幀選擇系統 的英文怎麼說

中文拼音 [zhèngxuǎnzháixìtǒng]
幀選擇系統 英文
frame selection system
  • 幀 : 量詞（幅, 用於字畫）
  • 選 : Ⅰ動詞1. （挑選） select; choose; pick 2. （選舉） elect Ⅱ名詞（挑選出來編在一起的作品） selections; anthology
  • 擇 : 擇動詞（挑選） select; pick; choose
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 選擇 : select; choose; opt; election; choice; culling; alternative
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. Then it studies the implementation, architecture and characteristic of embedded guis based on framebuffer, designs testing programs to test several embedded gui system ' s performances ( stability, efficiency ), and finally chooses qt / embedded as the development platform of the bsas. chapter 3 firstly briefly describes the embedded system hardware architecture, and then enumerates functions of system software

    在分析了若干種基於幀緩沖（ framebuffer ）的嵌入式gui的實現、體系結構和特點的基礎上，設計了測試程序對比它們在穩定性、繪圖速率等方面的性能，最終選擇qt embedded作為嵌入式系統軟體開發平臺。
  2. The performances of high - speed sdh frame aligner and selection of frame pattern

    幀同步系統性能與同步碼組選擇
  3. Qe1 achieve the whole synchronization by software and hardware. during the course of the initialization of the qe1 system, the chip pm4354 can accomplish the task of synchronization of bit, frame and multiframe after the chip initialization by the software. after pm4354 accomplishes the bit synchronization, qel will read the status registers of the pm4354 to get the status of each el circuit and choose recovered clock of the specified the el circuit as the external timing source of the whole htc - 5200an equipment

    Qe1系統在系統初始化時，通過軟體完成對硬體晶元pm4354的初始化工作后，便可利用該晶元完成4路e1的同步（位同步、幀同步和復幀同步） ；在pm4354完成時鐘提取的任務后， qe1通過不斷地訪問pm4354的狀態寄存器，獲得每路e1的狀態信息，在時鐘源的選擇原則下，選擇指定e1線路的恢復時鐘作為整個htc - 5200an節點設備的外部參考時鐘，從而解決了htc 5200an的中繼板卡由e1變為qe時所帶來的網同步時鐘源。
  4. The necessity and possibility to estimate and compensate camera rotation in the long focus imaging system is proposed according to characteristics of airborne imaging system. and choosing some points that have great gray levels as image characteristic to estimate motion is also given

    針對機載成像的特點，提出了長焦距攝像系統檢測和補償旋轉運動的必要與可能性以及利用選擇特徵圖像中的最大灰度值點，作為圖像特徵來估計圖像序列幀間運動的方法。
分享友人
分享到 Line

分享到臉書