塗層膠 的英文怎麼說

中文拼音 [túcéngjiāo]
塗層膠 英文
coating adhesive
  • 塗 : Ⅰ動詞1 （抹） spread on; apply; smear 2 （亂寫或亂畫） scrawl; scribble 3 （抹去） cross [blot; s...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 塗層 : paint-coat; paintcoat; coat; coating; covering; lining; wrapping flux
  1. The specimens were made from two glass arms joined with a 0. 005-in. layer of epoxy adhesive.

    製作的試樣是把兩塊玻璃臂用0005時厚環氧粘合劑塗層膠合成的。
  2. En iso 4674 - 2 rubber - or plastics - coated fabrics. determination of tear resistance. part 2 : ballistic pendulum method

    橡膠或塑料塗層織物.抗撕裂性的測定.第2部分:沖擊式擺錘方法
  3. Rubber or plastics - coated fabrics - determination of tear resistance - part 2 : ballistic pendulum method iso 4674 - 2 : 1998 ; german version en iso 4674 - 2 : 1998

    橡膠或塑料塗層的織物.抗撕裂強度的測定.第2部分:沖
  4. The research results show that, from the viewpoint of second phase morphologies, there exist quite differences between the grain - type materials ( such as wc / bcu brazing deposit material, wrs1000 and 1zt tungsten carbide strengthening overlaying material, as well as the wear - resistant material of polymer adhesive coating etc. ), and the aggregation - type as well as dispersion - type ones ( such as zg35simn, wrd - 1 and khc - k2 depositing material ) in the wear - resistance and sand slurry abrasion mechanism. the sand slurry abrasion mechanisms are brought forward, of new wear - resistant materials with the features of grain - type second phase morphologies

    研究發現，與聚合型、彌散型第二相的材料（如zg35simn 、 wrd ? 1和khc ? k2熔敷材料等）相比，顆粒型第二相的材料（如wc bcu釬焊熔敷耐磨材料、 wrs1000型耐磨材料、 1zt碳化鎢顆粒增強熔敷材料及ktc ? 1耐磨膠粘塗層材料等）在耐磨性能和磨損機理等方面均有不同，總結提出了以「顆粒型第二相」為特徵的耐磨新材料泥沙磨損機理。
  5. Iszard and wilks used a differential technique to study the surface coating on cellophane.

    伊斯扎德和威耳克斯應用差示技術，研究粘膠薄膜的塗層。
  6. Standard practice for evaluating accelerated efflorescence of latex coatings

    評價膠乳塗層加速風化的標準實施規程
  7. Rubber - or plastics - coated fabrics - accelerated ageing tests - physical ageing : effect of light or weathering

    橡膠或塑料塗層織物.加速老化試驗.物理性老化:光和氣候的影響
  8. Rubber - or plastics - coated fabrics - accelerated ageing tests - part 2 : physical ageing : effect of light or weathering

    橡膠和塑料塗層織物.加速老化試驗.第2部分:物理老化.光或氣候老化作用
  9. Rubber - or plastic - coated fabrics - accelerated ageing tests - part 2 : physical ageing : effect of light or weathering ; german version en 12280 - 2 : 2001

    橡膠和塑料塗層織物.加速老化試驗.第2部分:光和風化
  10. Rubber or plastics covered rollers - method of test - determination of apparent hardness by the pusey and jones method

    橡膠或塑料塗層的輥子.第3部分:試驗方法.第3節:採用普西和瓊斯法測定表面硬度
  11. When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set

    當膠粘劑中填料為其它物質（未處理蒙脫土、粉煤灰、粉煤灰和有機化蒙脫土共復合、碳化鈣和有機化蒙脫土共復合）時，通過拉伸剪切試驗確定膠粘劑中有機化蒙脫土含量為5時，膠粘劑的拉伸剪切強度最高；同時進行了沖蝕磨損試驗，通過比較得出，當膠粘劑塗層中有機化蒙脫土含量達到5時，塗層的耐沖蝕磨損性能最佳，並對沖蝕磨損試樣在掃描電子顯微鏡（ set ）上進行觀察。
  12. Based on detecting old fuel gas pipe material, corrosion condition, soil corrodibility and corrosion mechanism, this dissertation posed coating protection method that polythene gummed tape preservation layer can be used to the old pipes and polythene interlayer preservation layer can be used to new pipes

    本論文在細致考察了舊燃氣管道材質、腐蝕狀況、土壤腐蝕性和腐蝕機理的基礎上，提出對于舊管道採用膠帶防腐層，新管道宜採用聚乙烯「夾克」防腐層的塗層防護措施。
  13. Rubber or plastics - coated fabrics - determination of crush resistance

    橡膠或塑料塗層織物.耐擠壓性測定
  14. Rubber or plastics - coated fabrics. determination of crush resistance

    橡膠或塑料塗層織物.抗縐性的測定
  15. Rubber - or plastic - coated fabrics - accelerated ageing tests - part 3 : environnement ageing

    橡膠或塑料塗層織物.加速老化試驗.第3部分:環境老化
  16. Influence of nano - mmt on the property of epoxy adhesive coating

    納米蒙脫土對環氧樹脂膠黏塗層性能的影響
  17. The specimens were made from two glass arms joined with a 0. 005 - in. layer of epoxy adhesive

    製作的試樣是把兩塊玻璃臂用0 005時厚環氧粘合劑塗層膠合成的。
  18. Main fabrics used : oxford nylon cloths, nylon cloths, t c cloths, woolens, pvc coating cloths, fleece fabrics, a c coating cloths, pu leather, etc

    主要採用面料：牛津尼布，尼布，滌綸布， t c布，呢料， pvc塗層布， a c膠塗層布， pu塗層布。
  19. Paper - printing paper - part 2 : technical delivery specifications for offset - paper, coated and uncoated, white

    紙.印刷紙.第2部分:白色塗層和無塗層膠版印刷紙的交
  20. High potential pressure sensitive adhesive double coated tapes

    高位差壓敏雙面塗層膠粘帶
分享友人
分享到 Line

分享到臉書