拉伸變形 的英文怎麼說

中文拼音 [lāshēnbiànxíng]
拉伸變形 英文
stretcher strain
  • 拉 : 拉構詞成分。
  • 伸 : Ⅰ動詞（展開） stretch; extend Ⅱ名詞（姓氏） a surname
  1. When ct20 alloy was tensioned at 20k, the main deformation mechanism in equiaxed microstructure was the slip of dislocations, and in bimodal microstructure the slip of dislocations and a small amount of twinning and in lamellar microstructure a large amount of twinning

    Ct20合金20k拉伸變形時，等軸組織主要是位錯的滑移起主導作用，雙態組織除了位錯滑移外還有少量的變形孿晶產生，片狀組織中則能觀察到數量較多的孿晶。
  2. It ' s square copper signet with anamorphic inscriptions due to pics. it ' s only for playing

    是方銅印，印文照得有點拉伸變形了，印也不到代，閑玩的。
  3. Tensile behavior of electrodeposited nanocrystalline ni

    電沉積制備納米鎳的拉伸變形行為
  4. Some explains are given about internal deformations under tension

    對其拉伸變形的內部機理進行了說明。
  5. Dty : draw texturing yarn

    拉伸變形絲
  6. Dty draw textured yarn

    拉伸變形絲
  7. Poy pre - oriented yarn

    拉伸變形絲
  8. Testing methods for chemical resistance of plastics under constant tensile deformation

    在恆定拉伸變形下塑料耐化學作用的試驗方法
  9. Tensile test and cyclic strain test of copper single crystal were performed. there are three stages in the plastic deformation

    觀測到銅單晶在拉伸變形過程中的三個階段，得到了循環應力應變曲線。
  10. Then, it presents two methods of the pull - out tests to the different stress - strain characteristics for the geofabric and the geogrid

    其次，針對土工布、土工格柵的不同拉伸變形性狀提出了兩種拉拔試驗方法，經試驗證明可行。
  11. 16 not only will the tattoo stretch during pregnancy there is no guarantee that the tattoo will go back to its original shape after the birth of your baby

    腹部紋身不止在懷孕時會拉伸變形? ?你的孩子出生后它也不能保證可以恢復原樣。
  12. Analyzing the effects towards residual stress from different rolling loadcase, the value of cold rolling residual stress caused by different compress was gotten ; analyzing parameters stretching toward different rolling loadcase board, the effect of the residual stress elimination influenced by stretching force and stretching deformation was figured out

    通過分析不同軋制工況對殘餘應力分佈的影響，得到不同壓縮量對軋制殘餘應力的影響； ?對不同軋制工況后的板材進行參數拉伸，得到拉伸力大小、拉伸變形量大小對殘餘應力消除效果的影響值。
  13. The model considers the torsional deformation of transmission axes, bending and longitudinal deformation of links, geometrical nonlinearity of guiding leaf springs, and the elastic nonlinearity of balance springs

    該模型考慮了傳動軸的扭轉變形，連桿和導向板彈簧的彎曲和拉伸變形，導向板彈簧的幾何非線性及平衡彈簧的非線性等因素的影響。
  14. The results of quantitative analysis showed that the pre - tension deformation reduced the fatigue crack propagation threshold and increased the crack propagation coefficient, and consequently decreased the fatigue resistance of the part with mechanical damage

    定量分析表明：預拉伸變形降低了疲勞裂紋擴展門檻值，提高了裂紋擴展系數，從而使管線在機械損傷的部位疲勞抗力降低。
  15. Three parts are discussed, respective, ( 1 ) the nanostructure in the perfect of single crystal copper structure and perfect titanium structure. ( 2 ) the tensile deformation mechanism and stress analysis of the point defects effects. ( 3 ) the significance of effect as size reduced

    本論文所探討的內容可分為三部分，分別為： （ 1 ）針對完美單晶銅結構與完美鈦結構的拉伸變形研究（ 2 ）包含了空孔點缺陷的拉伸變形結構研究（ 3 ）針對尺寸縮小后所造成的表面效應影響作一探討。
  16. Gomez said doctors would start with the left side of casseus " skull and carve away the ballooning fibrous mass that had stretched and distorted her face, spreading apart her teeth

    手術前戈邁茲曾說，醫生將從卡蘇斯的左臉開始手術，並且把導致她臉部拉伸變形的球狀纖維組織切除掉。
  17. Abstract : the sensation of wearing pressure have assessed for knit garments having different sizes and fabrics having the different extensibility, by developing a wearing experimental procedure. at the same time, the objective clothing pressure, the fabric ' s extensibility and the garment ' s fitness have measured. regression analysis showed that the garment ' s fitnessand fabric ' s extensibility had great predictive power for the subjective pressure assessment

    文摘:設計了一組服裝用於穿著實驗.對不同尺寸、不同彈性性能的緊身長褲進行了主觀壓力感評價，並測量了服裝壓、衣料的拉伸變形程度和服裝寬裕率.通過分析，選用服裝寬裕率和織物的彈性模量作為指標預測服裝的穿著壓力感
  18. In this paper, the forming courses of the ribboning, bulge, expansive edge, cob - webbing and slough - off are analyzed. and the effect measures for overcoming these defects are provided

    摘要分析了拉伸變形后卷裝中出現的重疊、凸邊、脹邊、蛛網絲和脫圈等疵點的形成過程，提出了克服這些疵點的有效措施。
  19. The results show the moment developing course of flow over flat wall and the evolvement of coherent structure, and also completely simulate all kinds of detail processes in development of boundary layer over flat wall, such as the generation and rise of low - speed stream, the extension and rupture of horse - hoof - shaped vortex and so on

    模擬結果給出了平壁流動的瞬態發展過程以及流動中擬序結構的發展演變過程，成功地模擬了平壁邊界層發展中的各種瞬態細節過程，如低速條帶的產生、上舉過程，馬蹄形渦的拉伸變形、破裂過程。
  20. Test results showed that the fatigue crack propagation rare increased with increasing the pre - tension deformation degree, especially at the near threshold section

    結果表明：隨著預拉伸變形量的增加，疲勞裂紋擴展速率提高，尤其是在裂紋擴展的近門檻區。
分享友人
分享到 Line

分享到臉書