層狀包合物 的英文怎麼說

中文拼音 [céngzhuàngbāogěwù]
層狀包合物 英文
layer inclusion compound
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 物 : 名詞1 （東西） thing; matter; object 2 （指自己以外的人或與己相對的環境） other people; the outsi...
  • 層狀 : banding
  1. Layered and pillared material are a kind of multifunctional material which were developed in recent years, much attention has been paid to this kind of material for its application in ion - exchange catalysts solid state proton conductivity, nonlinear optics and physic. a lot of literature have reported the intercalation behavior of a - zirconium phosphate ( abbreviated as a - zrp ), different guest molecules inserted into a - zrp have been studied in detail, those guest molecules include amine, alcohok amino acid protein, enzyme coornadiate compound and coronal compound. the intercalation guest is restricted by their size and basicity

    層柱材料是近年來發展起來的一類多功能材料，由於其在離子交換、催化、固態質子導體、非線性光學以及醫學等方面的廣泛應用而受到國內外研究者的重視，大量文獻報道了-磷酸氫鋯zr （ hpo _ 4 ） _ 2 ? h _ 2o （ - zirconiumphosphate ，縮寫為- zrp ）的超分子插層化合物及插層性能，其中對不同的客體分子對磷酸鋯的嵌入做了詳細的報道，客體分子的種類包括氨、醇、氨基酸、蛋白質、酶、配合物、冠狀化合物等。
  2. Take middle - east district of taipusi banner as study area in the paper, combining field observation test ( pumping test and field survey ) with indoor experiment ( granule analysis and organic matter analysis etc ), based on the relationship between hydrological parameters and physical - chemistry characteristic parameters of formation, the variability of aquifer parameters and physical - chemistry parameters of unsaturated zone have been also analyzed. the aquifer system of the taipusi banner is identified and analyzed by using the internal and outside information. on the basis of real pumping of ground water, the water resources evaluated by the water balance method

    本文以太僕寺旗中東部地區為研究區域，採用野外試驗（抽水試驗、實地調查）和室內實驗（顆分、有機質等實驗）相結合的方法，推求了研究區含水層系統的水文水利參數，在系統模擬含水層水理參數與巖性物理化學特徵參數之間的關系基礎上，進一步分析了含水層參數及其包氣帶的物理、化學特徵參數的空間變化特徵，並利用其內外部信息對太僕寺旗含水層系統進行了辯識與分析；以現狀地下水開采量為依據，採用水均衡法評價了研究區水資源總量，並利用有限單元法來模擬分析驗證。
  3. However, the die attach layer delaminated after 500 cycles and pcb cracked in the underfilled samples after long time cycling. c - sam is employed to investigate the delamination in the underfilled samples. highly concentrated stress - strain induced by the cte mismatch between the bga component and the pcb board, coarsened grain and two kinds of intermetallic compounds ( nisn / nisns ) which formed during reflow and thermal cycle and their impact on the reliability of solder joints are discussed in this paper

    充膠樣品粗化尤為嚴重； ? ni - sn金屬間化合物包括兩層：其中，靠近ni焊盤的那層比較平整，同時， eds結果分析表明其化學式近似為nisn ，而靠近焊料的那層呈板條狀，化學式近似為nisn _ 3 ，文獻表明其為亞穩相； ?充膠使得樣品最大應力范圍降了接近一個數量級並降低了dnp的作用，同時，器件失效模式變為晶元粘接層分層； ? c - sam結果表明本論文採用的充膠樣品，晶元粘接層分層起始於500周左右，而經過2700周循環的樣品，分層幾乎擴展到整個界面。
  4. This work aims at studying multi - scale structures of large - scale stratiform precipitating clouds typical of henan province of central - eastern china in spring and autumn drought periods of china, the potentials and techniques of artificial rain increase. through analysis of historical weather / climate and cloud physical data, developed are a number of multi - scale observational schemes including intensive observational items, and space / time resolutions of data for integrative field observations to obtain real - time measurements of the structures at large -, medium -, small - and micro - scale. from analysis of observed separate items, their integrative treatment and numerical simulation we place focus on case studies and their integration in investigating such structures of stratiform precipitating clouds over the target region, rainfall physical mechanisms and exploitation of artificial rainfall increase potentials, whereupon a conceptual model is constructed and a range of catalysis schemes are proposed to improve smaller - scale forecasting accracy and techniques for the rainfall increase, with the dominant results given below

    以地處中原、具有典型代表意義的河南層狀降水雲系為主要研究對象，在對該地歷史天氣氣候和雲物理等資料分析的基礎上，研究設計雲系多尺度觀測方案（包括加密觀測項目、觀測時空解析度） ，實施有設計的外場綜合觀測，獲取雲系結構多尺度（大、中、小、微）配套的實時觀測資料；通過對各種觀測資料的分項和綜合處理分析，以典型個例觀測和數值模擬分析研究為重點，綜合多個例分析，研究河南層狀降水雲系多尺度宏微觀結構特徵、降水物理機制和人工增雨潛力條件，建立典型層狀雲系人工增雨概念模型，研究科學的人工增雨作業技術系統。
  5. This thesis focuses on the study of the layered lithium nickel - based oxides as catho de materials lithium - ion batteries, the main aspects follow : 1 study on the synthesis and properties of linixco1 - xo2 by the sol - gel method compared with solid - state method, sol - gel method enjoys the advantage of lower calcining temperature and small uniform particle size of products. after the xrd measurement, it was shown that the single - phase layered compound can be prepared in sintering temperature of 750 for 6 ~ 8 hours. the sintering temperature, the properties and the amounts of doping materials can all affect the product ' s phase, and its structure ( lattice parameter, crystal phase distance )

    本論文的研究工作主要集中在作為鋰離子電池正極材料的層狀鋰鎳基氧化物上，包括以下幾個方面： 1溶膠凝膠法（ sol - gel ）合成lini _ xco _ （ 1 - x ） o _ 2的研究與固相合成法相比，溶膠凝膠法合成lini _ xco _ （ 1 - x ） o _ 2煅燒溫度低，產物顆粒均勻一致，經過xrd的測試過后，結果表明750下燒結6 8小時，即可得到單相產物；燒結溫度，摻雜劑的種類及摻雜劑量均對產物物相的形成產生影響，並對產物的結構產生影響。
  6. ( 1 ) two edt monomer synthetic paths have been investigated. ( 2 ) using the method of depositing the pedt film on the glass base, the affect of processing and environmental conditions - - such as the polymerizing temperature, the state of the polymer material, the polymerization correctives, the drying temperature, and the amount of the solution etc. - - to the pedt material ' s electroconductivity has also been examined in this paper

    主要研究內容包括： （ 1 ） edt單體合成路線的兩種方案，以及具體的制備過程； （ 2 ）在玻璃基片上淀積pedt膜層，研究了聚合溫度、聚合物狀態、聚合改良劑、烘乾溫度、溶劑含量等工藝及環境條件對pedt材料電導率和成膜速度的影響。
  7. The full thesis is divided into five chapter : in chapter 1, it mainly discusses the research history and present condition of the traditional dwelling, elaborates the main purpose and meaning of the research, and definite a few definitions of basic concepts involved by this thesis ; in chapter 2, it mainly elaborates the main characters of the traditional yard - outside and patio - inside dwelling architecture in xiangnan ;, including the comprehensive treatise toward the person ' s subjective construction characteristics, the objective technique condition characteristics and social cultural characteristics etc. ; in chapter 3, there has a comparison to the traditional dwellings who has the typical model region features in the southern and northern. through analyzing, it puts forward that the traditional yard - outside and patio - inside dwelling architecture has the characteristics which are between the southern and northern dwellings ’ ; in chapter 4, fore the noodles ’ elaboration, it discusses how the traditional yard - outside and patio - inside dwelling architecture in xiangnan can be built, including the material reasons and the spirit reasons, the end got it to construct five main reasons that the appearance become : the objective environment factor, culture factor, the influence of the population flowing, the code institutions and the clan system and the social ideology at that time etc. ; in chapter 5, it introduces the existence conditions of the traditional yard - outside and patio - inside dwelling architecture in xiangnan, putting forward some viewpoints and measures on protection and renewing

    全文共分為五章:第一章緒論主要論述了傳統民居的研究歷史和現狀、闡述了研究的主要目的和意義、界定了本文所涉及的幾個基本概念的界定;第二章主要闡述了湘南外庭院內天井式民居建築的主要特徵，包括對人的主觀營造特徵、客觀的技術條件特徵以及社會文化特徵等的綜合論述;第三章則是對南北方具有典型地域特色的民居建築進行簡明地比較分析，提出湘南外庭院內天井式民居建築具備南北方民居建築構成要素的二重性特徵;第四章在前面闡述、分析的基礎上，論述了湘南外庭院內天井式民居建築的成因，包括物質層面和精神層面的多重考察和論證，最後得出了其建築形態形成的五個主要原因:客觀環境因素、文化交融的影響、人口流動的影響、禮法與家族制度以及當時的社會意識形態等，其中最主要的成因是南北方文化交融的結果;第五章，在湘南外庭院內天井式民居建築的現有存在狀況的基礎上，結合自己參與的一個民居保護項目，對民居保護與更新談了些粗淺看法。
分享友人
分享到 Line

分享到臉書