塗層面 的英文怎麼說

中文拼音 [céngmiàn]
塗層面 英文
side of coating
  • : Ⅰ動詞1 (抹) spread on; apply; smear 2 (亂寫或亂畫) scrawl; scribble 3 (抹去) cross [blot; s...
  • : i 量詞1 (用於重疊、積累的東西 如樓層、階層、地層) storey; tier; stratum 2 (用於可以分項分步的...
  • : Ⅰ名詞1 (頭的前部; 臉) face 2 (物體的表面) surface; top 3 (外露的一層或正面) outside; the ri...
  1. Biomimetic synthesis of apatite layer on 316l stainless steel

    不銹鋼表仿生合成磷灰石
  2. Preparation of apatite coatings on porous titanium via chemical treatment

    化學處理制備多孔鈦表磷灰石
  3. The research results show that, from the viewpoint of second phase morphologies, there exist quite differences between the grain - type materials ( such as wc / bcu brazing deposit material, wrs1000 and 1zt tungsten carbide strengthening overlaying material, as well as the wear - resistant material of polymer adhesive coating etc. ), and the aggregation - type as well as dispersion - type ones ( such as zg35simn, wrd - 1 and khc - k2 depositing material ) in the wear - resistance and sand slurry abrasion mechanism. the sand slurry abrasion mechanisms are brought forward, of new wear - resistant materials with the features of grain - type second phase morphologies

    研究發現,與聚合型、彌散型第二相的材料(如zg35simn 、 wrd ? 1和khc ? k2熔敷材料等)相比,顆粒型第二相的材料(如wc bcu釬焊熔敷耐磨材料、 wrs1000型耐磨材料、 1zt碳化鎢顆粒增強熔敷材料及ktc ? 1耐磨膠粘材料等)在耐磨性能和磨損機理等方均有不同,總結提出了以「顆粒型第二相」為特徵的耐磨新材料泥沙磨損機理。
  4. In the investigations on laser cladding, experiments and analyses of laser clad nickel - based alloys and nickel - based ceramal composite alloys on steel substrates were performed to improve wear - resistance and corrosion - resistance properties of the coatings

    以提高材料表的耐磨、耐蝕等性能為目的,採用預置和送粉熔覆工藝方式,對常用的鎳基合金和鎳基碳化鎢金屬陶瓷合金進行系統研究。
  5. That is the premise of the bg / ha electrophoresis codeposition. the laws of the electrophoresis deposition of the bg and ha partic les were found by the study on each of their deposition under the different conditions. the electrophoresis codeposition of the bg and ha particles had been studied and the bg / ha graded coating, which is compact in the bottom layer and porous near the surface layer, had been prepared on the surface of the dental implant after the low temperature heat treatment ( about 740 ) and fast firing ( 50 - 80 / min, heat preservation time was 5 - 8min. )

    以bg微粉和ha微粉作為原料,通過研究bg和ha微粉在非水介質中的分散情況和帶電特性,選擇冰醋酸為介質,使分散在其中的bg顆粒和ha顆粒表均帶上正電荷,為電泳共沉積提供前提條件;通過對不同條件下bg 、 ha各自電泳沉積的研究,探索出了兩者電泳沉積的規律;通過對bg和ha在冰醋酸中電泳共沉積以及后續低溫( 740左右)快燒( 50 ? 80 min ,保溫5 ? 8min )熱處理的研究,在鈦合金牙根種植體基體上成功制備出了底緻密而表多孔的bg ha梯度
  6. The surfaces adopt a series of advanced craft, such as sour wash, degrease, the turns, the static electricity sprays, etc. making the surfaces layers hard, bear the impacted the corrosion and more beautiful and meticulous

    採用酸洗,脫脂,磷化,靜電噴等十余道先進工藝,使堅固,耐沖擊,耐腐蝕,美觀細致,表裡如一
  7. Preparation and properties of drug elusion coating on coronary stents

    冠脈支架表載藥的制備和性能
  8. Standard specification for aluminum - pigmented asphalt roof coatings, nonfibered, asbestos fibered, and fibered without asbestos

    無纖維增強石棉纖維增強和無石棉的纖維增強的填充鋁顏料的瀝青屋標準規范
  9. How do you know the finish coating is of good quality

    怎樣知道質量是好的?
  10. Test method for coefficient of static friction of uncoated writing and printing paper by use of the inclined plane method

    用傾斜法測試無書寫紙和印刷紙靜磨擦系數的試驗方法
  11. Test method for coefficient of static and kinetic friction of uncoated writing and printing paper by use of the horizontal plane method

    用水平法測量非書寫印刷紙動態和靜態摩擦系數的方法
  12. Standard test method for coefficient of static and kinetic friction of uncoated writing and printing paper by use of the horizontal plane method

    用水平法測試無書寫紙和印刷紙的靜磨擦和動磨擦系數的標準試驗方法
  13. Only soils which become strongly attached to coatings at elevated temperatures would be difficult to remove by laundering.

    只有當油質污垢在高溫下,牢固地附著在時,才不易洗滌除去。
  14. Coated : gloss, silk, matte - uncoated : book, text, bond, cover,

    :書籍紙文本紙普通紙封
  15. With regard to the protection system of inorganic zinc - rich primer + epoxy micaceous iron oxide intermediate + polysiloxane finish having been used for major bridges for the first time and the anti - rust and anti - slip inorganic zinc - rich coating used for the bolted and welded surfaces of the bridges, the paper describes the protection system and coating workmanship in considerable details from aspects of the material properties, construction methods and coating inspection

    針對在大型橋樑上首次應用的「無機富鋅底漆環氧雲鐵中間漆聚硅氧烷漆」的防腐體系和栓接採用的無機富鋅防銹防滑料,從材料特性、施工方法及檢驗等幾方做了較詳細的論述。
  16. Standard test method for nondestructive measurement of dry film thickness of nonconductive coatings applied to a nonferrous metal base

    非鐵金屬基表非傳導干膜厚度無損測量的標準試驗方法
  17. The measurement method of current - cut - off potential and resistivity of coating surface

    斷電電位和塗層面電阻率測試方法
  18. 3. the gap defects in multilayer cvd sic coatings could be effectively controlled by means of slow deposition in low - pressure chemical vapor deposition ( lpcvd ). 2d c / sic composites with a multi - layer cvd sic coating prepared by slow lpcvd showed weight gain at 1300 @ in air condition

    ( 3 )採用慢速減壓化學氣相沉積工藝實現了對多cvdsic塗層面缺陷的有效控制,實現了單一cvdsic保護2dc sic在高溫下( 1300 )的氧化增重。
  19. Rubber - or plastics - coated fabrics - determination of roll characteristics - methods for determination of total mass per unit area, mass per unit area of coating and mass per unit area of substrate

    橡膠或塑料覆織物.卷料參數的測定.料單位積總質量單位塗層面積的質量和基體單位積質量的測定方法
  20. Ground on the knowledge of the form mechanisms of the coating defects, the research work proposed some thoughts related to preparation / deposition process to control the coating defects. based on observation of micro - morphologies of the coatings, combined with relative weight change in oxidation, the effects of these modifications on coating defects control and the behaviors of 2d c / sic at constant temperatures in air condition were investigated. the main contents and conclusions are as follows : 1

    本文從多cvdsic缺陷形成的根源出發,通過制備工藝進行缺陷控制;以對顯微形貌的觀察為基礎,結合氧化重量變化率,研究了不同改性工藝對多cvdsic塗層面缺陷的影響以及對2dc sic復合材料恆溫氧化行為的影響,主要研究內容與研究結果如下: ( 1 )研究了多cvdsic的2d和3dc sic復合材料在空氣中的恆溫氧化行為,表明2d和3dsic ? c sic在空氣中表現出類似的氧化動力學行為。
分享友人