峰值間距 的英文怎麼說

中文拼音 [fēngzhíjiānjù]
峰值間距 英文
peak separation
  • 峰 : Ⅰ名詞1. （山的突出的尖頂） peak; summit 2. （形狀像山峰的事物） peak-like thing Ⅱ量詞（用於駱駝）
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  • 間距 : interval; separation; spacing; espacement; space; spacing; space length; range; unpack; step
  1. After analyzed the basic principle of optimized noise reduction on tyre pattern, summarized three approaches to noise reduction. the first is trying to reduce size of single block or socket to reduce noise amplitude on time domain, the second is to adjust stripes sorting order and their interlace value to avoid noise - made by every single block - peak values on time domain overlayed and the last is to adjust ratio of blocks and sockets, ratio of stripe interval and stripe sorting order to avoid noise periodical distribution and abnormal high peak values in some frequency strip

    論文第四章分析了輪胎花紋優化降噪的基本原理，總結出三條降噪途徑：在允許范圍內盡量減小單個塊或槽的大小、刻刀槽軟化花紋塊來減小噪聲時域波幅度；調整節距排列順序、花紋條之間的錯位值，使各發聲單元發出的聲壓時域波形的同向峰值錯開，避免同向峰值疊加；調整花紋塊和槽比例、節距比例、節距排列順序，盡量避免周期性分佈，使輪胎所發出的噪聲趨于白噪化，避免某些頻段的異常高峰值。
  2. Based on the analysis about the test requirements and the saturated magnetization of the armor plate, the excitation magnetic circuit satisfying the testing condition and a validation system are designed. because the geometric, of the magnetic leakage at the direction of the normal of the roundness fault has the feature of two peaks : a positive and a negative, using the linear regression and the software matlab, two regression equation are proposed : one is about the peak value of the magnetic leakage and the diameter and depth of the roundness fault ; the other is the distance between the two peaks and the diameter of the roundness fault. the result of the validation system proves that the two equations are valid, and an applied method using for quantificationally inspecting the roundness faults is proposed according to the two equations

    根據實驗要求，通過對鋼板達到飽和磁化的必要性進行的分析，設計了符合試驗條件的勵磁磁路，並設計了一套實驗驗證系統；根據圓形缺陷法線分量漏磁場幾何圖形正負雙峰值的特點，採用線性回歸擬合的原理和matlab軟體及其統計工具箱中的相關函數，給出了圓形缺陷漏磁場幾何圖形的峰峰值與圓形缺陷的直徑和深度以及峰峰值間距與圓形缺陷直徑的兩個回歸擬合方程，並通過實驗驗證系統驗證了擬合方程的正確性，利用這兩個簡單實用的擬合方程，提出了一種工程定量檢測圓形缺陷的應用方案。
  3. In addition, effects of several factors such as local site conditions, focal mechanism, epicentral distance and seismic magnitude on these parameters are discussed, and several significative results and conclusions are obtained. in all records there are about 1 / 3 vertical ground motion ’ s peak acceleration bigger than 2 / 3 of the corresponding horizontal one, so the action of vertical ground motion should not to be underestimated. vertical design response spectrum equals that the horizontal design response spectra times 65 % is probably unsafe when period is short, and suggest adopting different coefficients when at different periods

    本文基於對大量歐洲強震記錄的研究，分析了地震動豎向與水平向分量在峰值加速度、反應譜值、頻譜周期等參數方面的差異，以及這些參數與場地、震源機制、震級和震中距的關系，得到了以下有意義的結果和結論:在本文分析的地震記錄中大約1 / 3的記錄加速度峰值比大於2 / 3 ，豎向地震動分量的作用不可低估;在短周期，豎向地震動影響系數的最大值僅取為水平向地震動影響系數最大值的65 %是偏於不安全的，可以考慮按周期分段採用不同的折減系數;我國現行抗震規范中設計反應譜特徵周期的取值偏低，可能是偏於不安全的;豎向與水平向地震動分量卓越周期的比值在0 . 7 - 0 . 9之間，豎向設計反應譜的特徵周期應有單獨規定。
  4. In the plate region of a vehicle image, the gray value varies frequently in cross - direction, so we define a parameter ". cross variance " to describe it. we also calculate other parameters to approximately locate the plate, they are the space length between two chars, the thickness of stroke, the peak and trough of gray value, the ratio of width and length, etc. at last, we exactly locate the plate by the theory of mathematical morphology

    該方法根據圖像車牌區域橫向灰度值變化頻率比較大這一特徵提出了橫向方差參數，並結合車牌的字元間距、筆劃粗細、灰度峰谷值、長寬比值等特徵粗定位車牌，在車牌的精確定位中利用了數學形態學的方法。我們從某高速公路收費站實地拍攝的照片中選取了1000多幅作為實驗樣本數據。
  5. The distance between peaks increases as the thickness is reduced.

    峰值間的距離隨厚度的減薄而增大。
  6. Based on the theoretical analysis and experimental researches, it is presented that the wider spectra are resulted from the many fluorophores with large numbers of vibrational energy levels on the ground level in the blood cells, and the reduction of the spectral intensity is due to the reabsorption of the blood cells and the energy transfer of the collisions between the fluorophore and another one or other macromolecule. on the other hand, when the concentration of the blood cells is increased, the reabsorption of the blood cells, the secondary fluorescence due to the reabsorption and the influence of the concentration on the energy levels of fluorophores are all the factors of the red - shifted spectral peaks

    在進行理論分析和研究的基礎上，提出了因血細胞中存在多種熒光團，且這些熒光團的電子能級上又存在大量的不同的振動能級，從而導致被激發的熒光團發出較寬的熒光光譜；血細胞濃度的增大，熒光團以及其他大分子之間的距離變小，造成它們之間因碰撞的能量轉移概率加大，因而易產生熒光猝滅，結果導致熒光強度的變小；血細胞溶液中重吸收所導致的熒光猝滅和二次熒光發射，以及血細胞濃度的變化對其中熒光團能級系統的影響都是導致熒光峰值波長「紅移」的原因；進而研究了led光誘導血細胞產生熒光光譜的機理。
  7. This paper confirms a kind of non - linear mapping relation between vibration velocity of particles on building and the influence factors, such as total explosive charge, maximum explosive charge fired at the same time, the distance between blasting point and monitoring points, peak particle velocity of ground where building is, the height from monitoring point to ground, and so on, and sets up a support vector machine ( svm ) model for forecasting the vibration effect induced by an explosion

    應用支持向量機，建立了總藥量、最大段藥量、爆破點與監測點距離、構築物所在地面震動峰值速度、測點到地面的高度等因素與建築物上的質點震動速度之間的非線性映射關系，確立了支持向量機預測模型。
  8. First, according to the demand of vimp for resin system, the reaction kinetics and rheological of up resin are investigated and the optimal content of low additive profile ( lpa ) is determined. then vimp based on a high - permeable medium and grooves are studied by visual experiments, through which the appropriate high - permeable mediums are selected and the parameters of width, depth and spacing for flow grooves and spacing for supply grooves are optimized. furthermore, various factors affecting the mold filling process are discussed and the whole vacuum infusion procedures are described taking examples of the manufacture of a model boat and a sandwich panel in one infusion

    文中首先根據vimp對樹脂體系的要求，對vimp用不飽和聚酯樹脂體系的動力學和流變學性能進行了研究，確定了最佳低收縮添加劑的含量；對高滲透介質型和溝槽型vimp開展了實驗研究，通過可視化實驗優選出較好的高滲透介質，確定了引流槽的寬度、深度和槽間距及主槽的槽間距等工藝參數並進行了優化；對影響充模過程的各種因素進行了詳細的討論，並以模型船和夾芯面板的製作為實例描述了兩種vimp的成型過程；在實驗的基礎上，建立了二維滲漏模型，採用控制體有限元法對高滲透介質型vimp進行了成型過程的計算機模擬計算，通過充模時間和流動前峰的計算值與實驗結果的比較，驗證本文所採用的數學模型和數值方法的正確性，其結果對實際生產具有一定的理論指導意義。
  9. With white background, the acquired images were studied. the distance was max between two - peak value in b gray level histogram. a set of computer vision hardware system which is use for bruise evaluation and classification of tomato was set up

    通過大量的實驗研究，選擇環形燈作為光源，選擇白色作為背景組成光照箱，可以得到有利於后續處理的圖像；並發現在b分量上，兩峰間的距離最大，所以用b分量確定闡值t ；建立一套適合番茄等農產品進行表面缺陷自動檢測與分類的計算機視覺硬體系統。
  10. In order to assess the performance of the proposed methods, we propose three types of image measures to quantify the performance compared to some other methods. the first type evaluates the fidelity of the reconstructed image by computing the peak signal - to - noise ratio and euclidean distance in cielab color space between the original and reconstructed image in smooth and edge regions respectively. the second type accounts for a major artifact ? zipper effect

    為了評估演算法質量，本文採用了三類評估手段:一是分別計算原始圖像與重構圖像在平滑區域與邊界區域的峰值信噪比與cielab顏色空間的歐氏距離來分析重構圖像的保真度;二是利用數學手段對重構圖像的一類主要失真現象? ? zipper效應進行定量評估;三是對硬體實現的成本與實際可行性進行了分析。
  11. There are some distance between the tested performances and theoretical peak values because of high systematic cost and access memory delay, but they all satisfy the performance requirements of the confidential server

    由於系統開銷和訪存延時等原因，通過操作系統進行的以上測試的性能雖然與理論峰值性能間存在一定差距，但均達到高性能密碼服務器的性能要求。
分享友人
分享到 Line

分享到臉書