展性合金 的英文怎麼說

中文拼音 [zhǎnxìnggějīn]
展性合金 英文
ductile alloy
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  1. Review and prospect of solderable tin - based binary alloy plating

    可焊性錫基二元合金鍍層研究的現狀與展望
  2. New alloy development is expensive and fully characterization is time consuming.

    發展新合金很費錢，而且獲得全面性能很費時間。
  3. High performance and high precision copper and copper alloy strips, electrolytic copper foil, lead frame, copper clad and printed - circuit board, special enameled copper wire, fashioned copper bar, track contact wire, medium and high elastic copper strips for interconnecting devices, precision alloy copper pipes for ac and cooling appliance, over - long and corrosion - resistant copper alloy condenser pipe, seamless cooper water pipe in housing construction and other copper fine and deep processing products will be highly developed in jiangxi province

    江西將重點發展高性能高精度銅及銅合金板帶、電解銅箔、引線框架、覆銅板及印刷電路板、特種漆包線、異型銅排、軌道接觸線、接插元件用中高彈性銅帶材、空調與製冷精密合金銅管、超長耐腐蝕銅合金冷凝管、建築用無縫銅水管等10項銅精深加工產品。
  4. : 36 < kth < 37 mpa / m3 / 2, 42 < kih < 44mpa / m3 / 2, 51 < kc < 52 mpa / m3 / 2 through the sem fractography, it is know that the susceptibility to brittle failure at room temperature is more than below 100 ?. and the susceptibility to brittle failure increase with hydrogen increasing, under the sustained loading, ductile cracking appears. the quantity of brittle cracking is more with crack growth

    T44mpa m 『 q ， sl lt52mpa in 』 」斷口分析表明，該合金充氫后其室溫時的氫脆敏感性大於100oc時的氫脆敏感性；且隨氫含量升高，氫脆敏感性增加：在恆載荷的作用下，該合金裂二紋開始擴展時顯示的是韌性起裂；隨裂紋增長，試樣脆性斷裂的比例增大。
  5. One of the most promising properties of glassy metals is their high strength combined with high malleability

    玻璃金屬的一個最有前途的特性，是它的高強度與高延展性相結合。
  6. Microforming progress of bulk amorphous alloys in supercooled liquid region

    大塊非晶合金在過冷液相區微塑性成形的研究進展
  7. In this thesis, previous research works on mg - based hydrogen storage materials have been reviewed. on this basis, the following works have been carried out : firstly, the part of ni in mg2ni alloys was partial substituted by the transition element cr. the effect of element cr and mechanical alloying on the phase structure and hydrogen storage properties of mg2nii. xcrx ( x = 0, 0

    本文在對國內外鎂基儲氫材料的研究進展進行了文獻綜述的基礎上，著重對以下兩方面內容進行了研究： （ 1 ）用過渡族元素cr對mg _ 2ni合金進行了元素替換，研究了mg - ni - cr三元合金的晶體結構、微觀特徵以及吸氫動力學性能。
  8. Zircaloy - 4 is generally used as fuel tubes in pressurized water reactors because of it " s low neutron absorption cross - section, excellent corrosion resistance, good strength and ductility

    由於鋯4合金具有低的中子吸收截面，良好的抗腐蝕能力、高強度以及延展性好的特點，被廣泛用於壓水堆作為核燃料棒的包殼材料。
  9. Current status and research development trends for zinc - nickel alloy coatings by electroplating in alkaline solutions

    強堿性溶液電鍍鋅鎳合金研究進展
  10. The hydrogen permeation experiment of manet ii with hot dipping aluminized coating was performed in temperature range of 300 to 450, in gas phase and in liquid pb - 17li phase

    在300 450溫度范圍內，分別在氫氣相和液態鉛鋰合金相中開展了帶熱浸鋁塗層manet馬氏體鋼的氫滲透性能研究。
  11. It is meaningful toe arry o ut s tudy one ffect o f microstructure and interstitial c ontent on cryogenic properties of these two near a titanium alloys and will promote the application of newly developed alloys in cryogenic engineering

    開展顯微組織以及間隙元素含量對近鈦合金低溫性能影響的研究，對促進我國自創的低溫鈦合金系列材料在低溫工程中的推廣和應用具有重要意義。
  12. This article introduced the development and ti - based brazing material used for titanium alloys, and analyzed the relationship between metallurgical structure and mechanical property of welding joint, mechanical behavior under high temperature 、 corrosion resisting property and fatigue capability of the joint were also represented

    本文介紹了鈦合金用的鈦基釬焊料的發展現狀，重點評價了鈦基釬料釬焊后組織與力學性能的關系，以及鈦基釬料的高溫力學性能、耐蝕性以及疲勞性能等。
  13. Application status of die casting non - ferrous alloy is surve yed. comparison between chemical composition of die casting non - ferrous alloy at home and abroad is offered. some common considerations existing in application a re offered and reason for defects formation and resolving methods are analyzed. d evelopment tendency of die casting non - ferrous alloy is introduced

    概述了有色壓鑄合金的應用現狀，列舉了國內外有色壓鑄合金化學成分對比，提出了它們應用中存在的一些共性問題，分析了產生這些問題的原因及防止措施，介紹了有色壓鑄合金發展趨勢。
  14. But when heavyly loaded, the former is far better than the latter. the wear resistance of za27 alloyed with mn is no obviously better than that of common za27 alloy. under the sliding friction conditions, the wear resistance at high temperature of za27 is improved by alloyed si and reaches the highest level when the content of si is 1 - 3wt. %

    裂紋主要始於脆性相si相和mn相，裂紋沿晶界擴展；在滑動摩擦條件下（常溫） ，含si的za27合金在載重較小時，耐磨性與普通za合金相比沒有明顯提高，但在載荷較大的情況下，其耐磨性遠高於普通za27合金材料；加mn的za27合金與常規za27合金相比，耐磨性沒有明顯提高；在滑動摩擦條件下， si的加入提高了za27合金的高溫摩擦性能。
  15. ( 5 ) establishing the measuring metallographic expert database with multi - modes express, obverse - contrary deduce method, fuzzy mathematical model pattern matching based on regulations. its reliability, accuracy and reappearance can satisfy requirement of quantitative analysis of metallographic microstructure. the system has great theoretical and practical significance in setting up quantitative relation among the composition, microstructure and mechanical property, selecting appropriate material, customizing suitable process and developing quantitative metallographic

    廣東工業大學工學碩士學位論文利用本系統對金相組織自動分析的可靠性、準確性能滿足一般定量金相分析的要求;它對于建立金屬材料成分、組織與性能之間的定量關系、合理地選擇金屬材料、制定合適的加工工藝、發展定量金相都具有重要的理論意義和使用價值。
  16. Furthermore, the supposition of galvanic couple is drawn into the procedure of corrosion fatigue crack growth of aluminum alloys, the relation of couple current vs loading time is determined with electrochemical methods. a formula in the theory is deduced which expresses the stress corrosion crack growth rate of lc4cs aluminum alloy, the results of mathematical modeling preferably correspond with examination

    再將「耦合作用」的猜想，引入鋁合金的腐蝕疲勞裂紋擴展過程中，用電化學的方法測定耦合電流與加載時間的關系，並從理論上導出lc4cs鋁合金應力腐蝕裂紋擴展速率的數學表達式，數學模擬的結果與實驗值具有較好的一致性。
  17. In rescent 10 vears in our counrtry, some excllent enterprises, such as hair, also used this instrument and achived a great success. this is a good example for zigong cemented carbide co. ltd. but zigong cemented carbide co. ltd has its own character, and has to be considered its own specialty and its location when using capital instrument. only when the company connect these two sides organically, then the realistic strategy target can be drawn up and the developing location can be chosen. under guidline of the detailed mergence. purchasing, reorganization and investment ' s policy with hard effort and work, the zigong cemented carbide co. ltd future should be glorious and the company ' s developing t - arget should come true

    但是，自貢硬質合金有限責任公司有其特殊性，在運用兼并、收購、重組、投資等資本運營手段時要考慮自身特點、公司地理，要考慮資本運營手段的原則、特點的方法，要考慮創造性地將兩者有機結合起來，制訂出更加切實可行的戰略目標，選準定位，並在具體的兼并、收購、重組和投資策略指導下，奮發努力，扎實工作，這樣，自貢硬質合金有限責任公司的前景必將更加美好，公司的發展目標必將得到實現。
  18. A general consensus exists related to the influence of slow crack propagation ahead of the crack tip upon the nonlinearity observed in the typical load - deflection response of the concrete specimen, namely, concrete exhibits somewhat quasibrittle behavior, which has been verified by the inapplicability of the conventional linear elastic fracture mechanics ( lefm ) and fracture models suitable for metal - like materials

    現在已經意識到，混凝土在其典型的位移曲線中呈現出的非線性特徵是由於裂縫在端部的緩慢擴展引起的，可以認為是混凝土的一種半脆性性能。這是在發現傳統的線彈性斷裂力學（ lefm ）和適合金屬類材料的斷裂模型不適用於混凝土研究時得出的結論。
  19. In order to strictly control the blind development of some special kinds of consumer goods and goods in over - supply, no locality may reduce or exempt product taxes or value - added taxes on tobacco, alcoholic beverages, firecrackers, fireworks, clocks, watches, bicycles, sewing machines, electric fans, refrigerators, motorcycles, washing machines, vacuum cleaners, air conditioners, electronic keyboards, pianos, tv sets, tape recorders, cassette players, video cassette recorders, electronic video games, pull - top cans, canned beverages, aluminum doors or windows, architectural decorations, kilowatt - hour meters, saccharin, adhesive clay bricks or tiles, cosmetics for the skin and hair, and articles for use in a memorial ceremony, which are produced or marketed in that locality, regardless of the ownership or type of enterprise

    一、為了嚴格控制某些特殊消費品、長線產品的盲目發展，無論什麼性質和類型的企業，生產銷售的煙、酒、鞭炮、焰火、鐘、表、自行車、縫紉機、電風扇、電冰箱、摩托車、洗衣機、吸塵器、空調器、電子琴、鋼琴、電視機、錄音機、放音機、錄像機、電子游戲機、易拉罐及易拉罐飲料、鋁合金門窗及建築裝飾材料、電度表、糖精、粘土磚瓦、化妝品、護膚護發品、焚化品，各地一律不得減免產品稅、增值稅。
  20. The experimental results show that the quality of zno films prepared by electron beam evaporation can be greatly improved by means of two - step annealing of metallic zn films in oxygen ambient, and it is feasible to fabricate high quality mgxzn1 - xo alloy films with mgo buffer layers by using thermal evaporation technique following by two - step annealing process. this method gives a new path to prepare mgxzn1 - xo alloy films

    實驗結果表明利用電子束蒸發技術制備的zno薄膜材料，在經過氧氣氣氛下的二次退火處理后，能夠表現出較好的發光和結構特性；以mgo薄膜作為緩沖層制備出了高質量的mgzno合金薄膜材料，這為開展mgzno合金薄膜材料的研究開辟了新的途徑。
分享友人
分享到 Line

分享到臉書