均勻束 的英文怎麼說

中文拼音 [jūnyúnshù]
均勻束 英文
homogeneous beam
  • 均 : Ⅰ形容詞（均勻） equal; even Ⅱ副詞（都; 全） without exception; all
  • 勻 : Ⅰ形容詞（均勻） even Ⅱ動詞1. （使均勻） even up; divide evenly 2. （分出一部分） spare
  • 束 : Ⅰ動詞1 （捆; 系） bind; tie 2 （控制; 約束）control; restrain Ⅱ量詞（用於捆在一起的東西） bundle;...
  1. Detailed numerical results for a pgsm beam passing through a bifocal lens are presented. it implies that the degree of polarization is no longer uniformly polarized in general and propagation - induced polarization changes depend on the beam parameters and system parameters, such as beam coherence parameter

    通過對雙軸透鏡系統進行的數值計算表明， pgsm光束光場的偏振不再是均勻偏振，光束的偏振特性與光束參數和光學系統參數有關，不同相關狀態下場點的偏振度不同。
  2. At last turn connected - implement with hand, to check if have the phenomenon of grinding and collide or not, if the turning become breezily and equably well then the installation over

    5安裝完畢。最後用手盤動聯軸器，檢查有無擦碰現象，轉動輕松均勻則安裝結束。
  3. We can see from the photos of the sem that the diameters of the powers of this tree land of materials obtained by the system of trion x - 100 / caprylic alcohol / cyclohexane / water are about 20 nm. by means of uv - vis, atomic absorption spectrometry and so on, nanoparticles of this three kind of anode materials are synthesized

    利用trionx - 100 /正辛醇/環己烷/水反膠束體系制備出三種物質的粉體，掃描電子顯微鏡照片顯示粒子的粒徑在20nm左右，分佈均勻；此外還利用uv - vis 、原子吸收光譜等測試手段，都表明合成出了三種正極材料的納米粒子。
  4. In the optimized structure, the electron distribution at the exit hole of the chunnel is more uniform and the electron beam is rather slim

    在該結構中，電子在通道出口處的分佈更加均勻，電子束的束徑較小。
  5. The direction which embroiders wants consistently, while rising needle should make sure central point, while embroidering to loosen to make an effort tightly and appropriately to be even, while rising needle or ending don ' t tie knot, should stay an 1cm or so line head in the noodles anticipate back press a prison mutually, noticing don ' t make the line head entwine conglobation

    一、繡出的方向要一致，起針時應確定中心點，繡時要松緊適度用力均勻，起針或結束時不要打結，應留出一厘米左右的線頭在面料背面相互壓牢，注意不要使線頭糾纏成團。
  6. It has been shown that when the partially coherent beams propagate in the atmosphere, it may be less affected by turbulence than are fully coherent ones. moreover in laser fusion a highly coherent beam is transformed into a partially coherent beam, for reducing the speckle and for getting more smooth focused spot

    例如，部分相干光在大氣中傳輸時所受大氣騷動的影響要比完全相干光小得多;並且部分相干光束具有光強比較均勻，對散斑低靈敏等優點而被應用於激光核聚變等領域。
  7. At the end of the formation, both current and potential distributions are uniform. however, their distributions on the negative plate with the expanded grid design are a little more uniform

    化成結束時電流密度和電位分佈都比較均勻，且拉網式負極板比輻射式負極板更均勻。
  8. To attain the high - power, well - proportioned and steady high - energy particle beam is the base of analyzing beam loss. the factors that influence the emission performance of the filament are analyzed, and the parameters are calculated. the experiment results proved the correctness of analyses

    獲得大功率、均勻、穩定的高能粒子束是進行束流損失分析的基礎，本文分析了影響燈絲發射特性因素，對燈絲各參數進行了設計計算，實驗證明了分析的正確性。
  9. Part 2 analyses beam landing shifts made by thermal deformations of a shadow mask and vibration of a new type of shadow mask - aperture grille. an automatic measurement system for cpt decolorization and a vibration measurement system for aperture grille are established. part 3 analyses the difference of perception and discrimination to color between the human eyes and ccd system, and develops a new method based on ccd technology to evaluate the screen white - balance

    主要內容分為三部分： （ 1 ）分析著屏電子束分佈與電子槍、偏轉系統及蔭罩之間的關系，研製自動測試裝置，為設計和改進相關結構提供依據； （ 2 ）分析蔭罩熱變形和振動對顯示屏色純度影響，建立了色純漂移自動測試裝置和張緊式蔭罩振動測試系統； （ 3 ）分析了人眼與ccd對彩色刺激的不同響應，建立了基於ccd的顯示器全屏色純均勻性測試方法。
  10. The embroidery way should be consistent and making sure the center before stitching. moreover, elasticity and potency should be moderate during embroidering. meantime don ' t tie a knot in the begining of stitching and the ending and the head of thread lefting one cm should be pressed firmly on the back of material and pay attention to avoid the sleave of the head of the thread

    繡出的方向要一致，起針時應確定中心點，繡時要松緊適度用力均勻，起針或結束時不要打結，應留出一厘米左右的線頭在面料背面相互壓牢，注意不要使線頭糾纏成團。
  11. In conclusion, a laser target shooting setup utilizing one single laser beam homogenized by isi with image relay based on the krf laser " heaven i ", laser beam diagnostics and shock - emission detection with streak camera have been established

    中國原子能科學研究院博士學位論文本工作的主要結果是:在「天光一號」一路is工均勻化krf激光的基礎上，建立了打靶手段、光束診斷手段、沖擊波測量手段。
  12. Abstract : we have studied theoretically a beat effect in a four - level system due to fifth - order optical polarization, and considered the cases that the pump beams have either narrowband or broadband linewidth. we have found that the accuracy for the energy - level splitting measurement is determined by the homogeneous linewidths of the optical transitions. that is to say, this technique can achieve doppler - free precision in the measurement of the energy level splitting between two excited states which are dipolar forbidden from the ground state

    文摘:研究了四能級系統中基於五階極化的拍頻效應，考慮了抽運光束為窄帶線寬或寬帶線寬的情形.發現其對能級分裂的測量精度決定於光學躍遷的均勻增寬.也就是說，這種技術在測量與基態是偶極禁戒躍遷的兩激發態之間的能級分裂時，可得到消除多普勒增寬的精度
  13. This thesis gives a brief account of the basic theories of software engineering and computer graphics, of the data structure of individual component modeling, of the design of the software structure and of the method of realizing software. meanwhile, this thesis put more emphasis on the exploration of the arithmetic of the delaunay triangle network, nurbs curve integration, the filling - in arithmetic of triple - tree, and the arithmetic based on the scan - line arithmetic and the filling - in of complex section

    文章介紹了關于軟體工程學與計算機圖形學的基本理論及其各組件模型的數據結構、軟體結構設計與軟體實現的技術方法，並重點討論了基於約束條件的delaunay三角網格化演算法、 nurbs （非均勻有理b樣條）曲面擬合、三叉樹等值線填充演算法和基於掃描線的復雜剖面填充演算法。
  14. The main results and academic contributions of the dissertation can be summarized as following : 1 ) for the difficulty to obtain the accurate analytical solution of the stress constraints around 3d cracks, detailed 3d fe analyses have been conducted to study the out - of - plane constraint factor tz around a straight through - thickness crack, a quarter - elliptical corner crack and a semi - elliptical crack embedded in an isotropic elastic plate subjected to uniform remote tension loading. the distributions of tz are minutely studied in the forward section of the cracks. strong 3d zones ( tz > 0 ) along the crack front were investigated despite the far field stress - free boundary conditions

    全文主要研究內容和學術貢獻如下: 1 .針對一般三維裂紋端部場應力約束準確解析的困難，對均勻拉伸載荷作用下各向同性彈性板中穿透厚度中心直裂紋、半橢圓表面裂紋和1 / 4橢圓角裂紋進行了大量詳細的全場應力三維有限元分析，首次全面分析了非穿透裂紋端部場三維影響區范圍，給出了不同形狀三維裂紋前沿離面應力約束因子tz的數值解，並結合k場平面解給出了非穿透裂紋端部應力場k - tz雙參數描述。
  15. In this paper, dual - beam transmission problem that possess to a certainty included angle and gains the nonlinear schrdinger coupled equation ( nnlse ) in self - defocusing media is discussed

    摘要自散焦介質中雙光束斜入射耦合能發生光束偏轉，通過數值模擬發現在非線性折射率不是均勻分佈時光束偏轉能降低抽運光功率並且偏轉角度不減小，在相同的功率條件下，能產生更大的偏轉。
  16. When it is discharged at high - rate, the distributions are also the most uniform at the end of the discharge. this indicates that the positive plate with the red lead has the better discharge performance than the other two kinds of positive plates

    含紅丹的正極板在化成初期電流密度和電位的分佈最均勻，極化最小，在高倍率放電結束時，其電流密度和電位分佈也最均勻，表明含紅丹的正極板的放電性能比其它兩種正極板好。
  17. For the purpose of estimating 2 - d doa of uniform circular array ( uca ), phase mode excitation based uca beamforming is employed to obtain real - valued beamspace manifold

    對均勻圓陣列（ uca ）二維波達方向估計問題，運用相位激勵模式波束形成技術，得到圓陣波束空間實值陣列流形。
  18. On the basis of theories of physics, geometrical optics and photometry, the optical properties of collimated light beam incident upon single fiber perpendicular to the fiber axis are studied. by exploring the behaviors of reflected light and transmitted light from single fiber, the distribution of the light is described and the proportionalities between the intensity of the reflected, transmitted and scatered light are obtained respectively, and the different laws governing the intensity of diffused light and transmitted light from single fiber between near and far field are discussed. experiments demonstrate that the decrease of projecting light in far field is in direct proportion for the increase of fiber diameter, which serves as the theoretical basis for a series optics equations, as well as for the designment for photoelectric deviccs for detecting fibers

    結合物理學的基本原理和幾何光學的基本規律以及光度學的基礎理論等三方面，研究了單纖維在平行均勻光束垂軸入射時的光學性質.分析了單纖維反光和透光的特徵，光強分佈及反射光、透射光和散射光的相對大小;討論了在近場和遠場條件下，漫反射光和透射光光強的不同規律;通過實驗驗證了遠場時，纖維的漫射光強度與纖維直徑成正比的關系
  19. As an example, polarization changes in vector gsm beams propagating through a telescopic system have been analyzed and illustrated by numerical results. it has been found that propagation - induced polarization changes are non - uniform across the beam cross - section. for the symmetric gaussian spectrum, the effect of the bandwidth on the polarization is barely noticeable

    以望遠鏡系統為例進行的數值分析表明，多色矢量gsm光束的偏振不再是均勻偏振，對源光譜為對稱分佈高斯型的多色矢量gsm光束，譜寬對光束偏振特性的影響不明顯。
  20. Adopt far - infrared heating technology, with low hot loss, high efficiency, high precisely for control temperature, uniform heating. compared with drying cabinet or electric stove ; it can automatical control temperature, easy to operate, drying effect is very satisfied

    採用了遠紅外輻射加熱技術，與一般烘箱及熱處理用的箱式電爐相比較，具有熱損失小、效率高、控溫精度高，加熱均勻：能自動控溫、一時結束、操作方便等優點，可達到十分滿意的烘乾效果。
分享友人
分享到 Line

分享到臉書