折點電流 的英文怎麼說

中文拼音 [zhédiǎndiànliú]
折點電流 英文
breakpoint current
  • 折 : 折動詞[口語]1. （翻轉） roll over; turn over 2. （倒過來倒過去） pour back and forth between two containers
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. In order to make the sensitivity of 2 - demension accelerometer along the two main arbors almost identical, symmetric four - beam structure that embeds a double - sides interdigitated differential capacitive with puckered beam in two directions was used as sensitive component. in addition, the differential capacitive accelerometer fabricated by bulky silicon micromechanical technique has high sensitivity, wide measurement scope, less nonlinear error, and simple converting circuit. then, the structure parameters of the sensitive component were calculated and stimulated, which results in a set of the optimized structure design parameters, main fabrication procedure and several key fabrication technology

    為使二維振動傳感器在兩主軸方向的靈敏度大致相同，敏感元件採用高度對稱的四梁結構，其中每個軸向上均採用帶折疊梁的雙側叉指電容結構，採用體硅微機械工藝製作的高深寬比叉指電容式敏感元件，具有高靈敏度、寬量程、非線性誤差小、外圍電路簡單等優點;對設計的敏感元件結構參數進行了計算，並利用有限元法進行了模擬分析，根據模擬結果得出了優化參數;在確定敏感結構的基礎上，研究了敏感元件採用體硅微機械加工工藝製作的工藝流程和關鍵工藝技術;對敏感晶元內部的c - v介面電路進行了原理設計與分析，利用差動測量技術得到由振動引起的微小電容變化量，經c - v介面電路進行相位調制處理，然後通過解調輸出與加速度成正比的電壓信號。
  2. Today, liquid crystal, a new functional material, has been applied more and more widely. on the side of display, owing to stable frarne, absolute environmental protecting, save electric energy and no tire for user, liquid crystal display keeps ahead among the range of display. with the developing of the technology of liquid crystsl, lcd will must substitute for crt and become the chief in market. in additin, liquid crystsl light filers which have been used in optic communicatins and light information handling, emply th e technical of combining the birefringence of liquid crystsl and fabry - petrot - type cavity. they manifest a series of merit, such as narrow band wide, deterioration low, wide tuning domain, simple structure and low cost, so liquid crystal light filter draw attention of many country

    現在，液晶作為一種新型功能材料越來越得到廣泛的應用，在電子顯示裝置中，液晶顯示器以其畫面平穩、真正安全環保、省電和使用者不易疲勞等優點領先於顯示器的行列中。隨著液晶技術的發展，液晶顯示器將取代crt顯示器逐步成為未來市場的主流。此外，應用於光通信和光信息處理中的電調諧液晶濾光片，採用液晶材料的雙折射和電光效應與傳統f - p腔相結合，表現出窄帶寬、低損耗、調諧范圍寬、驅動電壓低、結構簡單、低成本等一系列優點，而日益受到各國研究部門的關注。
  3. By analyzing the refraction 、 reflection process of fault transient current traveling wave of high voltage and characteristics of refraction 、 reflection coefficient systematically, a new fault location method of single ended traveling wave is presented. it can not only identify the reflection wave for fault location efficiently, but also not be affected by the structure and length of line. fault earthed resistance 、 fault type 、 system impedance and can locate fault in adjacent areas accurately

    論文深入地分析了高壓線路故障暫態電流行波的波折、反射過程以及折、反射系數的特點，提出了新的單端行波故障測距方法，它不僅能夠有效地識別出測距所用的反射波，而且幾乎不受線路結構、長短、故障接地電阻、故障類型、系統阻抗的影響，在近區仍可以準確地進行測距；同時模擬阻波器的特徵，設計了低通數字濾波器，對通過了低通數字濾波器的暫態故障電流行波再次進行小波分析，並利用本文提出的單端行波故障測距方法進行故障定位，結論是所提出的測距方法在實際應用中仍是有效的。
  4. Electric current sensors employing highly circularly birefringent fiber are proposed. also a novel scheme to compenwte for laser source power and ambient temperature fluctuation is proposed here. this scheme is based on the traditiona1 signal - processing scheme with simpler and more effective design

    對應用高圓雙折射光纖的電流傳感器進行了研究，在傳統的信號處理方案上，保留其原方案優點，提出新的功率補償方案，對應用高圓雙折射光纖電流傳感器的溫度效應進行研究。
分享友人
分享到 Line

分享到臉書