弦調諧 的英文怎麼說

中文拼音 [xiándiàoxié]
弦調諧 英文
hermode tuning
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : Ⅰ形容詞1 (和諧) in harmony; in accord; in tune 2 (詼諧) humorous Ⅱ動詞(商量好; 辦妥) come t...
  1. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發,提出了一種lcc振型恆頻移相單相高頻鏈逆變電路拓撲,在調制系數0 . 1 m 0 . 5情況下,控制移相角按正規律變化,使振電壓脈沖列的幅值追蹤參考正電壓信號,經過整流、濾波、低頻逆變,從而獲得正度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載,移相全橋具有超前橋臂零電壓開通,滯后橋臂或者零電壓開通( _ 0 )或者零電流關斷( _ 0 )的軟開關特性,而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  2. In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high

    針對這一情況本文對冶金輔傳用變頻輥道電機的設計進行了系統研究。首先對變頻器和變頻輥道電機的運行特性進行詳細分析,變頻器輸出的電壓波形波大,沖擊大,電壓上升率高達6600v / s ,是普通正交流電壓的20倍;軋機輔傳輥道對電機提出了十分嚴格的要求:其運行頻率很低,額定頻率在8 - 20hz ;調速范圍寬,最低運行頻率低到0 . 5hz ,起動次數相當頻繁,每小時高達600 - 800次,沖擊負荷大,過載能力要求較高。
  3. 3 using current injecting frequency modulation method and modulating sine wave around the resonator point, the lock - in phenomena is observed in a comparatively short period of time. this has achieved the basic goal for a closed loop r - fog

    3 、採用電流注入法,在振點附近進行正調制,實現了對振點的短時間鎖定,達到了閉環光纖陀螺設計的首要基本要求。
  4. The adaptive signal processing technology is a rising science embranchment, which composed with many subjects and fields. in this paper, application of the adaptive filter to elimination of the leaked triangular wave and the adaptive signal processing of the fmcw millimeter - wave radar system is studied thoroughly. the use of an adaptive filter offers an attractive solution to the problem as it usually provides a significant improvement in performance over the use of the conventional methods

    在系統的自適應信號處理研究中,系統實現採用稱為自調濾波器的自適應對消器,結果表明,在自適應過程結束后,利用該方案可以得到和原始攜帶信息的理想干波十分近似的正波輸出,其誤差是一個具有很小振幅的隨機過程,具有很好的濾波效果。
  5. The performance of the electric vehicle is improved greatly in which the harmonic wave of output voltage, power loss and torque pulsation of the system are decreased by controlling the switch angles

    它運用規則采樣法產生正脈寬調制波,通過開關角的控制抑制逆變器輸出電壓中的波分量,降低了電動機的損耗和轉矩脈動,使電動車的運行性能得到了較大改善。
  6. The asynchronous motor is widely used for its simple construction, ruggedness, high working reliability, relatively low cost, and high environmental adaptability. it is suit for the direction of high voltage, high speed and large capacity. vector control is its ideal speed modulation method. the harmonics of three - level inverter are less than the traditional two - level inverter ’ s, and it is convenient to realize high sinusoidal voltage output. the maximum voltage strength which each electric component bears is small, and it is easy for three - level inverter to realize large capacity. the research on the asynchronous motor vector control based on the three - level inverter is one novel work

    異步電機結構簡單、堅固耐用、運行可靠、成本低、環境適應性強,容易向高壓高速和大容量方向發展,獲得了廣泛應用,矢量控制為其理想的調速方法;三電平逆變器輸出端波少,有利於實現輸出電壓的正化,且單個開關管承受的最大電壓小,適合向高壓大容量方向發展。對基於三電平逆變器的異步電機調速系統開展矢量控制研究,是一件有意義的工作。
  7. For the first time, three types of sine structures for wavelength linear scale in grating spectrum instruments are described systematically. the tuning structures for wavelength linear scale in both littrow and littman set - up external - cavity laser diodes are designed

    ( 3 )首次系統地分析了光柵光譜儀器中的三類正機構,分別設計了可實現波長線性標度的littrow和littman外腔半導體激光器調機構。
  8. The volume of the output filter can be reduced greatly used in cascade inverter with carrier - phase - shifted spwm technology which has a high equivalent switching frequency and a good output sine wave. it is the base of the high power density of asi

    載波移相正脈寬調制技術有獨特的消波優勢,其等效開關頻率高,輸出波形正度好,可以大幅減小濾波器體積,為實現系統的高功率密度奠定基礎。
  9. The system had auto startup and stop function by software. the dsp based motor control system had lower current harmonic, more efficient use of supply voltage than spwm, less switch loss. on the other hand, this system make a lower noise for the pwm modulation. frequency is up to 20khz

    本系統實現了電機的軟啟動、軟關斷功能,電機電流的波失真較少,電壓利用率比常規的正波脈沖寬度調制( spwm )有了較大的提高,器件的開關損耗也得到了明顯的減少。
  10. As a result, there are some disadvantages for its large size, heavy weight and lower efficiency. in this paper, phase - shifted zero - voltage - switching pwm converter is presented, which is help to ruduce the size and improve the efficiency of inverter. in the later stage, we adopted a pic microcomputer as the control chip, whose low price decreases the price of the inverter

    在逆變環節中,本文採用體積小、功能全、價格便宜而且簡單易學的單片機pic16c72作為控制晶元,對前級直流電壓進行spwm正脈寬調制,從而產生了高質量的正輸出電壓波形,減小了輸出電壓中的波含量。
分享友人