垂直系材 的英文怎麼說

中文拼音 [chuízhíxìcái]
垂直系材 英文
vertical ties
  • 垂 : Ⅰ動詞1 （東西的一頭向下） hang down; droop; let fall 2 [書面語] （敬辭 多用於長輩、上級對自己的行...
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 直系 : direct line直系繼承人 heir of line; heir of one s body; 直系親屬 lineal relative [relation; depen...
  1. At the surface of the pollen grains there are three types of aperturates, including three porates type, three colpates type and three porate - colpates type ; and four types of sculpture, namely, reticulate, striate, striate - reticulate and verrucate. the upper epidermal cells of the leaves of 12 species plants are detected with hpias - 1000 image analytic system through the treatment of binarization, and the experimental methods are proved stable. the results indicated that the waviness of the anticlinal walls ( sfc ) and the ratio of the feret ' s diameter ( slf ) of the epidermal cells of the middle lamina in the third node of leaves starting from the lowerest part of the stem have a relative constant range and could distinguish from each other. oieanolic acid, l, 5, 8 - trihydroxy - 3 - methoxyxanthone and swertiamarin are separately detected on the tlc, and the different chromatogram of various plants can be considered as characters of identification. the contents of oleanolic acid in 12 species of plants are determinated by hplc, but among the different plants and botanical organs their contents are different, and the highest content in flowers

    本文對川鄂產獐牙菜屬藥用植物資源進行了野外調查、標本採集和鑒定，對12種乾燥藥材的性狀進行了描述，提供了可以鑒別的特徵。通過掃描電子顯微鏡觀察的12種本屬藥用植物的花粉粒均為單粒花粉，萌發孔有3孔型， 3溝型和3孔溝型三種類型；表面紋飾包括網狀紋，條狀?網狀紋，條狀紋和瘤狀紋四種類型。用hpias ? 1000高清晰度彩色病理圖文分析系統對葉片上表皮細胞作圖像分析，並進行方法學研究，結果表明，同種植物莖上第3節葉片中段主脈和第1側脈之間葉上表皮細胞垂周壁彎曲程度sfc值和細胞縱、橫向直徑的比值slf值，種間有顯著差異，每種都有相對恆定范圍值。
  2. But it will affect the airflow organization with the cooled airflow drops. also, it studies the impact of solar radiation on displacement ventilation and cooled ceiling system. horizontal warm areas lowers the height of thermocline and is unfavorable to displacement ventilation system ; vertical hot surfaces will destroy the thermal stratification

    水平熱表面的存在，會使系統的溫躍層高度降低，對置換通風系統會有負面影響，為了減小水平熱表面的影響，對于地板材料應該選擇對長波輻射吸收較低的物質;垂直局部熱表面的存在會破壞置換通風系統溫度分層的特性，使垂直方向溫度變化減小。
  3. By compounding caco3 with pp, the effect of caco3 content, diameter and shape on the crystallization, dispersion morphology and properties of pp / caco3 composites was investigated. the results showed that addition of caco3 into pp decreased the apparent crystal size in perpendicular direction to the ( 110 ), ( 040 ) and ( 130 ) crystallographic planes of ppa crystal, and with similar uniform dispersion of caco3, the dominant factor influencing toughness is the diameter of caco3 particles, but not the decrease of pp crystal size. the toughening effectiveness of nano caco3 is obviously better than that of micron caco3

    將caco _ 3與pp進行填充復合，研究了caco _ 3含量、粒徑及形狀對體系的結晶，分散形態及性能的影響，發現碳酸鈣的加入使聚丙烯晶型垂直於（ 110 ） 、 （ 040 ）和（ 130 ）晶面的表觀晶體尺寸減小，揭示了在分散均勻的情況下，影響材料韌性的主導因素不是晶粒尺寸的減小，而是碳酸鈣的粒徑，納米張玲：彈性體及無機剛性粒子增韌增強聚丙烯復合材料的研究碳酸鈣的增韌效果明顯優于微米碳酸鈣。
  4. Using three male sterile lines of radish, the activicy of three isozymes were studied during their development of vegetable and reproductive stages

    摘要以蘿卜細胞質雄性不育系和保持系為試材，採用聚丙烯酰胺凝膠垂直板電泳方法對花期葉進行過氧化物酶同工酶、澱粉酶同工酶進行分析。
  5. Then, according to the established structure, the parameters of the optical switch were modeled and optimized. the thickness, roughness, verticalness of the mirror was analyzed and designed. finally, the rectangular magnetic material was selected for the electromagnet thirdly, the parameters were optimized by ansys software and the performance of the optical switch was analyzed

    首先根據電磁鐵的非線性特性和梁的抗彎曲力的線性特性，設計出磁力驅動懸臂梁式光開關結構，然後根據提出的結構，從理論上對懸臂梁的參數進行模擬分析選出合適的懸臂梁參數，緊接著分析平面鏡的厚度、表面粗糙度、垂直度對光開關性能的影響；最後對磁路系統，明確選擇具有矩形磁滯回線的材料，設計出電磁鐵的結構。
  6. Secondly, safety factor of a landslide body with a polygonal sliding surface is analyzed in this paper. the results demonstrate that this method can consider that the different material stiffness parameters in the landslide body have an effect on the safety factor. finally, the safety factor of a three - dimension landslide body with a spherical sliding surface is calculated with this method, and the applicability of this method for three - dimension slope is verified after comparing the result with theoretical answer

    文中首先用具有理論解的算例? ?垂直坡受集中荷載的安全系數問題驗證了該方法的正確性，再通過對一個具有折線滑動面的滑坡體的安全系數的分析說明了該方法還可以考慮塌滑體內不同的材料剛度參數對安全系數的影響，之後用該方法對一個具有球形滑裂面的三維滑坡體進行了計算，通過與閉合解的比較驗證了該方法對三維邊坡問題的適用性。
分享友人
分享到 Line

分享到臉書