彈粘度 的英文怎麼說
中文拼音 [dànniándù]
彈粘度
英文
elastic viscosity-
A little emulsoid was added in the bitulith to improve the performance of asphalt pavement. the new material is of rigidity and flexibility. we called it semi - rigid bituminous emulsion
乳化渣油半剛性路面材料就是針對瀝青混凝土的弱點進行改性研究的一種新型復合材料,其在增加材料剛度的同時仍保留了部分粘彈性特徵。Gluten index was significantly correlative with tensile strength, significantly correlative with hardness, springiness, cohesiveness, gumminess, resilience, shear force, tensile force, tensile stress, dry weight and protein losses, dry material absorption of the noodles
麵筋指數與面條的拉伸距離呈高度顯著正相關;與面條的硬度、粘合性、剪切力、拉斷力、拉斷應力呈顯著正相關;與面條的彈性、粘結性、回復性、干物質吸水率、干物質損失率呈顯著負相關。The consolidating wave speed means the speed at which elastic stress wave transmits throughout reinforced concrete, and it is intervenient the inherent wave speed of steel and of the concrete. moreover, the consolidating wave speed inherent in the material of the reinforcing steel bar and the concrete, and it relates to the cling strength of steel bar and the concrete
固結波速是指彈性應力波通過鋼筋-混凝土體系傳播時的速度,通過理論分析得知固結波速的大小介於鋼筋和混凝土中彈性應力波速之間,由鋼筋與混凝土二者的材質特性決定,與二者的粘結強度密切相關。Theoretical analysis and computer simulation studies show that performance comparable to that of electro - control active damping suspension systems can be achieved with the hydraulic network model which can self - adaptingly adjust the damping of suspension to realize the optimal control by virtue of response of vehicle. in chapter 5, the effects of time - variant factors in the new active damping suspension system on reduction are investigated
第五章研究了主動阻尼系統中的時變因數對減振系統的減振效果的影響(包括路況、車速、載重阻尼油的粘度系數隨油溫變化而引起的變化,油液的彈性模量等) ,並分析了模型簡化時一些被忽略的非線性因數對系統性能的影響。The results show that the dynamic elastic modulus, loss modulus and complex viscosity of the nanocomposite are higher than those of pp, while the loss factor is lower, that the complex viscosity of the nanocomposites is more sensitive to temperature, and that the flow activation energy and the crystallization temperature increase respectively by 15 % and 10k as compared with pp, which may contribute to the enhanced interfacial interaction between pp and ommt resulting from the addition of tmpp
結果表明:與純聚丙烯相比,納米復合材料具有較高的動態彈性模量、損耗模量和復合粘度,力學損耗因子則降低,納米復合材料的復合粘度對溫度的敏感性略高於聚丙烯;界面改性劑的加入增強了有機蒙脫土與聚丙烯的界面作用,與聚丙烯相比,納米復合材料的流動活化能提高約15 % ,結晶峰溫度提高10k左右。Fig. 8. 29 shows the effect on the solution of including elasticity and enhanced viscosity.
圖829表示考慮彈性變形及粘度提高對計算結果的影響。Clear, one - component, flexible, heat cure epoxy system designed for coil impregnation, and potting applications requiring low viscosity and minimal thermal stress
透明的單組分加熱固化環氧,彈性,專為低粘度、最小熱壓的灌封澆注要求而設計。Applications of higher - order upwind scheme for viscous flow of projectiles
高精度迎風格式的射彈粘性繞流場數值模擬Attenuation characteristic of fast wave, slow wave, quasi - transverse wave and anti - plane transverse wave are discussed and the combined effects of the anisotropy of the solid skeleton and fluid viscosity on the propagation characteristic of plane waves are analyzed numerically. the influence of horizontal anisotropy and fluid viscosity on the propagation characteristic of elastic waves is clarified
討論了液飽和多孔介質中快波、慢波,準剪切波和反平面剪切波的衰減特性,並分析了固體骨架異性以及流體粘度的綜合效應對平面波傳播特性的作用,澄清了介質水平面內異性以及流體粘度對彈性波傳播特性的影響。2. effect of the viscosity ratio, mterfacial adhesion, processing conditions and composition on the dispersing morphology and properties of pp / eoc blends was investigated. low viscosity ratio and high shear rate during processing were found to produce fine and uniform dispersion of eoc in pp matrix, while low viscosity ratio, high interfacial interaction, good fluidity of elastomer and high shear rate in molding process resulted in fibril dispersion, which afford a guide for controlling the morphology of pp / eoc blends
研究了粘度比、界面相互作用、加工條件和共混比例等因素對pp eoc體系分散形態和性能的影響,發現粘度比小和加工過程中剪切強度大有利於彈性體在基體中分散均勻細化;粘度比小、界面相互作用強、彈性體本身的流動性好及成型時受到的剪切應力大,使彈性體相易變形,沿流動方向取向呈纖,闡明了各因素對形態影響的作用機制,這對pp eoc共混物的形態控制具有重要的指導作用。But, the melt viscosity of the sbs and sebs elastomers is highly affected by the shear rate inside the barrel but it is not sensitive to the temperature inside the barrel
但sbs與sebs彈體的熔膠粘度melt viscosity非常容易被炮筒內剪切率shear rate影響,反而對炮筒內的溫度不太敏感Due to the structure difference in the molecules of soft sections between sbs and sebs elastomers, the viscosity and shear rate is of significant variation
由於sbs與sebs彈體中間的軟質段分子結構不同,其相對剪切率的粘度特性viscosity shear rate也有顯著的差異Taking gear without tooth face invalidation such as agglutination and abrasion as a precondition, and according to the relation between minimal oil film thickness and tooth face roughness of elastic liquid dynamic pressure lubrication theory, viscosity of gear lubrication oil was educed by reliability method in this paper, and the calculation formula has been elicited and applied
摘要以齒輪傳動不發生膠合、磨損等齒面失效為前提,根據彈性流體動壓潤滑理論的最小油膜厚度與齒面粗糙度的關系,用可靠性方法確定齒輪潤滑油的粘度,給出計算公式並進行了實例計算。Testing of rubber and elastomers ; testing with the mooney shearing disk viscometer ; determining the mooney viscosity
橡膠和彈性體的檢驗.第3部分:莫氏剪盤式粘度計檢驗Testing of rubber and elastomers ; testing with the mooney shearing disk viscometer ; determining the scorching behaviour
橡膠和彈性體的檢驗.第4部分:用莫氏剪盤式粘度計檢驗Results from experiments with a constant - viscosity, elastic fluids ( boger fluids ) and computations using the corresponding oldroyd _ b constitutive equation are presented
實驗採用作者配置的等粘度彈性流體,並用流變測量的結果確定oldroyd _ b本構方程的參數。Semi - flexible, moderate viscosity, flame retardant epoxy compound displaying the best thermal shock resistance currently available in an epoxy compound, as well as excellent electrical properties over a wide range of temperature, insulcast 985fr makes use of the latest polymer and filler technology
半彈性、中高粘度、阻燃環氧化合物,具有出色的抗熱沖擊性能,運用了最先進的聚合物與填充技術,在較大的溫度范圍內也能保持良好的電氣性能。Seals. elastomer base mastics used for sealing. determination of adhesivness - cohesion. characteristics under tensile stress
縫隙.密封縫隙用彈性膠泥,拉力作用下附著粘度性能測定Seals. elastomer base mastics used for sealing. determination of adhesivness - cohesion characteristics by cyclic tensile - compression tests
縫隙.密封縫隙用彈性膠泥.循環試驗測定附著粘度性能.拉伸.壓縮In addition, the research suggested that amylose content in annong waxy 1 was extremely low, and its viscosity parameters including pasting temperature, peak viscosity, hold - through, break - down, final viscosity, set - back, peak time and stirring were lower and extremely low
但「安農糯1 」籽粒硬度的值較低,表現為軟質,直鏈澱粉含量表現極低的值,糊化溫度、高峰粘度、低谷粘度、稀懈值、最後粘度、反彈值、峰值時間和攪拌值等8個粘度儀參數均表現較低或極低的值。分享友人