均勻的表面 的英文怎麼說

中文拼音 [jūnyúndebiǎomiàn]
均勻的表面 英文
uniform outer surface
  • 均 : Ⅰ形容詞（均勻） equal; even Ⅱ副詞（都; 全） without exception; all
  • 勻 : Ⅰ形容詞（均勻） even Ⅱ動詞1. （使均勻） even up; divide evenly 2. （分出一部分） spare
  • 的 : 4次方是 The fourth power of 2 is direction
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  1. Fluid circulation makes the calory and drugs distribution uniformly over the surface of the belly and pelvic cavity

    3 .加熱循環可使藥物和熱量均勻的分佈於腹腔和盆腔表面
  2. Owing to penetration, absorption, and internal lubrication, the homogenizing - dispersing agent filled in rubber compound reduced the difference of viscosity, polarity, surface tension in dissimilar rubbers, and accelerated interfusion, dispersing, homogeneous mixing

    由於均勻分散劑的滲透、吸附及內潤滑作用，減小了不同橡膠間粘度、極性和表面張力的差別，達到了快速融合、分散、摻混均勻的效果。
  3. The major function of having precious metals coated with carriers is that it can provide with larger touchable square measure. therefore, it can provide the largest surface square measure and held - up time. equilibrium tight intensity can provide gas with good mixable degree and even step - down in order not to cause slanting flow

    將貴金屬披覆于擔體上，主要功能為提供較大的接觸面積，因此可提供最大的表面積及滯留時間，均衡的緊密度可提供氣體好的混合程度及均勻的壓降，不致造成偏流。
  4. The acquired stm images exhibit that tryptophane can form a uniform adsorption layer at room temperature. two kinds of structures were observed : two - dimensional stripe structure and two - dimensional monoclinic lattice

    實驗發現，在室溫下色氨酸分子可以在石墨表面形成均勻的吸附層，並形成二維條狀結構和二維單斜晶格兩種有序結構。
  5. The tem analysis of pa6 composites shows that optimal incorporation of nano - al2o3 into pa6 is at 10 phr of nano - al2o3, and that fillers can equably disperse in matrix

    另一方面，透射電鏡分析表明，添加量為10phr的試樣中納米a12o3粒子可以在尼龍6基體中均勻的分散。
  6. The temperature distribution on the high temperature side of an electric tunnel furnace is analysed and simulated on the basis of the principle of thermal radiation by the way of thb ( thermal heat balance ). the heated silicon carbon sticks are decomposed into innumerable tiny heating faces, which exchange the heat with the heated materials. a numerical model based on the radiation intensity law is constructed to calculate the energy absorbed by the heated materials and simulated by a computer. the results showed that the even distribution of temperature can be obtained by optimizing the arrangement of the silicon carbon sticks according to the calculation results to make the structure design more reasonable. these calculation results have been used in the practical designs and the expected objectives achieved

    利用熱輻射原理，採用熱平衡法對電熱隧道窯的高溫恆溫區溫場進行了分析和模擬.計算中將發熱棒分解為無數微元發熱面與燒結體進行熱交換，依據輻射強度定律，建立了燒結體接收能量的數學模型，並用計算機進行了模擬計算.結果表明，依據模擬結果來優化硅碳棒的排布，可使結構設計更加合理，進而可以獲得分佈均勻的恆溫區溫場.計算結果已在窯爐設計中應用，實踐效果良好
  7. Smooth tempered glass is manufactured by heating up float glass to swiftly and uniformly, with this special heat treatment and quenching process which increases glass strength up to four to five times vs, annealed glass, in case stresses beyond its capacity, smooth tempered glass simply disintegrates into innumerable small pieces, significantly reducing the risk of serious injury

    鋼化玻璃是將浮法玻璃經過物理性淬火處理，使其表面形成均勻的壓應力，而內部則形成張應力，從而有效的提高了玻璃的抗彎和抗沖擊性能，強度達到了普通玻璃的3 - 4倍，當其破碎時則分裂成均勻純角不易傷人的小顆粒，使其成為一種現代生活中理想的安全玻璃。
  8. Sem results imply that the surface of thin films deposited by chemical bath method is correlate to the reaction conditions. surface of sns thin films deposited by chemical bath method are coarse than thin films deposited by chemical bath with ultrasonication method and successive ionic layer adsorption and reaction method

    Sem結果顯示用常規化學浴方法所制備的薄膜樣品的表面形貌與反應條件有關，而用超聲波輔助化學浴和連續離子反應法制備的薄膜樣品的表面較之常規化學浴方法所得到的薄膜樣品表面晶粒細小均勻，緻密平整。
  9. The result shows that the addition of pbo, bi2o3, in2o3 in zinc electrode can improve the morphology of zinc deposition and prevent it from dendrite growth and deformation. and also, the dendrite growth of zinc was inhibited by the addition of c16 ( ch3 ) 3nbr in the electrolytes through the absorption in active sites on the surface of zinc electrode which will suppress zinc deposition

    實驗結果表明：在電極中適量添加pbo 、 bi _ 2o _ 3 、 in _ 2o _ 3三種金屬氧化物可以明顯改善鋅沉積形態、抑制鋅枝晶和變形；十六烷基三甲基溴化銨通過在鋅電極表面的活性中心上特性吸附，抑制鋅在這些位置的沉積，產生較均勻的沉積，從而達到抑制枝晶的效果。
  10. From the measurements of cyclic voltammetry and galvanostatic charge / discharge, the composite electrode had higher specific capacitance ( 0. 84f / cm2 ) than pure mwnt array electrode ( 0. 38f / cm2 ) in the same experimental conditions. a kind of linear elementary carbon with the similar structure to carbyne was prepared by a new method. the sample appeared to be winding lines with the diameter of around 0. 2 run in the magnified image of the high resolution transmission electron microscope ( hrtem )

    掃描電子顯微鏡表徵結果顯示，聚吡咯比較均勻地附於碳納米管的表面；通過比較復合電極和純mwnts陣列電極在相同條件下的循環伏安和恆電流充放電實驗結果得知，前者的比電容（ 0 . 84f / cm ~ 2 ）明顯高於後者（ 0 . 38f / em ~ 2 ） 。
  11. The analysis results indicate that the correlative influence factors to the technological capabilities of electronic solders include the composition and purity and chemical uniformity of solder alloy, the composition and properties of mother materials and their clean level on the surface, the surface tension of liquid state solders, the temperature and atmosphere in soldering and the activity of flux, the chemical composition and structure and properties of the surface film of melting solders, and so on

    分析表明：相關的影響因素主要包括合金的組成、純度和化學均勻性；母材的成分、性質和表面的潔凈度；液態焊料的表面張力；釬焊溫度、氣氛、助焊劑的活性；液態焊料表面膜的組成、結構和性能等。
  12. Then this dissertation implements most of algorithm of non - uniform b - spline surface such as positive calculation, reverse calculation, knot interposer etc. based on the g0, g1 continuous conditions of uniform bicubic b - spline surface, the paper deduces the g0, g1 continuous conditions in the surface reverse calculation then implements it for each face. the last step is the data exporting

    然後運用非均勻b樣條曲面反算構造插值曲面，研究了雙三次非均勻b樣條曲面反算過程中的g ~ 0 ， g ~ 1連續條件，並根據該條件針對不同的表面給出了相應的連續策略，實現了各曲面間的g ~ 0或g ~ 1連續。
  13. It is the fist thing to make particles to mix with htpb equally by the mixer. many superfine particles with various particle diameters, varieties, content and surface coated had been employed to study the influence on viscosity and dispersion of the slurry

    為了使加入的粉體通過捏合機的捏合，在丁羥膠中得到均勻的分散，我們分別研究了粉體的粒度、品種、組成及粉體表面經包覆處理后，對推進劑漿料的粘度、分散性的影響。
  14. Moreover, the two - step heat treatment method was utilized in the preparation of the films, the films prepared by the first coating with 550 ? heat - treatment and the second coating with of with 500 ? heat - treatment ( b type films ) were highly c - axis oriented with smooth, dense and uniform surface morphology

    此外，結合高溫和低溫熱處理方法優點的兩步熱處理法得到的b型薄膜同時具有較好的c軸擇優取向性和更為平整均勻的表面形貌。另外，在硅基板上也制備出了良好的c軸擇優取向性的摻雜氧化鋅薄膜。
  15. Ub grinding wheel provides heavy stock removal and uniformed surface finish, permitting automation of polishing operation which results in reducing finishing time and eliminating some of finishing processes

    Ub磨輪可提供較大的切削量以及均勻的表面研磨較果。可應用在自動化的拋光作業中，也因此可以減少精磨時間及減去一些製程中的步驟。
  16. The results showed that appropriate copolymer composition and processing techniques were fairly important in the preparation of composite magnetic microspheres. superparamagnetic magnetic composite microspheres with size less than 500nm, magnetic content 22 % and saturation magnetization 32. 5emu / g could be prepared by this novel method. it is proposed that the polymer

    綜合看來，採用dpe法制備的磁性復合微球磁含量高、飽和磁化強度高、無機微粒分佈均勻，且表面潔凈，包覆效率高，因而具有更好的綜合性能，是一種具有廣闊應用前景的新方法。
  17. The involved reason was that monocrystalline silicon had a higher smooth and uniform surface

    其原因可能是單晶硅表面原子排列非常整齊，具有高度光滑和均勻的表面條件。
  18. Zinc oxide ( zno ) is a wide band gap ( 3. 4ev ) semiconductor with the hexagonal crystal structure ( wurtzite type ). zno thin films with the c - axis orientation perpendicular to the substrate show excellent piezo - electrical properties and are widely used in piezo - electrical filed. and the dense anjd uniform surface of the films is required when zno thin films are used as integrated functional films

    Zno屬於六方晶系6mm點群，晶體在c軸垂直面上的電性和彈性都是對稱的，因而c軸擇優取向的多晶薄膜能夠具有單晶那樣的壓電性和光電性質，而具有平整均勻的表面形貌則是zno薄膜作為一種集成功能薄膜應用性能的保證。
  19. It had many great merits such as excellent optical properties, low - cost and easiness to handle which offered promising prospects in the filed of self - cleaning, anti - fog and so on. the hydrophilicity of tio2 was influenced by many factors such as crystal structure, surface morphology, band gap, etc. preparing method and doping element would take effect on the properties of the film

    Tio _ 2薄膜的親水性能受到結構形貌及其禁帶寬度的影響，銳鈦礦相的tio _ 2具有最好的親水特性；平整均勻的表面不僅有利於水的鋪展，而且透光率高，適于玻璃鍍膜；薄膜禁帶寬度降低有利於提高光能的利用率。
  20. The surface morphology of the composite films was confirmed by the sem measurements ; indicating the films are smooth and the thickness of the films are in the range of nanometers ( 250 - 400 nm )

    利用掃描電子顯微鏡測試手段對上述膜材料的表面物理性質和形貌進行了分析。結果表明，這類耐水性復合材料的厚度在納米級（ 250 400nm ） ，並具有均勻的表面結構。
分享友人
分享到 Line

分享到臉書