張應力 的英文怎麼說

中文拼音 [zhāngyīng]
張應力 英文
extensional stress
  • : Ⅰ動詞1 [書面語] (給弓或樂器上弦) fix (a bowstring); string (a musical instrument) 2 (分開;...
  • : 應動詞1 (回答) answer; respond to; echo 2 (滿足要求) comply with; grant 3 (順應; 適應) suit...
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  1. The specimen deforms under a tensile stress applied parallel to the fibres.

    試樣在平行於纖維的張應力作用下發生變形。
  2. The change of microstructure of intramuscular connective tissue in response to the tension stress during limb lengthening

    肢體延長中張應力對肌間結締組織顯微結構的影響
  3. Cbm sealed condition is bad under neutral plane at axial part where shows tensile stress in syncline structure

    向斜中和面以下表現為拉張應力,向斜軸部中和面以下的煤層甲烷封存較差。
  4. Smooth tempered glass is manufactured by heating up float glass to swiftly and uniformly, with this special heat treatment and quenching process which increases glass strength up to four to five times vs, annealed glass, in case stresses beyond its capacity, smooth tempered glass simply disintegrates into innumerable small pieces, significantly reducing the risk of serious injury

    鋼化玻璃是將浮法玻璃經過物理性淬火處理,使其表面形成均勻的壓,而內部則形成張應力,從而有效的提高了玻璃的抗彎和抗沖擊性能,強度達到了普通玻璃的3 - 4倍,當其破碎時則分裂成均勻純角不易傷人的小顆粒,使其成為一種現代生活中理想的安全玻璃。
  5. Cbm is easy to escape over the neutral plane where shows tensile stress in antiform ; cbm accumulates under the neutral plane

    背斜構造中和面以上表現為拉張應力,煤層氣容易逸散,中和面以下煤層甲烷聚集。
  6. For strained si pmosfets, the hole mobility is not only determined by the tensity of strain, but also related to the strain types, which are uniaxial compressive strain and biaxial tensile strain. when electric field is high enough, the hole mobility will be deteriorated in pmosfets under biaxial tensile strain, however, in the case of uniaxial compressive strain, the deterioration will never occur

    經模型分析發現,變硅pmosfet空穴遷移率與作用方式有如下關系:當橫向電場較高( > 5 105v / cm )時,雙軸張應力作用下的變硅pmosfet的空穴遷移率將發生退化,而單軸壓器件則不會受到影響。
  7. ( 2 ) the structure condition of the earthquake happened : ms 6. 0 earthquake frequently happened several special structure place as follows : the intervein or the intersect of two deep and large rupture that their activity were very strong, the east of yulong - jiuzihai rupture and yulong snow mountain rupture

    ( 2 )區域強震發生的構造條件:區域ms 6 . 0級強震活動主要發生在如下幾類特殊的構造部位:兩組現今活動較強深大斷裂相互交錯或交匯部位;玉龍?九子海三角形斷塊東部尖端附近局部張應力異常區內的近sn向玉龍雪山東緣斷裂。
  8. Morphological and biomechanical study on the tension - stress effect on the growth of epiphyseal cartilage

    張應力對骺軟骨生長的形態學和生物學研究
  9. By means of the finite element inverse analysis, based on stress - strain theoretical equations of the elastoplasticity and viscoelasticity - viscoplasticity, the change of the valley - side margin stress distribution during original state, the condition of human cutting a terrace of building houses in the loess slope, and the condition of cutting the top of loess slope is elucidated

    3 .基於粘彈?粘塑性理論的本構方程,運用有限元方法進行反演分析,闡明了宅基邊坡谷緣在天然條件、斬坡建窯條件下和削坡條件下的場變化特點。結果表明,谷緣在斬坡建窯條件下拉張應力和剪切增大是導致崩塌產生的根本原因。
  10. ( 5 ) conclusion was obtained by the analyzing and studying the mechanics environment of the rock mass and the landslide on right bank : according to the analysis, the present direction of the maximal principle stress was consistent with the present tectonic stress field, the value of the principle stress increased or reduced in special place, and there was tensile stress region at the 2000m or above it on the left bank, the accumulate and adjustment was very limited in 200 years, the calculated result of the landslide indicated that the landslide on the right bank was stable under the various conditions

    ( 5 )壩址區河谷巖體學環境及右岸古滑坡體的穩定問題分析得出:河谷巖體場的分析顯示,河谷巖體中主的方向基本上與現今區域構造場的方向一致,在一些特殊地帶巖體的主值有所降低或增高,特別是在左岸的2000m高程附近及以上,存在有明顯張應力區。在未來200年流變計算時步范圍內,河谷巖體的積累與調整較為有限。同時對滑坡體各種工況條件下的穩定性計算結果表明,右岸古滑坡體在各種工況條件下是處于穩定狀態的。
  11. ( 6 ) conclusion was obtained by the analyzing the mechanics environment and the stability of the lanslide on the right bank after the dam built : the value of the rock mass stress increased and the tensile stress region obviously reduced, the direction of the principal stress was unchangeable the dam and the landslide were stable under the dangerous condition ( the reservoir and at the same time the earthquake was viii ), but when the water lever suddenly fell and did not think of other force, safe factor evidently reduced, the dam and the landslide will be destroyed under the most dangerous condition ( the water lever suddenly fell and at the same time the earthquake was vi ) ; the stability of the landslide will be destroyed by the horizontal thrust under the most dangerous condition or ; the physical and mechanical parameter will be reduced due to long period filter, the landslide will be destroyed too

    ( 6 )建壩工程荷載條件下河谷巖體學環境分析及右岸古滑坡體的穩定問題分析得出:建壩后河谷的巖體量值明顯增高,同時左岸的張應力區的范圍及量值明顯減小,主的方向依然與模型的底邊界垂直;大壩建成后逐漸蓄水階段以及同時考慮本區最強地震的作用等各種不同的工況條件時,滑坡體及壩體總體上仍處于穩定狀態;水位驟降時,在未考慮其他外作用的情況時,滑體的安全系數將顯著降低。若考慮水位驟降及本區最大地震的共同作用,壩體將在滑坡體下滑推的作用下產生破壞;建壩后水平推對右岸古滑坡體穩定性的影響分析可以看出,在最危險的工況條件下,壩體及滑坡體也將處于臨界狀態;在長期滲透變形的作用下,由於滑帶的物理學參數的降低而有可能導致壩體失穩破壞。
  12. Using these approaches, diffusion coefficients were obtained for the first time for complexes under tensile stress condition and no stress condition respectively

    用這些計算方法,首次從實驗上求得了空位與溶質原子復合體分別在低張應力狀態和無狀態下的擴散系數。
  13. The vertical loading plays a major role in the state of the flexural stress. beneath the mountain belts, the compression decreases and changes to extension from the top of the elastic plate to the bottom. the change of the flexural stress beneath the basin is vice versa

    從彈性板頂部向下,造山帶下方的擠壓逐漸減小,到中性面以下變為拉,然後張應力逐漸增大,在彈性板底部達到最大;盆地下方的變化則與之相反。
  14. Critical tensile stress

    臨界抗張應力
  15. Abstract : the change in strength, plasticity and relaxation rate of pc steel strand before and after stabilizing has been analyzed by means of fracture and stress relaxation tests. the effect of treatment parameters and tensile stress on the properties was obtained and optimum parameters of stabilizing treatment were also proposed

    文摘:通過對預( pc )鋼絞線穩定化處理及隨后的破斷、鬆弛試驗,分析了處理前後強度、塑性、鬆弛率指標的變化趨勢,得出了工藝溫度、張應力對性能指標的影響規律,進而提出了穩定化處理的最佳工藝參數。
  16. Residual stresses of bst thin films are tensile stresses, grain size and stresses increase with annealing temperature

    Bst薄膜殘余表現為張應力且隨著薄膜晶化溫度升高,薄膜的晶粒變大,殘余呈變大的趨勢。
  17. Study of in situ measurement of residual tensile stress in thin films for t - shaped microstructures

    形結構在位測量薄膜中殘余張應力的理論研究
  18. In contrast, the lcmo thin films grown on lao substrates show an in - plane compressive stress. the afm images suggest that at the annealing temperature range between 650 and 750, with the annealing temperature increase, the grain sizes increase, the rms increase

    沉積在sto基片上的lcmo薄膜在面內方向受張應力作用,垂直方向上的晶格常數相對縮小,沉積于lao基片上的lcmo薄膜在面內方向受壓作用,垂直方向上的晶格常數相對增大。
  19. Three - dimensional finite element analysis on cell culture membrane under mechanical load

    張應力作用下體外細胞培養膜上分佈的三維有限元分析
  20. But there is a big tensile stress, caused by the difference of the thermal expansion coefficient, at the interface between the ha coating and the substrate

    但因熱膨脹系數差異, ha塗層與基體間存在很大的張應力
分享友人