工作壓力水頭 的英文怎麼說

中文拼音 [gōngzuòyālìshuǐtóu]
工作壓力水頭 英文
working-pressure head
  • 工 : Ⅰ名詞1 （工人和工人階級） worker; workman; the working class 2 （工作; 生產勞動） work; labour 3 ...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 水頭 : waterhead; head; flood peak水頭落差 head fall; 水頭坡降 water table gradient
  1. This paper analysed working principles and controling features of water lifts about the head pressure transition. plc was used to operate controling system so as to work the system well

    摘要對水頭差壓力轉換提水裝置的工作原理及控制特點進行了分析，使用可編程式控制制器（ plc ）控制系統運行，使系統很好的工作。
  2. ( 4 ) through the hydraulic property experiment of micro - hole lateral pipes of simple sdi in air, it was found that the average pressure of 60 mitre length lateral pipes was at the position of per 40o / o ~ ~ ~ 50 % of the effectual pipe length from the fist micro - hole, major pressure - loss was occurred at the ahead part of half pipe. the pressure uniformity reduced with orifice aperture ? increasing, and the relationship between pressure uniformity and initial water pressure was poor. running under the initial water pressure of 1. 5 meter, the discharge uniformity reduced with orifice aperture ? increasing, and when the orifice aperture smaller than or equal 1. 0mm, irrigation uniformity could achieve above 0. 6

    （ 3 ）通過對空氣介質中簡易地下滴灌的微孔毛管試驗研究發現： 60m管長的毛管平均壓力水頭的位置基本上在距第一孔口的有效管長40 - 45的地方；大部分水頭損失發生在毛管的前半部分；壓力均勻度隨孔徑的增大而減小，但與初始工作水頭關系不密切；在1 . 5m以下的工作壓力下運行，沿程出流均勻度隨孔徑的增大而降低，當孔徑不大於1 . 0mm時，灌水均勻度可以達到60以上；當孔徑大於等於1 . 2mm時，灌水均勻度低於50 。
  3. The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87. 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis, not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi

    得出了以下結論：在8792mpa的載荷下筒體一封頭連接結構處的集中剪切帶貫穿韌帶，可能發生沿與原裂紋線成155 「角方向剪切型斷裂；筒體一封頭連接結構不可能發生韌窩型斷裂； （ 2 ）在工作壓力下進行次數不多的反復加、卸載，結構不會破壞，也不會喪失安定性：結構在工作狀態下是安全的； m在本文的彈塑性有限元模擬計算中，對于裂紋尖端進行力學分析時，不考慮壓力容器製造過程中水壓試驗的影響，將導致計算結果出現較大的偏差； （ 4 ）筒體完全屈服時的載荷為92石3mpa ，封頭完全屈服時載荷為86
  4. Based on experimental result of energy dissipation and scour protection for downstream of spillway at yu jian kou power station, this paper discusses the flow characteristics, aerated characteristics of flaring gate pier for low dam pivot, the influence on pressure of dam surface and the result of energy dissipation for flaring gate pier. it is put forward to be an available method to solve the problems of energy dissipation and scour protection for depth of covering strata, poor geologic condition and weakness of resistance to scour capability under reasonable use of flaring gate piers and auxiliary dissipaters. thus, a new method is obtained for release of floodwater and energy dissipation of low dam pivot which are provided with low water head, great unit discharge and low froud coefficient. it may be used for reference for design and test workers

    結合魚劍口電站壩下消能防沖試驗研究成果，對低壩樞紐寬尾墩的水流特點、摻氣特性、寬尾墩對大壩泄流能力和壩面壓力的影響以及寬尾墩的消能效果等問題進行了初步探討，提出了合理地使用寬尾墩結合輔助消能設施可有效地解決壩下覆蓋層深，地質條件差，抗沖能力弱的低壩樞紐的消能防沖問題，從而為具有低水頭，大單寬流量，低佛氏數特點的低壩樞紐泄洪消能開辟了一條新途徑，可供有關低壩樞紐設計與試驗工作者借鑒與參考
  5. According to these, the paper put forward some countermeasures : select low carbon steel or low metal alloy steel with lower intensity, like 20r steel ; while welding, adopt strict craft measures with lower welding heat to input ; after jointing, proceed the whole hot dissolving on time ; control each welding joint with hardness hb 185 ; add 0. 25 % water into the liquid ammonia as decay eclipse ; enhance checking in operation, repairing equipment in time through regular interior and exterior checking

    針對上述原因提出了防止氨冷器類臨氨壓力容器產生應力腐蝕裂紋的對策：選用強度稍低，但抗裂性較好的低碳鋼和低合金鋼，如用20r鋼製造；焊接時應採用嚴格的工藝措施和較低的焊接熱輸入量；焊后應及時進行整體消除應力熱處理；控制焊接接頭各區硬度hb 185 ；在液氨中添加0 . 25 %的水作為緩蝕劑；在運行中加強檢查，及時進行停車檢修時的內外部檢查和定期檢驗。
  6. For the sake of the research about hydroelectric interfere among machines, the article utilized the simulink in matlab as simulating tool, meanwhile established the simulating model about two high head diversion water turbines regulation system in violent fluctuating pressure sharing one head race tunnel and surge tank and one penstock. then calculated the load rejection transition process by means of the real parameters of a hydro power station, analysed the interfere of hydro power station safety and stable nenring brought by hydroelectric interfere and put forward a series of measures that lightening the hydroelectric interfere

    為了研究機組間的水力干擾，本文採用matlab下的simulink作為模擬工具，建立共用有壓引水管道、調壓井、壓力主管的兩臺高水頭引水式水輪機調節系統大波動時的模擬模型，引入實際電站的參數，對甩負荷過渡過程進行了模擬計算，分析水力干擾對電站安全、穩定運行所造成的影響，並提出了一系列減輕水力干擾的措施。
  7. And, the applicable conditions and the merits and shortcomings of every kind of subarea forms are compared according to the plane and vertical arrangements of buildings, water supplying pressure of cities, water tanks or pressure stabilization devices installed in buildings, working states of fire pumps and working pressure of the vertical systems and sprinkler numbers

    同時，根據建築物的平面和豎向布置、城市管網的供水壓力、水箱或穩壓裝置的設置情況、水泵工作狀態、豎向系統工作壓力要求和噴頭數進行各種系統分區，討論各種分區形式的適用條件、優缺點。
  8. The following contents are included : ( 1 ) based on the fundamental seepage theory, the basic differential equation of saturated - unsaturated seepage in porous mediums has been deduced, in which the pressure head is the fundamental unknown quantity. furthermore, the equation for rcc dam is deduced too

    主要內容包括： （ 1 ）從滲流基本理論出發，以壓力水頭為基本未知量推導多孔介質三維飽和非飽和滲流微分方程，並根據碾壓混凝土壩的特點得出適合其自身的滲流控制方程：進而對碾壓混凝土的滲流基本理論、滲流特性開展深入的研究工作。
  9. 3. testing all the hydraulic parameters of the sprinkler installed with adjuster such as working pressure, water flux, the range of the sprinkler, intensity of water drop impact, characteristic of water distribution, etc. according to the testing data, we can learn the quantitative relations among the structure of the adjuster, working pressure, diameter of the nozzle, elevation of sprinkler, wind power, velocity of rotation and the range of water

    測試安裝「壓力調節器」后的噴頭的水力性能參數，即工作壓力、流量、射程、水滴的打擊強度、噴灑水分佈特性等。依據所測得的噴頭水力性能參數和射程數據，我們可較清楚的了解「壓力調節器」的結構形式、工作壓力、噴嘴直徑、噴射仰角、風力、旋轉速度和噴頭射程之間的定量關系。
  10. Abstract : based on experimental result of energy dissipation and scour protection for downstream of spillway at yu jian kou power station, this paper discusses the flow characteristics, aerated characteristics of flaring gate pier for low dam pivot, the influence on pressure of dam surface and the result of energy dissipation for flaring gate pier. it is put forward to be an available method to solve the problems of energy dissipation and scour protection for depth of covering strata, poor geologic condition and weakness of resistance to scour capability under reasonable use of flaring gate piers and auxiliary dissipaters. thus, a new method is obtained for release of floodwater and energy dissipation of low dam pivot which are provided with low water head, great unit discharge and low froud coefficient. it may be used for reference for design and test workers

    文摘:結合魚劍口電站壩下消能防沖試驗研究成果，對低壩樞紐寬尾墩的水流特點、摻氣特性、寬尾墩對大壩泄流能力和壩面壓力的影響以及寬尾墩的消能效果等問題進行了初步探討，提出了合理地使用寬尾墩結合輔助消能設施可有效地解決壩下覆蓋層深，地質條件差，抗沖能力弱的低壩樞紐的消能防沖問題，從而為具有低水頭，大單寬流量，低佛氏數特點的低壩樞紐泄洪消能開辟了一條新途徑，可供有關低壩樞紐設計與試驗工作者借鑒與參考
  11. To meet the peaking need of the grid and improve the source structure of the system, it is necessary to construct the mass pumped storage power station. and more high pressure tunnels will be constructed

    大規模抽水蓄能電站的建設是現代電網的必然產物，它在電力系統中起調峰填谷作用，提高電網運行的靈活性和可靠性；相應高水頭大直徑水工壓力隧洞的建設也逐漸增多。
分享友人
分享到 Line

分享到臉書