工作主偏角 的英文怎麼說

中文拼音 [gōngzuòzhǔpiānjiǎo]
工作主偏角 英文
working cutting edge angle
  • : Ⅰ名詞1 (工人和工人階級) worker; workman; the working class 2 (工作; 生產勞動) work; labour 3 ...
  • : Ⅰ形容詞1 (不正; 歪斜) inclined to one side; slanting; leaning 2 (只側重一面) partial; prejudi...
  • : 角Ⅰ名詞1 (牛、羊、 鹿等頭上長出的堅硬的東西) horn 2 (古時軍中吹的樂器) bugle; horn 3 (形狀像...
  1. Second, by computing the trajectory of the missile and the method of analyzing cep, influences that the fighter ' s height, speed, pitch angle, the deflection angle between fighter and target, and the target moving characters make on the times of fighter attack and missile launch are deeply developed. third, by relating the motion of the missile and the fighter, the influences that fighter ' s dive angle and the deflection angle between fighter and target make on the attack field of the fighter are discussed in this paper when the fighter perform vertical and horizontal attack. criterion of attack effect is proposed focusing on attack time of the fighter, trajectory of the missile and destruction probability to the target

    本文要完成了以下幾個方面的:對導彈可發射區和飛機可攻擊區進行建模,通過對導彈彈道的模擬計算,並運用典型的圓概率差精度分析方法,詳細討論了飛機實施攻擊時,飛機的飛行高度h 、速度v 、俯仰、與目標的_ x及目標運動特性等對飛機攻擊時機和導彈發射時機的影響;因此,將飛機和導彈結合起來,詳細研究了飛機在垂直平面和水平平面內實施攻擊時,飛機俯沖和與目標的_ x對飛機的攻擊范圍的影響;以飛機實施攻擊的時間t 、彈道特性和對目標的殺傷概率p來評判對地攻擊的效果;最後給出典型算例,通過對空地攻擊過程的模擬實現,對飛機飛行過載提出要求。
  2. Analysis indicates the " low pressure closed reticular flow region " results in the non - equilibrium of pressure along the primary jet ' s orifice. to obtain as large vectoring angle as possible, the optimal ranges of angles, frequencies, velocity amplitudes, and distances from the microjet actuator to the primary jet exit were discussed. the relationship between the vectoring angle of the primary jet and the phase - difference of two adjacent actuators was analyzed

    分析了「拉」模型單動器模式下,微射流動器的入射度、驅動頻率、速度幅值及與射流間的距離對射流轉程度的影響,並確定了動器參數的最佳范圍;分析了「拉」模型雙動器模式下,不同的相位差對轉程度的影響。
  3. Biology, etc. owing to many merits has not yet been used to measure parameters of gratings. the paper researches on the subject in view of current lack of it. the main tasks of the paper include : analyzing ellipsometric characteristics of gratings in detail with vector diffraction theory and ellipsometrics ; devising a reflective quarter wave plate at normal incidence according to some ellipsometric characteristics ; making use of normal simplex algorithm during ellipsometric inversion of gratings parameters, inversing ellipsometric parameters with gaussian noise of different standard deviations to simulate actually measured values with examples of isotropic metallic and anisotropic step gratings and testing that ellipsometry about gratings parameters is feasible with the range of certain precision ; discussing choice of incidence angle at length

    本論文的包括:結合光柵的矢量衍射理論和薄膜的橢理論,詳細分析了光柵的橢特性;並且根據一些橢特性設計出一款正入射反射型單波長1 4波片;在光柵參數的橢反演中,引入正單純形法為反演演算法,分別以各向同性的正弦形金屬光柵和各向異性的階梯型光柵為例,在標準橢值的基礎上加入不同差的高斯噪聲來模擬實際的橢測量值進行反演,在一定精度范圍內得出滿意的光柵參數,說明光柵參數的橢測量是可行的;還就入射的選取問題進行了一定的探討。
  4. Based on the theory of glow discharge, the angle distribution of electron and the recombination process are simulated by adopting monte carlo method. the doping process of n - type diamond film is investigated by this method for the first time. the results indicate : 1 ) the scattering angle of electrons near the substrate is mainly lange - angle, which is helpful to grow diamond film over a large area when glow discharge is kept ; 2 ) after considering the recombination process, the number of particles distribution is provided

    要結果如下: ( 1 )研究了電子在雪崩碰撞和分解電離后的分佈情況,結果表明基片附近電子的散射以大散射為,在維持輝光放電的條件下,較高的壓和氣壓對金剛石的橫向連續成膜是有益的; ( 2 )考慮了低溫合成金剛石薄膜過程中電子與各種碎片粒子的復合過程,給出了不同的復合系數情況下的粒子數分佈,結果顯示各種碎片粒子的分佈隨復合系數的變化會出現粒子數分佈的漲落現象。
  5. In the field job the visual angle of researcher is easy to be affected by the prejudice with first impression

    在田野中,研究者的視很容易被先入為見所影響。
  6. Whereas, vdsc operates on physical limits of large vehicle slip angle and lateral acceleration, and enhances vehicle lateral stability by utilizing the additional yaw moment produced by different adhesion forces acted on the right and left side wheels

    而vdsc系統要在車輛大側向加速度、大側的極限況下,通常利用左、右兩側車輪附著力之差產生的橫擺力矩來達到穩定性控制目的。
分享友人