塑性極限 的英文怎麼說

中文拼音 [sùxìngjíxiàn]
塑性極限 英文
plastic limit
  • 塑 : 動詞（塑造） model; mould
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 極限 : 1 （最高的限度） the limit; the maximum; the ultimate limit; limitation; extremity; tipping point...
  1. Based on the analysis of mechanism for joint region, the " frame - wall " and " aslope compression stub column " mechanical models and yielding patterns of core zone of the joints are set up. the shear load - carrying formulation for joint core zone is also given in terms of plastic ultimate analysis. and then, the comparisons between the formulas given in this paper and that of chinese design code ( draft ) and nonlinear fem as well are presented

    對節點核心區的抗剪，通過受力機理的分析，建立了鋼「框架剪力墻」加混凝土「斜壓短受力體系及其屈服機制，根據塑性極限分析，給出了節點核心區抗剪承載力計算的迭加公式， 《規程》公式和非線性有限元近似模擬分析結果進行了比較。
  2. Plastic theory suggests, the composite beam for the floorslab is suited lower flange, it s plastic limit moment cuts down by 52. 4 % than the composite beam for the floorslab is suited on the top flange. it s plastic limit moment lifts 8. 8 % than the steel beam, which is on the same condition

    塑性理論分析的結果表明，樓板位於鋼梁下翼緣形式的組合梁和樓板位於鋼樑上翼緣形式的組合梁截面相比較，其塑性極限彎矩降低52 . 4 ，和同等條件下純鋼梁截面相比較，樓板位於鋼梁下翼緣的組合梁塑性極限彎矩提高8 . 8 。
  3. Based on the method of limitation analysis of soil plasticity, researching from the soil arching mechanism of soil - nailing retaining, the upper limit of the critical height of soil - nailing slopes and the minimum horizontal length from coping of the potential slide surface to the edge of deep excavation are obtained through the analysis to weight of soil and vertical loading and the mechanism of soil and soli - nailing acting reciprocally

    摘要基於土的塑性極限分析方法，以均質土坡為例，從土釘支護結構的準粘聚力理論出發，綜合考慮土體自重、坡頂的條形荷載，以及土釘與土體的相互作用的機理，推導出了土釘支護的臨界高度的上限值和潛在螺旋曲線滑動面在坡頂方向距基坑邊沿的最小水平距離解析表達式，可供基抗支護設計參考。
  4. Now, there are three main methods, namely limit equilibrium method, plasticity limit analysis and fem

    目前，邊坡工程穩定性分析主要有極限平衡法、塑性極限分析法和有限元法。
  5. Plastic limit analysis of heterogeneous soil slope using finite elements

    非均質土坡的有限元塑性極限分析
  6. The application of mises yield condition in limit analyse of plasticity

    屈服條件在固支圓板塑性極限分析中的應用
  7. Matlab in finite element plastic limit analysis lower limit law application

    在有限元塑性極限分析下限法中的應用
  8. There are two main innovate ideas in the dissertation. ( 1 ) supported by the results from the method of limit analysis of soil plasticity and the ultimate equity method, the author proposes the criterion of judging of stability of slope of foundation of a building

    本文的創新點主要有：採用塑性極限分析和極限平衡方法，通過計算，提出了黃土地區宅基邊坡的穩定性評價標準，即人工谷緣的坡度不得大於天然坡度。
  9. Nonlinear constitutive relations are discussed for analyzing the stress distribution, the appearance and development of the cracks, as well as the behavior of the boundary conditions of the two way slabs respectively. in the light of the experimental research on r. c. two way slabs under static loading, the behavior of yield line, the load deformation curves and the crack yield, plastic limit loads of slabs with different supporting conditions are studied

    根據反映雙向板混凝土材料非勻質性的本構關系，分析了雙向板在荷載作用下的變形、屈服、裂縫和破壞的形態特性，並對鋼筋混凝土雙向板在不同支承條件下的塑性極限荷載、正常使用撓度（曲線）和截面設計作了進一步研究。
  10. Test method for liquid limit and plastic limit of soils

    土壤液性極限與塑性極限的試驗方法
  11. Third, a theoretic approach based on total theory of plasticity is for the first time applied to analyze elastoplastic torsion rigidity of the tubular, and the results are well proved by the test data. also for the first time, the plastic stability of the spiral skew stiffening shell is studied. it is shown in the experiments that there is the comparability between the stability of the members at plastic limit and that of the thin - shelled steel tubular with the spiral skew stiffening concrete rib

    本文首次分析了扭轉作用下的螺旋斜向加勁殼的塑性穩定性問題，還根據試驗觀象的觀察，對構件在塑性極限時的狀態，簡化為內壁襯朽螺協剎向加勁混凝土肋的薄壁鋼管的塑性穩定問題，利用塑性殼體穩定理論進行了探討。
  12. Soil : inverstigation and testing. determination of atterberg ' s limits. liquid limit test using cassagrande apparatus. plastic limit test on rolled thread

    土壤:研究和試驗. atterberg極限的測定.卡薩格蘭德儀器液體極限試驗.軋制螺紋塑性極限試驗
  13. The effect of different sizes of sections, modes and values of residual stresses are studied. through the analysis, the conclusion is arrived at that the universal slenderness ratio should be used to better correlate the stability of box section beams with the member length instead of the out - of - plane slenderness, and the stability coefficient is taken to be 1. 0 for practical used box girder. then, the elastic critical loads of box section beam - columns are obtained based on the gjelsvik theory, and the relationship between axis force p and moment m is given

    最後，運用ansys通用有限元程序的beam189單元，引入初彎曲和殘余應力的影響，用考慮幾何和材料雙重非線性的有限元求解格式求得箱形柱在不同軸力和彎矩比例作用下的彈塑性極限承載力，通過對十幾個不同截面尺寸構件在不同長細比下的承載力計算，發現在軸力p遠大於彎矩m時，構件將是平面外失穩控制，而當軸力p遠小於彎矩m時，構件則以平面內失穩為主。
  14. Plastic limit load

    塑性極限載荷
  15. Firstly, based on the classical theorem of limit analysis, the von mises yielding condition and finite element method technique, two common mathematical programs for the determination of the lower and upper bounds are built and solved by an iteration algorithm directly

    首先，基於塑性極限載荷分析中的上下限定理和有限元離散技術，推導和給出了一般結構極限載荷上下限計算的數學規劃的普遍格式和相應的積分數值計算公式。
  16. The optimal course is automatically implemented with matlab. the cusp catastrophe model is established by means of the upper bound theorem of plastic limit theory. the characteristic formula of the failure of slope is also deduced

    根據分析邊坡穩定性的塑性極限方法的上限理論建立了邊坡失穩尖點突變模型，並得出邊坡突發式滑坡的特徵關系式，用突變理論對非飽和土邊坡穩定進行了初步研究。
  17. 2. taking five representative casualty loess landfalls on the house side - slope as examples, applying the method of limit analysis of soil plasticity and the ultimate equity method, the equation of the stability and gradient of the landfall is derived

    2 .以5個典型宅基邊坡傷亡性黃土崩塌為例，利用塑性極限分析和極限平衡法，推導出了此類黃土崩塌的穩定性與其坡度之間的關系。
  18. Plastic limited deformation analysis of the clamped rectangular steel plate subjected to air non - contact explosions

    空爆載荷作用下固支矩形鋼板的塑性極限變形
  19. Standard test methods for liquid limit, plastic limit, and plasticity index of soils

    土壤液體極限塑性極限和塑性指數的標準試驗方法
  20. Abstract : based on soil plasticity and limit analysis theory, the second failure surface of backfill behind retaining wall with gentle back surface are studied from two view points of maximum active soil pressure and minimum resistive overturning safety factor, and it is further considered that the minimum resistive overturning safety factor is the best approach to studying the failure mechanism of backfill under complex back surface conditions of retaining structures

    文摘:基於土的塑性極限分析理論，從擋土墻最小抗傾覆安全系數和擋土墻背上的最大主動土壓力兩個角度，分別研究了坦墻後土體中第二破裂面的位置，認為在復雜的擋土結構墻背條件下，用最小抗傾覆安全系數來研究擋土墻後土體的破壞機制較為合理。
分享友人
分享到 Line

分享到臉書