壁基極 的英文怎麼說
中文拼音 [bìjījí]
壁基極
英文
walled base-
Though much progress has been achieved in previous study, there still remains a lot to be studied and perfected. the thesis is devoted to study on the multi - ribbed slab wall, the main bearing member in mrss, including its mechanism, failure mode, aseismic capability, mechanical models, ultimate bearing capacity and aseismic design based on control. the paper mainly accomplished such work as follows : 1 ) based on test research on multi - ribbed slab wall, the paper proposed the member ' s failure modes under horizontal loads, analyzed the co - performance between the inner frame and the infilled silica bricks and that between the slab and the outer frame, discussed the wall ' s bearing capacity, rigidity, deformation, ductility and energy dissipation ability in different modes, and put forward a simplified mechanical model of the slab wall under vertical loads
本文針對密肋壁板結構的主要受力構件? ?密肋復合墻體為研究對象，就其受力機理、破壞模式、抗震性能、三階段力學模型、極限承載能力以及基於控制的抗震設計方法等進行了較為詳細的研究，完成的主要工作有： 1 ）通過對密肋復合墻體在水平低周反復荷載和單調荷載作用下的試驗研究，提出了墻體的主要破壞模式；分析了框格與內部填充砌塊、墻板與外框的共同工作的受力特點；探討了不同破壞模式情況下墻體的承載能力、剛度、變形、延性、耗能等抗震性能，並給出了豎向荷載作用下密肋復合墻體的簡化力學模型。To meet this challenge, a research project was supported by ministry of communication and bv shanghai zhenhua port machinery co. ltd. focusing on analysis of tdtcd ( traditional design theories of crane drums ) the paper has studied the impacts of features under the binding force of wire ropes, the end - plate and rope slot. this study is based not only on the thin shell theory and viscoelastic mechanics to calculate the strength and stability of drum, but also on an experiment with technology in " state of act "
本文結合交通部重點科技項目「港口起重機鋼絲繩傳動件高性能技術研究」和上海振華港機股份有限公司委託項目「起重機焊接捲筒極限壁厚研究」 ，針對起重機捲筒傳統設計方法偏於保守的情況，以薄殼理論和近代力學為基礎，以現代試驗技術為研究手段，對鋼絲繩緊箍力作用下的外載特性、端板、繩槽等因素對捲筒強度和穩定性的影響進行了系統的理論研究，在深入開展捲筒強度、穩定性和實驗模態分析等試驗的基礎上，提出了有別于傳統方法的捲筒強度、穩定性計算方法。Today, cast - in - situ piles are more widely used in deep foundation engineering because of their many advantages, such as better adaptability to various ground condition, providing enormous bearing capacity by a single pile and smaller dosage of reinforcing steel bar. but, their own disadvantages, such as sediment under tip, clay slurry around pile, friction and tip resistance disagreement and initial ground stress freeing, limited their bearing capacity, lowered the utilization ratio of material and increased the settlement
灌注樁，因其對地層適應性強、能提供較大的單樁承載力、鋼筋用量少等優點，在目前深基礎工程中得到了極為廣泛的應用。但是，灌注樁的固有缺陷，諸如孔底虛土；孔壁泥漿；端阻、側阻發揮不同步；鉆孔后原地應力釋放等，限制了其承載力的發揮，使得材料利用率不高，沉降較大。Chapter four focuses on the countermeasures against anti - dumping from the view of government and enterprises respectively. the following is the major viewpoints in the thesis : anti - dumping has developed into one of the major forms of trade barriers, which has its root deeply set into the economy and its internal features ; the backward managerial style of chinese enterprises constitutes the primary internal cause of the severe situation in which they have been suffering from anti - dumping ; the discriminating practices violate, in essence, the relative wto principles ; to break the anti - dumping barrier, the chinese government should straighten out the export practices, build up trade and business associations, and appeal to the wto dispute settlement body. as for enterprises, they should alter their marketing strategies and strengthen the cooperation with international business entities
本文的主要觀點有：反傾銷自二十世紀下半期以來逐漸發展成為一種主要的國際貿易壁壘，有其深刻的經濟客觀需要以及自身的特點；中國企業普遍不存在對海外市場的傾銷能力，落後的經營管理方式是造成中國企業遭遇反傾銷制裁的主要內因；替代國制度從本質上講是違背wto反傾銷協議原則的；欲打破反傾銷封鎖，我國政府對內應整頓出口經營秩序，建立健全商會職能，對外應在研究吃透有關規則的基礎上積極向wto爭端解決機構申訴，以從根本上扭轉不利局面；企業應轉換經營思維，調整經營策略，積極應訴並加強國際合作，才能消除遭致國外反傾銷的內部隱患。Abstract : it has been discovered that the coke formed in ch4 coupling under plasma can be eliminated via pure h2 discharge in the system. eliminating coke under plasma with positive or negative high voltage in dc electric field has been compared with that in ac field. the elimination of coke takes place only on the negative of the two electrodes in dc field, while on both electrodes in ac field. the coke on the reactor walls can be eliminated with either positive or negative high voltage and in either dc or ac field. based on the experimental facts, hypotheses of the reaction mechanism are suggested. quantity of eliminating coke depends on diametrical ratio between reactor and the electrode, input power and electrode materials
文摘:發現了等離子條件下甲烷偶聯反應中形成的積炭可以通過該體系中純氫氣放電而消除.將消除積炭使用直流電場的正高壓和負高壓與使用交流電場作了比較，發現直流電場中無論使用正高壓還是負高壓，只有陰極上的積炭可以被消除，而交流電場中兩極積炭均可被消除，反應器壁上的積炭在以上任何情況下均可被消除.基於實驗事實提出了機理假設.消除積炭的量與輸入功率、反應器對電極的直徑比以及電極材料有關On the basis of the mentioned above, this paper analyzes the international competition of our textile industry. and using the method of ahp analyzes the main difficulties that our clothing industry will encounter in the new environments and to what extent they will affect its development. according to that, an optimum developing plan is also put forward in this paper, which mainly includes : ( 1 ) increasing enterprises " capability on technology and equipment, ( 2 ) breaking through technical barriers, ( 3 ) enhancing the personnel characteristic and boosting the cultivation of talent resources, ( 4 ) enlarging enterprises " scope and constituting large textile groups, ( 5 ) knowing well the trade policy and chances in main market, ( 6 ) increasing product quality and developing characteristic and setting up globally famous brands, ( 7 ) carrying out adjustment of industrial structure and completing the reconstruction of modern enterprises " system, ( 8 ) actively replying anti - dumping barriers, ( 9 ) carrying out the strategies of differential market, ( 10 ) implementing regional adjustment
在此基礎上，分析了中國紡織服裝業的國際競爭力，並引入層次分析法（ ahp ）對中國紡織服裝業應對新環境的主要困難及其對發展中國紡織服裝業的影響程度進行理論分析，按照問題輕重和影響程度大小進行了排序，提出集中力量按照： （ 1 ）提高企業的技術裝備水平， （ 2 ）集中力量突破技術壁壘， （ 3 ）提高員工素質，加快人力資源培訓， （ 4 ）擴大企業規模，組建企業集團， （ 5 ）熟悉各主市場的貿易政策及其變動， （ 6 ）提高產品質量，開發特色產品，創建名牌產品， （ 7 ）進行產業結構調整，完善現代企業制度的改革， （ 8 ）積極應對反傾銷， （ 9 ）實施差別化的出口市場戰略， （ 10 ）進行區域結構調整，加大市場開放的力度，充分發揮產業集群的競爭力的主次分明地最優化發展方案。A competition mechanism throughout the tunnel etching of aluminum foils is established in this study, namely, the competition between the attack to passive surface by aggressive anions and the passivation caused by passivators ; dissolution competition between side wall of tunnels and overall surface of foils. to demonstrate the competition mechanisms, the etching conditions influencing the morphology of tunnels, surface modification of foils, redemption and regeneration of passive state were investigated
本文在綜述了目前國內外鋁陽極箔發展和直流電侵蝕理論的基礎上，研究了鋁箔侵蝕過程中影響隧道孔形貌和比容的各種因素，揭示了貫穿于整個侵蝕過程的競爭規律，即蝕孔成核競爭? ?鋁箔表面的活化與鈍化競爭；溶解競爭? ?隧道孔孔壁的溶解與侵蝕箔表面的溶解競爭。分享友人