恆壓電池 的英文怎麼說

中文拼音 [héngyādiànchí]
恆壓電池 英文
constant cell
  • 恆 : Ⅰ形容詞1 （永久; 持久） permanent; lasting 2 （平常; 經常） usual; common; constant Ⅱ名詞1 （恆心...
  • 壓 : 壓構詞成分。
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 池 : 名詞1 （池塘） pool; pond 2 （旁邊高中間窪的地方） an enclosed space with raised sides 3 （舊指劇...
  • 電池 : [電學] cell; battery; element; electric battery
  1. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體電路以恆定電流驅動4隻白光led ，利用1倍/ 1 . 5倍分數型電荷泵和低壓差電流調節器，在整個鋰電池供電電壓范圍內保持最高的效率，並使四個白光led獲得均勻的亮度。
  2. The li - ion or li - polymer battery ic use cc / cv charging mode which includes the 3 charging stages : the trickle charging, large constant current charging and constant voltage charging

    本文設計的鋰電池充電器晶元採用了恆流恆壓的充電方法，並在此基礎上將充電過程分為三個階段:預充電、恆流充電和恆壓充電。
  3. After which, the battery will be charged by large constant current to allow the fast charging. finally, the constant voltage charging is adopted to guarantee the battery was charged to its full capacity. under the condition that the temperature has raised to a certain threshold at the constant current charging stage, the over temperature circuit is performing and it provides a compensation current which switches the system to constant temperature charging mode with the intention of protecting the ic

    即在充電初期採用較小的電流對電池進行預處理，對出現過放電的電池進行修復和保護;然後採用較大的恆定電流對電池充電，實現快速充電的目的;最後採用恆定壓充電，確保電池充滿;在恆流充電階段，當晶元溫度上升到一定程度時，晶元過熱保護電路開始工作，該電路以提供充電補償電流的形式使充電進入恆溫充電模式，對晶元進行保護。
  4. The effects of the fabrication conditions on the crystal structure, grain size, micromorphology and electrochemical performance of these materials have been studied in depth. the reaction mechanism of the low - heating solid - state reaction method has also been investigated. in addition, a novel electrochemical method ( rpg method ) based on the concept of " ratio of potentio - galvano - charge capacity " has been for the first time developed to determine the diffusion coefficient of lithium - ion within insertion - host materials on the basis of the spherical diffusion model

    本論文較系統地考察了低熱固相反應法合成鋰離子電池正極材料的可行性問題，研究了工藝條件對材料的晶體結構、晶粒尺寸、微觀形貌及電化學性能等的影響，探討了低熱固相反應的機理，並通過引進「恆壓-恆流充電容量比」的概念，給出了一種測定鋰離子嵌入脫出固相擴散系數的新方法。
  5. Constrained to technologies, the lead - acid battery mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current, etc. the charging current of these methods cannot match efficiently the acceptance curve of the lead - acid battery proposed by j. a. mas. as a result, some of these methods have a low time efficiency and incompleteness charging. and some of them lead to overcharge and gas - generation, which will result in low - efficiency, time - consuming and prone - to - damage of the charging operation

    鉛酸蓄電池由於受到技術條件的限制，其充電主要採用恆壓、恆壓限流、恆流等常規充電模式，這些方法的充電電流未能有效的遵從馬斯所提出的可接受充電電流曲線，因而有的充電方法時間效率低、充電不完全;有的則存在著過充電和析氣等現象，並導致充電過程的低效，耗時和易損。
  6. The charging of lead - acid battery, the most widely accepted secondary battery, constrained to technological limitation, mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current and etc. those methods may not follow the internal physical and chemical laws within the battery, leading to serious overcharge and gas - generation, and resulting in low - efficiency, time - consumming and prone - to - damage of the charging operation

    二次電池中被最廣泛接受的鉛酸蓄電池由於技術條件的限制，其充電主要採用恆壓、恆壓限流、恆流等常規模式，這些充電方法未能遵從電池內部的物理化學規律，大多存在著嚴重的過充電和析氣等現象，並導致充電過程的低效，耗時和易損。
  7. Based on the experiment of nimh battery, investigations on characteristics of discharging and charging of nimh battery, and analysis of influencing factor of nimh battery, an approach of ah ? coe ? ocu has been carried out to estimate an accurate surplus energy and state of charge of nimh batteries, and consider the compensation of the temperature, aging and self - discharging etc. after theoretic analysis has been completed, simulations are given to determine parameters of batteries for changan hev

    本文在蓄電池試驗的基礎上，分析和研究ni - mh蓄電池充放電特性及其影響因素，建立了電池內阻、電動勢模型，提出了安時?能量守恆?開路電壓演算法（ ah ? coe ? ocu法）預測蓄電池的剩餘能量和荷電狀態計算方法，並進行溫度、循環使用壽命、自放電等補償，從而建立了蓄電池的充放電模型。
  8. The trickle charging uses small current at the initial of charging cycle to fix and protect the over - discharged battery ; after which, the battery will be charged by large constant current to allow the fast charging ; finally, the constant voltage charging is adopted to guarantee that the battery is charged to its full capacity

    在充電初期採用較小的電流對電池進行預處理，對出現過放電的電池進行修復和保護;然後採用較大的恆定電流對電池充電，實現快速充電的目的;最後採用恆壓充電，確保電池充滿。
  9. Another advantage is that by supplying power to the 12v electrical system from the ima battery, electrical system voltages remain very constant, even under changing electrical system loads

    另一個優點是12v電子系統的電源是輔助電機集成電池模塊，即使改變電子系統的負載，其電壓維持恆定。
  10. A simple constant voltage and constant current charger has been improved, the state of float charger has been added to the charger in order to guarantee the full charge of battery safely, with high charge speed. experiment results and detailed designs of power circuit and control circuit of the charger are presented

    本論文對一種簡單實用的恆壓恆流充電器進行了改進，在恆壓恆流充電的基礎上加入了浮充狀態，從而保證了蓄電池的滿充；同時對充電器的功率電路和控制電路進行了詳細的設計，並且給出了實驗結果。
  11. With the application of real - time multi - tasks mechanism and modulization software structure, the controller can set and modify the parameters on - line, collect and process the real - time data of the four - battery charge / discharge devices, termly and digitally regulate the closed loop and monitor the real - time faults, so that the system can control different styles of charging and discharging operate mode such as in constant current style, constant voltage with limited current style and static style

    控制器軟體採用實時多任務機制和模塊化的設計思想，通過對蓄電池化成充放電過程中工藝參數的在線設定修改、實時數據的採集處理、定時的數字閉環調節和故障的監測，實現對蓄電池靜電、恆流、恆壓限流等多種充放電工作方式的控制。
  12. By analyzing the charging & discharging characteristics of accumulators, and by improving the hardware and control algorithm of the former chargers, this dissertation designes a high - power charger. the charger can not only charge accumulators with constant voltage and limited current, but also charge them intelligently. meanwhile, it is characteristic of over - voltage, over - current and overheat protection, self - recovery and automatic current - averaged in parallel

    本論文通過對蓄電池的充、放電特性的分析以及對以往充電機硬體和控制演算法兩個方面的改善，設計了一種不僅能對蓄電池進行恆壓限流充電，還可以進行智能充電，同時具有過壓、過流、過熱保護、自恢復功能和並聯自動均流的大功率充電機。
  13. In this paper, a charger of storage battery with power factor correction ( pfc ) is devised. additionally, the summarization, implement methods and the charge mode are mainly introduced

    本文設計帶功率因數校正的蓄電池充電電路，主要介紹了功率因數校正的概況、實現方式及恆壓限流充電方式。
  14. Following the operational principle of the li - ion battery fast - charging and the existing charging approaches, the trickle pre - charge mode and constant temperature charging mode are added based on the cc / cv mode, i. e. pre - charge the battery using trickle current at the initial of charging cycle to fix and protect the over - discharged battery

    並在此基礎上設計了一款針對單節鋰電池的dc / dc充電器晶元。在對鋰電池快速充電原理和目前各種充電方法研究的基礎上，本文以恆流恆壓充電法為基礎，增加了小電流預處理和恆溫充電模式。
分享友人
分享到 Line

分享到臉書