拱支座 的英文怎麼說

中文拼音 [gǒngzhīzuò]
拱支座 英文
arch bearing
  • 拱 : Ⅰ動詞1 （兩手相合 臂的前部上舉） cup one hand in the other before the chest 2 （環繞） encircle; ...
  • 支 : Ⅰ名詞1 （分支; 支派） branch; offshoot 2 （地支） the twelve earthly branches3 （姓氏） a surname...
  1. After an introduction to the research on the software for the design of the variant steel arched girder construction, the creation of the structural model, the structure of the supporting seat, the design of the variant arched girder, and the measures taken to ensure the stability of the plane surface of the arched girder, the thesis goes to study the methods for the hoisting and the angle setting of the long - span arched girders, as well as the bolting of the axle pin in the hinge support

    論文首先對變異鋼拱架結構設計可採用的軟體、結構模型的建立、支座構造形式、變異拱梁的設計，以及保證拱梁平面外穩定所採取的措施等進行了研究，然後研究了大跨度變異鋼拱架弧形梁吊裝、角度的調整、鉸支座穿軸銷等的施工方法，最後對施工完成後的位移進行了實際量測。
  2. In this study, sts - - the steel construction design module of pkpm, a software program of china " s institute of the construction science - - is employed to create the construction model in order to study the construction of the supporting seat. a mechanical analysis of the variant arched girders was implemented, with the result that consturction documents meeting mechanical requirements were designed for the hinge support, the roller support and the steel girders

    本文採用中國建築科學研究院pkpm軟體的鋼結構設計模塊sts ，從結構建模入手，根據規范要求研究了支座的構造形式，通過對變異拱梁的力學分析，設計出符合力學模型的鉸支座、滑移支座和變異拱處鋼梁的施工圖。
  3. All of the researches are carried out on the background of a spatial continuous beam - arch composite bridges, and the relative loading experimental results are compared with the calculated values. it indicates that the theory of elastically supported continuous beam method load lateral distribution is a kind of simple convenience and safe practical engineering calculation method. 2 ) the suspender force and correlated modality is analyzed with the use of general calculation program ansys. during testing suspender force, the influence of the rigidity of suspender must be considered

    在此基礎上，以一座實際的預應力混凝土連續梁拱組合體系橋梁為工程背景，採用一般的試驗研究方法對該橋進行了荷載試驗研究，並將有關的荷載試驗結果與理論計算值作了比較，結果表明：所提出的彈性支承連續梁法計算值，與空間有限元分析理論值及荷載試驗測試值基本吻合。
  4. Meanwhile, arched roof is generally set on beam at the top of pillar. since column adaptor may has displacement ( specially horizontal displacement ), load - carrying capability of the structure will step down, and bending rigidity of the column also has emphatic influence on it

    同時，拱型屋蓋一般是通過邊梁支承在柱子上，由於柱頂產生位移（尤其是水平位移） ，支承在柱子上的拱型屋蓋的承載力較固定支座的拱型屋蓋有所降低。
  5. For example, no - supporting elements should be made of light material which attracts less seismic loads. 2 ) generally speaking, seismic combined maximum loads of aqueduct transverse direction is less than 100kn, which present joints near the arch - foot sections

    2 ）總的來看，各質點橫槽向的地震總名義合外力不大，最大值不到100kn ，且發生在支座附近緊臨拱腳的節點上。
  6. Not only t he self - weigh of every beam, the prestressing, the compression on the support of form scaffolding, constriction of concrete, creeping are considered when the inter nal force is calculated, but also the result of displacement and deviation of th esupport and precamber should be taken into consideration

    施工階段的內力計算不僅考慮逐段施工梁的自重，預加應力，模板支架的支點壓力，以及混凝土的收縮、徐變；同時還應考慮施工程序，施工中的支座位移、支座偏差和預拱度等的影響。
  7. The results are important for dam base excavation and engineering disposal. ( 2 ) arch dam can be regarded as an elastic ground cantilever system composed of vertical cantilever, horizontal arch, and torsion structures. the dissertation takes the arch dam as load diversion system of arch - cantilevers system located on the ground composed of elastic cantilever

    （ 2 ）將拱壩虛擬為由座落在壩基塊體有限元上的一系列懸臂梁與水平拱組成，將懸臂梁視作由水平拱所支承的彈性地基梁，考慮徑向和切向調整，比以往的彈性地基梁只考慮徑向調整有所發展；而且用塊體元模擬壩基，也能較精確地模擬壩基多種斷裂構造等對壩體結構行為的影響。
  8. On the basis of simplified calculation model presented by doctor wangxiaoping, some finite element models are set up. by finite element model program sap93, an analysis of static models of 18m - span and 30m - span w666 acmr in different supporting conditions is made. also a study on the relation between definite support displacement, which reflect variational stiffness of substructure represented by steel column or reinforced concrete column, and load - carrying capacity mechanical performance is made too

    本文以w666金屬拱型波紋屋頂為研究對象，沿用王小平博士的簡化計算模型，對18m 、 30m跨波紋拱兩端不同支座形式（鉸支、固支和彈性支座）分別利用有限元計算程序sap93進行計算分析，研究波紋拱在不同跨度，不同支座形式下，不同外荷載作用時對該結構受力性能及穩定承載力的影響，同時分析下部支承鋼柱、鋼筋混凝土柱的剛度變化體現為允許支座位移的大小與結構受力性能及穩定承載力之間的關系。
  9. As we know, support at the both straight edge of acmr is a elastic support between the hinged support and fixed support, and its stiffness is variational. so the relation between support stiffness and load - carrying capability of acmr is worth to be studied

    眾所周知，實際工程中波紋拱兩端的直邊支座處于鉸支和固支之間，屬一彈性支座，其彈性剛度是變化的，支座剛度與波紋拱結構受力性能及穩定承載力之間的關系是一個非常值得研究的課題。
分享友人
分享到 Line

分享到臉書