拉壓試驗機 的英文怎麼說
中文拼音 [lāyāshìyànjī]
拉壓試驗機
英文
te ile and compre ion testing machine-
Verification of helical compression and extension springs testing machines
螺旋壓縮和拉伸彈簧試驗機的校驗In this research, the lime - fly - ash bound macadam was joined with steel fibers, glass fibers and polypropylene fibers with the contents of the lime, the fly ash and the macadam fixed in lab tests. the study focuses mainly on the split strength, compression strength, and modulus of compressive resilience and shrinkage property of the lime - fly - ash bound macadam enhanced by different kinds of fibers. based on the test, a detail theoretical analysis was made on the relation of mechanical property, dry shr inkage with the variety and the quantity of fibers, applying the theories of strength, dry shrinkage and the methods of statistics, curve mimesis and variance analysis
本論文主要是研究在同一種二灰碎石混合料（石灰、粉煤灰、集料的含量及比例相同）中分別摻入不同數量的鋼纖維、玻璃纖維、聚丙烯纖維，通過室內試驗對其抗拉強度、抗壓強度、抗壓回彈模量和乾燥收縮性能與纖維摻量和纖維品種之間的關系加以分析和研究，並在此基礎上根據二灰碎石強度形成機理、乾燥收縮機理和數理統計、曲線擬合、方差分析的方法分析纖維品種和纖維數量對二灰碎石的力學性能和乾燥收縮性能的影響，最後得出纖維對二灰碎石的強度、抗壓回彈模量、乾燥收縮有很顯著的影響，並提出了相應的建議。Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc
能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。By using 5000kn pressure - bent testing machine, the specimens of boulder concrete and crushed stone concrete were tested through three - point - bending method and wedge - split tensile method, the scale division of the index dial of pressure - bent testing machine is larger, whereas the predicted test - load is lesser, so the velocity of exerted load is controlled through observing the reading of the multimeter which is connected with the collecting systerm in order to continuously exert test - load
本文使用5000kn壓彎實驗機，對不同強度等級的卵石混凝土和碎石混凝土試件分別進行了三點彎曲試驗和楔入劈拉試驗。試驗過程中，由於實驗機噸位較大，而試驗荷載預計較小，為了能夠有效地控制加載大小和加載速度，採用通過觀察與荷載傳感器相連的萬用表讀數控制加載速度的方法，連續加載。In the beginning, the working principle, testing and data processing system of pdl micro - control material test machine is introduced ; then more attention is paid to the hardware system which is composed of high precision raster linear displacement sensor, high precision force sensor, the digital displaying sets, the interface equipments and the controlling circuits etc to perform the data collection and ensure the testing precision of the whole system
論文首先介紹了pdl材料拉伸試驗機的工作原理、測試及數據處理系統；接著詳細介紹了由高精度光柵線位移傳感器和壓力傳感器、數顯裝置、介面裝置及控制電路等組成的新的硬體系統，來完成數據採集，並保證整個系統的測試精度要求。( 1 ) systematic triaxial compression tests are made for the sand reinforced by various national geosynthetics. comprehensive investigations into the interaction characteristics are also made between sand / lime fly ash and various national geosynthetics by direct shear tests and pull out tests, which can help choosing geosynthetic type and understanding the geosynthetic reinforcement mechanism ; ( 2 ) this paper is also firstly systematically presents the results of a comprehensive investigation into the interaction characteristics between lime fly ash and various national geosynthetics ; ( 3 ) by non - linear fem, the influence of the modulus of geosynthetics, the thickness of the soft ground and the width of the foundation on the effectiveness of geosynthetic reinforcement are also studied ; ( 4 ) the main conclusions are as followed : ( geotextiles are likely to be suited for projects allowing high displacement, polyester warp knitting geogrids and oriented geogrids for projects allowing medium displacement, glass fiber geogrids for projects allowing low displacement and geonets for secondary projects. ( the confining effect of fill material to act on different kinds of geosynthetics varies largely, which must be considered
（ 1 ）本文利用三軸壓縮試驗，比較各種國產土工合成材料對砂土的加筋效果；利用直剪試驗和拉拔試驗，比較各種國產土工合成材料與砂土或石灰粉煤灰的界面摩擦特性，深入研究土工合成材料的加筋機理，首次明確提出加筋土工合成材料的選型原則； （ 2 ）本文首次系統地研究了石灰粉煤灰與各種國產土工合成材料的界面摩擦特性； （ 3 ）本文採用有限元法，系統研究了加筋模量、軟土地基厚度、基礎寬度等因素對土工合成材料加固軟土地基效果的影響； （ 4 ）本文主要結論如下： （無紡土工織物適合用於允許大變形的加筋土工程；滌綸纖維經編土工格柵和塑料拉伸土工格柵適合用於對變形有較嚴格要求的加筋土工程；玻璃纖維經編土工格柵適合用於對變形有嚴格要求的加筋工程；土工網適合用於低等級的加筋土工程。This article performed an application of such means as modern test technology, computer processing system, serial ports communication and electrohydraulic proportional control technology to reform the sheetmetal combined testing machine, so that the stretching force, clamping force and the stretching length can be tested and controlled by the computer system, which greatly improved the stability and testing precision of the testing machine
摘要通過應用現代測量、微處理、串口通信、電液比例控制等技術，對自行研製的鈑金綜合試驗機進行了改造，實現了對拉伸力、夾緊壓力和拉伸長度的計算機數據採集和控制，大大提高了原系統穩定性和測試精度。At present experiment on the test the pull and press intensity test to rubber is usually curried out on the stretch experiment machine. most of the testing systems for homemade stretch experiment machines are based on single chip and others are based on pc systems
目前對橡膠產品進行拉壓強度檢測實驗一般是在拉伸試驗機上進行，國產拉伸試驗機大部分是以單片機為主的測試系統，也有部分拉伸試驗機是以pc機系統為核心的測試系統。Servo control computer system / microcomputer universal testing machines, ozone tester, compression flexometer, computer hdt / vicat tester, digital impact tester, melt flow indexer, moving die rheometer, mooney viscometer, lamination of pvc plastic press tester
伺服控制電腦系統微電腦式拉力試驗機，耐臭氧機，橡膠壓縮生熱試驗機，塑料用維卡熱變形，數位沖擊試驗機，塑膠熔體流動速率機，無轉子密閉膜腔硫化儀，門尼黏度試驗機等等。Specifications for tension - compression fatigue testing machines
拉壓疲勞試驗機.技術條件Metallic materials - verification of static uniaxial testing machines - part 1 : tension compression testing machines - verification and calibration of the force measuring system
金屬材料.靜態單軸向試驗機的驗證.第1部分:拉伸壓縮試驗機.力測量系統的驗證和校正Verification and calibration of the force measuring system of the tension compression testing machines
拉伸和壓縮試驗機測力系統的驗證和校準Metallic materials - verification of static uniaxial testing machines - tension compression testing machines - verification and calibration of the force - measuring system
金屬材料.靜態單軸向試驗機的鑒定.拉伸和壓縮試驗機.測力系統的鑒定和校準Tension and compression spring testing machines
彈簧拉壓試驗機Verification regulation of universal tension and compression testing machine
拉力壓力和萬能試驗機檢定規程Requirements for tensile, flexural and compression testing machines for rubbers and plastics
橡膠塑料拉力壓力彎曲試驗機技術要求Materials testing machines - strain cylinder test method for compression testing machines for concrete
材料試驗機.拉伸.加壓和彎曲試驗機的檢驗.建築材料壓Verification regulation of tension compression and universal testing machina for non - metallic
非金屬拉力壓力和萬能試驗機檢定規程Concretes. common characteristics of hydraulic machines for compression, bending, and tension testing of hard materials
混凝土.硬材料彎曲.壓縮和拉力試驗用液壓機的一般特性Making use of the transformed pressure test machine and low - temperature refrigerator, 16 groups, 3 per group, uniaxial tensile experiments are carried out. it educed tensile, compression - strain curves of concrete, tensile strength - caring age curves of concrete and compressive strength - caring age curves of concrete
採用液壓試驗機和使用低溫冷凍室，做了20組60個單軸受壓試驗和20組60個單軸受拉試驗，得出了混凝土的受壓和受拉應力?應變曲線、抗壓強度與養護齡期以及抗拉強度與養護齡期的關系曲線。分享友人