8. Uniformity test method for motor vehicle tyres

    汽車輪胎均勻性試驗方法
  9. Standard test method for conducting temperature uniformity surveys of furnaces used to heat treat steel products

    熱處理鋼產品用爐的溫度傳導測量標準方法
  10. In order to sure the homogeneity of the testing, the paper uses the way of homogeneity design and uses the theory of the uniform designs for experiments with mixtures ( udem ), restricted uniform designs for experiments with mixtures ( rudem ) and method of fitting level to optimize the testing

    為保證,通過安排水平,運用配方設計理論、有約束的配方設計理論和擬水平法進行優化。
  11. Experimental research on the airflow distribution uniformity in material layers of crossflow recirculating drier

    橫流循環式烘乾機氣流分佈研究
  12. The influence of preparing conditions on aluminum titanate composing was inquired. by analyzing element content of alumina and titania source, arranging a stoichiometric dosage, and keeping the chemical homogeneity from sol to mixed ti - al oxide precursor, a high activity powder was prepared. after calcining the precursor powder at 1250 for 2h, aluminum titanate phase is formed

    通過準確測定起始物的ti 、 al含量,嚴格化學配比,採取適當措施將微尺度上的組成從溶膠一直保持到混合鋁鈦氧化物前驅體的生成,使該粉體具有高活,將其在1250煅燒2h ,已合成出以鈦酸鋁為主晶相的產物,比文獻報道的鈦酸鋁相的最低生成溫度降低了50 。
  13. The tests of e - o applications by our flux ktp has been realized, the results showed : optical waveguides fabricated by using an ion - exchange process, which have an exchange - ion concentration depth profile and refractive - index profile, is close to a complementary error - function distribution, optical homogeneity and device thermal stability is much better. amplitude modulation switch formed by our flux ktp has the contrast ratio of 150 : 1 and insert loss is 2. 5 % at 1064 nm. high quality optical pulse with 1 ns width was cut successfully by using an e - o modulator from a laser pulse with 50 ns width, this modulator had run for three years, and the crystal did n ' t blackened, it showed our low conductivity flux ktp can endure high modulation voltage for a very long time

    Ktp晶體的電光應用表明:用離子交換法製作的電光波導,其離子交換濃度、折射率變化符合餘弦誤差函數,光學以及器件的溫度穩定較好;製作的強度調制電光開關,消光比為150 : 1 ,對1064nm激光的插入損耗為2 . 5 ;製作的電光調制器用於激光脈沖整形,從脈沖寬度50ns的激光脈沖削出脈寬1ns的高質量光脈沖,該電光開關經過長達三年多的使用,沒有出現晶體變黑現象,說明本實的低電導率ktp晶體能夠耐受長時間的調制電壓。
  14. Test methods for communication cable - impedance and impedance irregularities test of coaxial pair - pulse method

    通信電纜方法同軸對端阻抗及內部阻抗不均勻性試驗脈沖法
  15. Study on the experimental programme for testing of homogeneity of disk form crm for aes analysis

    光譜分析用塊狀標準物質方案研究
  16. Household sewing machines. test on irregularity in stitch length

    家用縫紉機.針跡長度不均勻性試驗
  17. Test relating to pavements. transversal eveness tests. part 2 : continuous dynamic measurement of the profile section by materialisation of the intersection of a plane and the pavement surface

    路面.橫向均勻性試驗.第2部分:平面和路面交截面的連續動態測量
  18. At first, it describes structure of the full - length prototype, manufacturing craft and prepare to work, including sting, sealing, wire tension and leak current measurement, mounting of the preamp, gas system, high voltage system, reduction of noise and so on. the construction of full - length prototype provided valuable experience and important reference to the besiii drift chamber. then good function of the full - length prototype was performed using 55fe 5. 9kev x _ ray source. we can see that the uniformity of gas gain of the full - length prototype is well and it is effective for the compensation voltage to adjust the uniformity of gas gain of the boundary cells

    為了初步測模型的能用55fe5 . 9kevx射線進行了氣體增益的檢測,隨之用55fe5 . 5kevx射線初步測了模型能,對部分高壓和補償電壓的設置進行了調整,證了對邊界場絲層加補償電壓能夠有效地調節邊緣層氣體增益的,實結果表明全長模型能正常工作並具有良好的能。
  19. Test procedures for automobile tire uniformity

    汽車胎均勻性試驗方法
  20. Cylinder variation test

    各缸工作均勻性試驗
分享友人