射埠 的英文怎麼說

中文拼音 [shè]
射埠 英文
shebu
  • : Ⅰ動詞1 (用推力或彈力送出) shoot; fire 2 (液體受到壓力迅速擠出) discharge in a jet 3 (放出) ...
  • : 名詞1. (碼頭) pier; port; wharf; jetty 2. (有碼頭的城鎮) port city3. (商埠) commercial port
  1. First introduces briefly the characteristic of microwave, the history of mamt, its characteristic and trends. then explains the contents of one port reflection parameters, the way to measure them and something to pay attention to. at the end we illustrates how to get the reversible two ports s matrix using eight - point method

    首先概述了微波的特點,接著介紹了微波自動測量技術的發展歷史、特點及其今後發展的趨勢,然後說明了二網路反參量的內容、測定方法、需要注意的問題以及可逆二口網路散參量的八點法測量,重點介紹了八點法圖解的方法。
  2. Telecommunications - fixed radio systems - point - to - point and multipoint systems - spurious emissions and receiver immunity limits at equipment antenna port of digital fixed radio systems v1. 2. 1

    電信.固定無線電系統.點對點和多點系統.數字固定無線電系統的設備天線的雜散輻和接收器抗干擾限值
  3. Wire antennas are still very popular on vehicles, ships and aircrafts. they are easily to be interference sources and sensitive bodies. in our calculation we must take account of the mutual coupling between wire antennas when they are very close

    線天線在移動通信系統中被廣泛地應用,它作為許多機載、艦載、衛星、通信電子設備中電磁能量的發和接收,最有可能成為輻干擾的干擾源和敏感體,特別是當天線靠得很近的時候,必須考慮相互之間的互耦。
  4. A analysis of these effect to the pattern is presented. in the mean time, the method of correcting the phase errors is given by shortening or lengthening the section of sinuous feed line between couplers from the normal value. 6. the reflection characteristic of a serpentine is analyzed where the coupler is replaced by the equivalent of two ports loss network

    提出了用有耗二網路來等效波導耦合器的方法,對由耦合器、饋電波導和波導彎頭級聯的慢波線系統的駐波特性進行了分析計算,針對慢波線在設計測頻率上大反問題,討論了多種解決辦法。
  5. Changing the depth of penetration of the three dowels results in the variation of the reflection coefficient ( s1 1 ) at the port 1. using matlab, we can calculate different equivalent impedance of port 1 which resulted from the variation of dowels depth. the purpose of my work strike up a relationship between the depth of dowels and equivalent impedance at port, thereby accomplish matching rapidly, simultaneously and stably

    在構建了自動阻抗匹配系統的基礎上,本文提出了一種新的快速匹配方法;此方法是將模擬軟體hfss和系統設計相結合,用hfss模擬系統中完成阻抗變換作用的銷釘匹配器,獲得銷釘插入波導深度變化時的等效特性,並將模擬得到的數據用matlab組織起來,分析銷釘插入波導的深度變化時等效阻抗特性的變化,來達到對調試變化規律的認識,快速的實現銷釘插入深度與反系數間的統一。
  6. For low distortion, the drains ( or collectors ) of a differential amp " s front - end should be bootstrapped to the source ( or emitter ) so that the voltages on the part are not modulated by the input signal

    為了得到低失真,差分放大器前端的漏極(或集電極)應該被引導到源極(或極) ,這樣電壓就不會被輸入信號調制了。
  7. If a port is mapped to more than one numa node, sql server assigns connections to nodes in a round - robin fashion without attempting to balance load across the nodes

    如果一個到多個numa節點,則sql server以循環的方式將連接分配到各節點,而不會試圖平衡節點之間的負載。
  8. Durning study of the subject, realizating comprehensive rf front - end simulator and starfabric data - distributed interface module in hardware. moreover, it elaborates the achievement of a system of data - distributed based on starfabric technology, by designing hardware modules, multi - entrance high - speed switch module, signal processing module and pc terminal

    在課題研究期間,在硬體上完成了高速數據分發系統中的綜合頻前端模擬器和starfbric數據分發介面板設計及實現,並用所設計的硬體模塊,加上多高速交換模塊、信號處理模塊和pc終端實現了一個基於starfabric技術的高速數據分發系統。
  9. Finite - element analysis of a circular waveguide bevel cut radiator

    圓波導斜劈形器的有限元分析
  10. How to : map tcp ip ports to numa nodes

    如何將tcp / ip到numa節點
  11. More than one port can be mapped to the same numa nodes

    可以將多個到同一numa節點。
  12. To map a tcp ip port to a numa node

    將tcp / ip到numa節點
  13. 3. the design and implementation of the manager tool client of gategod firewall syste

    設計並實現了gategod防火墻系統的地址偽裝和功能模塊。
  14. Nat implements the functions of pat and dnat in the real time embedded operation system with the result of supporting protocols of tcp udp and icmp

    其中, nat包括pat和dnat兩個功能在實時、嵌入式操作系統中的實現,支持tcp 、 udp和icmp協議,採用的方法,實現多個內網地址使用一個防火墻連接公網地址的方式。
  15. Through the analysis of windows ndis frameworks, the nat use ndis intermediate driver technique and modify the packets during it. the nat we designed support tcp, udp and icmp protocols. customer hosts in local network could connect to the internet using one ipv4 address

    通過對windowsndis框架的分析,系統採用在windowsndis中間層驅動進行數據包截獲處理的方式實現了網路地址轉換,它支持tcp 、 udp和icmp協議,採用的方法,實現多個內網地址使用一個公網地址連接internet的方式。
  16. Secondly, a network based on multi - terminal components modeling methodology was applied to model mems at system - level by the analogy and mixed - signal modeling tool of vhdl - ams, for the system - level model of mems is a mixed signal model, which has attributes of multi - energy domains coupling, multi - signals mixed and interacting between discrete - event subsystems and continuous - time subsystems. with this method, the whole system can be divided into some subsystems defined as multi - terminal components ; the behavior of the subsystems depends only on their terminal signals ; the information exchange between subsystems was done by the signals at their terminals. the continuous - time systems or discrete - event systems can be modeled and simulated with this method, which satisfied the requirements of nonlinear systems and large signals analysis

    同時,針對mems的系統級模型是一個混合信號模型,具有多能量域耦合、多信號混合、離散事件子系統與連續時間子系統交互的特點,使用vhdl - ams作為混合信號模型建模的工具,採用多組件網路建模方法建立了mems系統級模型,把微型機電系統分解為多個子系統或組件,各子系統被定義為多組件,子系統的內部行為通過其行為來描述,子系統間的能量與信號的交換通過組件的來實現,從而實現了對連續時間系統和離散事件系統的建模與模擬,滿足了非線性系統以及大信號分析要求。
  17. In this paper, the crosstalk and radiation of multiple - core cable is analyzed according as the multiconductor transmission line, two ports network and antenna theory. firstly the fundamental theories are presented

    本文主要依據多導體傳輸線理論、二網路理論和天線理論對多芯電纜的耦合泄漏和輻進行了較為詳細的分析討論。
  18. Abstract : constant components and output opened ports in the result of high - level synthesis lead to explicit redundancy in gate - level technology mapping. explicit redundancy can not improve the performance, but increases power consumption, enlarges circuit area and decreases its testability, so it should be removed. this paper proposes a queue loop optimization algorithm to remove explicit redundancy completely which decreases the circuit area and improves the testability

    文摘:高級綜合結果中常量元件和輸出懸空導致門級工藝映結果中存在顯式冗餘.顯式冗餘無助於提高電路性能,反而增加功耗,降低電路的可測試性,使電路面積增大,應予消除.文中提出了顯式冗餘的隊列循環優化演算法,完全消除了此類冗餘,從而有效地減少了生成電路的基片面積,提高了電路的可測試性
  19. Relying on the international 4d - class baitabu airport, the demonstration work of airport logistics park that occupied an area of 10 - 15 sq km is done by jinhai investment company

    依託輻蘇北魯南地域的國際4d級連雲港白塔機場,面積達10 - 15平方公里的空港物流園區正由金海投資先期規劃論證運作。
  20. The author bring forward the devise scheme to design the new type reader based on the ti s6700 reader ic while getting full understanding of the relevant theories and fundamentals about the rfid system, thus to realize the data collection, storage, display and transmission across a long way and enhance the reading distance through adding power amplifier and improving the antenna design

    本文作者在對rfid系統的相關理論和技術深入研究的基礎上,提出採用tis6700閱讀器晶元集成化設計新型閱讀器的方案,實現數據採集、存儲、顯示和有效遠距離傳輸,並通過在信號發射埠增加功率放大模塊的方法提高閱讀器的有效閱讀距離。
分享友人