弦向彎曲 的英文怎麼說

中文拼音 [xiánxiàngwān]
弦向彎曲 英文
chordwise bending
  • : Ⅰ形容詞(彎曲) curved; bent; crooked; flexuous; tortuous Ⅱ動詞1 (使彎曲) curved; bend; flex 2 ...
  • : 曲名詞1 (一種韻文形式) qu a type of verse for singing which emerged in the southern song and ji...
  1. The possible shear of the upper chord will change beam from flexural member to member under flexure and compression force. this is emphasised through design example. as a result , we find that composite floor system is good for reducing the height of floor system

    在組合樓蓋體系設計中,筆者指出,可能的桁架桿剪力會使作為桁架桿側支承的梁由構件變為壓構件,這是在與桁架體系相適應的樓蓋體系設計中應該注意的一個環節。
  2. Arching his left elbow with a rather theatrical gesture, he held the guitar above the finger - board, and winking at anisya fyodorovna, he played, not the first notes of my lady, but a single pure musical chord, and then smoothly, quietly, but confidently began playing in very slow time the well - known song, as along the high road. the air of the song thrilled in nikolays and natashas hearts in time, in tune with it, with the same sober gaietythe same gaiety as was manifest in the whole personality of anisya fyodorovna

    接著他擺出一點舞臺姿勢,略微前伸出左手肘,握住吉他琴頸稍高的地方,阿尼西婭費奧多羅夫娜使個眼色,開始不彈芭勒娘舞,先奏一聲清脆而嘹亮的和,之後合乎節奏地悠閑自得地然而剛健有力地用那極慢的速度彈奏一支著名的子在大街上。
  3. Cross - check the main roof truss roof installation quality of the surface is not perpendicular to the vertical center two blocks ; roof surface pressure chord of the roof truss vertical bending side, we must ensure that such errors do not exceed the allowable deviation to ensure roof stability and comply with the design requirements of the state by force

    屋架安裝質量主要檢查屋架跨中對兩支座中心豎面的不垂直度;屋架受壓桿對屋架豎面的側面,必須保證上述偏差不超過允許偏差,以保證屋架符合設計受力狀態及整體穩定要求
  4. Based on the minimum potential energy principal, the influences of three loads, which are concentrated force, trapezoidal load and sinusoid load, over shear lag of cantilever single - box - single - cell box girder are deducted and discussed, and a conclusion is reached, which has some instructive significance for designer to determine the sectional dimension and reinforcing bars ; the bending normal stress changes greatly as considering the shear lag effect

    以最小勢能原理為基礎,推導並討論了3種形式的荷載:集中力、梯形荷載、正形荷載對懸臂單箱單室箱形梁剪力滯的影響,得出考慮剪力滯效應后應力有較大變化的結論,對設計人員確定截面尺寸、截面配筋具有一定的指導意義。
分享友人